Balsalobre-Fernández, C, Kuzdub, M, Poveda-Ortiz, P, and Campo-Vecino, Jd. Validity and reliability of the PUSH wearable device to measure movement velocity during the back squat exercise. J Strength Cond Res 30(7): 1968-1974, 2016-The purpose of this study was to analyze the validity and reliability of a wearable device to measure movement velocity during the back squat exercise. To do this, 10 recreationally active healthy men (age = 23.4 ± 5.2 years; back squat 1 repetition maximum [1RM] = 83 ± 8.2 kg) performed 3 repetitions of the back squat exercise with 5 different loads ranging from 25 to 85% 1RM on a Smith Machine. Movement velocity for each of the total 150 repetitions was simultaneously recorded using the T-Force linear transducer (LT) and the PUSH wearable band. Results showed a high correlation between the LT and the wearable device mean (r = 0.85; standard error of estimate [SEE] = 0.08 m·s) and peak velocity (r = 0.91, SEE = 0.1 m·s). Moreover, there was a very high agreement between these 2 devices for the measurement of mean (intraclass correlation coefficient [ICC] = 0.907) and peak velocity (ICC = 0.944), although a systematic bias between devices was observed (PUSH peak velocity being -0.07 ± 0.1 m·s lower, p ≤ 0.05). When measuring the 3 repetitions with each load, both devices displayed almost equal reliability (Test-retest reliability: LT [r = 0.98], PUSH [r = 0.956]; ICC: LT [ICC = 0.989], PUSH [ICC = 0.981]; coefficient of variation [CV]: LT [CV = 4.2%], PUSH [CV = 5.0%]). Finally, individual load-velocity relationships measured with both the LT (R = 0.96) and the PUSH wearable device (R = 0.94) showed similar, very high coefficients of determination. In conclusion, these results support the use of an affordable wearable device to track velocity during back squat training. Wearable devices, such as the one in this study, could have valuable practical applications for strength and conditioning coaches.

Flight time is the most accurate and frequently used variable when assessing the height of vertical jumps. The purpose of this study was to analyze the validity and reliability of an alternative method (i.e., the HSC-Kinovea method) for measuring the flight time and height of vertical jumping using a low-cost high-speed Casio Exilim FH-25 camera (HSC). To this end, 25 subjects performed a total of 125 vertical jumps on an infrared (IR) platform while simultaneously being recorded with a HSC at 240 fps. Subsequently, 2 observers with no experience in video analysis analyzed the 125 videos independently using the open-license Kinovea 0.8.15 software. The flight times obtained were then converted into vertical jump heights, and the intraclass correlation coefficient (ICC), Bland-Altman plot, and Pearson correlation coefficient were calculated for those variables. The results showed a perfect correlation agreement (ICC = 1, p < 0.0001) between both observers' measurements of flight time and jump height and a highly reliable agreement (ICC = 0.997, p < 0.0001) between the observers' measurements of flight time and jump height using the HSC-Kinovea method and those obtained using the IR system, thus explaining 99.5% (p < 0.0001) of the differences (shared variance) obtained using the IR platform. As a result, besides requiring no previous experience in the use of this technology, the HSC-Kinovea method can be considered to provide similarly valid and reliable measurements of flight time and vertical jump height as more expensive equipment (i.e., IR). As such, coaches from many sports could use the HSC-Kinovea method to measure the flight time and height of their athlete's vertical jumps.

PurposeMonitoring training from a multifactorial point of view is of great importance in elite endurance athletes. This study aims to analyze the relationships between indicators of training load, hormonal status and neuromuscular performance, and to compare these values with competition performance, in elite middle and long-distance runners.MethodFifteen elite middle and long-distance runners (12 men, 3 women; age = 26.3±5.1 yrs) were measured for training volume, training zone and session rate of perceived exertion (RPE) (daily), countermovement jump (CMJ) and salivary free cortisol (weekly) for 39 weeks (i.e., the whole season). Competition performance was also observed throughout the study, registering the season best and worst competitions.ResultsSeason average salivary free cortisol concentrations correlate significantly with CMJ (r = −0.777) and RPE (r = 0.551). Also, weekly averages of CMJ significantly correlates with RPE (r = −0.426), distance run (r = −0.593, p<0.001) and training zone (r = 0.437, p<0.05). Finally, it was found that the CMJ (+8.5%, g = 0.65) and the RPE (−17.6%, g = 0.94) measured the week before the best competition performance of the season were significantly different compared with the measurement conducted the week before the season’s worst competition performance.ConclusionsMonitoring weekly measurements of CMJ and RPE could be recommended to control training process of such athletes in a non-invasive, field-based, systematic way.

The aim of this study was to determine the effects of a power training cycle on maximum strength, maximum power, vertical jump height and acceleration in seven high-level 400-meter hurdlers subjected to a specific training program twice a week for 10 weeks. Each training session consisted of five sets of eight jump-squats with the load at which each athlete produced his maximum power. The repetition maximum in the half squat position (RM), maximum power in the jump-squat (W), a squat jump (SJ), countermovement jump (CSJ), and a 30-meter sprint from a standing position were measured before and after the training program using an accelerometer, an infra-red platform and photo-cells. The results indicated the following statistically significant improvements: a 7.9% increase in RM (Z=−2.03, p=0.021, δc=0.39), a 2.3% improvement in SJ (Z=−1.69, p=0.045, δc=0.29), a 1.43% decrease in the 30-meter sprint (Z=−1.70, p=0.044, δc=0.12), and, where maximum power was produced, a change in the RM percentage from 56 to 62% (Z=−1.75, p=0.039, δc=0.54). As such, it can be concluded that strength training with a maximum power load is an effective means of increasing strength and acceleration in high-level hurdlers.

No abstract

Splitting sets into clusters has been shown to maintain performance during resistance training. This study compared the acute fatigue produced by a traditional (TSC) versus a cluster (CSC) set configuration in the smith machine half squat exercise. Fifteen males performed a single bout of TSC and CSC separated by 72–96 h. In the TSC, participants performed as many repetitions as possible until reaching a 20% drop in barbell velocity (MPV), while in the CSC, they performed the same number of repetitions with 15 seconds inter-repetition rest. Effects of both protocols in MPV, countermovement jump height (CMJ), and blood lactate (BLa) were measured. Significant differences between protocols were found for MPV of the last repetition (0.4 vs 0.5 m/s TSC and CSC) and BLa (6.8 mmol/L vs 3.2 mmol/L TSC and CSC). Significant drop of velocity from the first to the last repetition of the set (19.9%), decrease in CMJ height (35.4 vs 32.6 cm), and increase in BLa (2.1 vs 6.8 mmol/L) pre–post-exercise was observed just for the TSC protocol. The results of the present study showed that CSC reduces the lactate response and mechanical fatigue produced by a single set on the half squat exercise in comparison with TSC.

No abstract

Observed differences in CMJ height correlate significantly with salivary free cortisol levels and RPE of middle- and long-distance runners. These results show the suitability of the CMJ for monitoring multifactorial competition responses in high-level middle- and long-distance runners.