No abstract

Two-stage revision treatment of prosthetic joint infection (PJI) frequently employs the use of a temporary bone cement spacer loaded with multiple antibiotic types. Tobramycin and vancomycin are commonly used antibiotics in cement spacers, however, there is no consensus on the relative concentrations and combinations that should be used. Therefore, the purpose of this study was to investigate the influence of dual antibiotic loading on the total antibiotic elution and compressive mechanical properties of acrylic bone cement. Varying concentrations of tobramycin (0-3 g) and vancomycin (0-3 g) were added either alone or in combination to acrylic cement (Palacos R), resulting in 12 experimental groups. Samples were submerged in 37°C saline for 28 d and sampled at specific time points. The collected eluent was analyzed to determine the cumulative antibiotic release. In addition, the cement's compressive mechanical properties and porosity were characterized. Interestingly, the cement with the highest concentration of antibiotics did not possess the best elution properties. Cement samples containing both 3 g of tobramycin and 2 g vancomycin demonstrated the highest cumulative antibiotic release after 28 d, which was coupled with a significant decrease in the mechanical properties and an increased porosity. The collected data also suggests that tobramycin elutes more effectively than vancomycin from cement. In conclusion, this study demonstrates that high antibiotic loading in cement does not necessarily lead to enhanced antibiotic elution. Clinically this information may be used to optimize cement spacer antibiotic loading so that both duration and amount of antibiotics eluted are optimized. © 2017 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 36:1078-1085, 2018.

No abstract

No abstract

No abstract

No abstract

The results underline the importance of optimal balancing. Over-stuffing should be avoided as it results in the largest kinematic changes relative to the native condition and induces higher strains in the sMCL. Based on the kinematic findings, it is advisable to use thinner inlays, as long as this is not compromising stability or risking inlay luxation.

Our study data demonstrate that the kinematics of the unloaded knee following MB UKA closely resemble those of the native knee while relative medial overstuffing with UKA will result in the joint being more valgus. However, replacing the conforming and rigidly fixed medial meniscus with a mobile inlay may successfully prevent aberrant posterior translation of the medial femoral compartment during passive motion and squatting motion.