No abstract

No abstract

No abstract

Techniques of liver replacement would benefit patients awaiting donor livers and may be a substitute for transplantation in patients whose livers can regenerate. Poly(lactic-co-glycolic acid) (PLGA) copolymers are biodegradable and have been shown to be useful as scaffolds for seeding and culturing various types of cells. In this study, foam disks were prepared from PLGA (lactic-to-glycolic mole ratio of 85:15) by lyophilization of benzene (5% w/v) solutions. These disks were then used as scaffolds for rat hepatocyte culture. Foams were coated with either a type I collagen gel (0.1% w/v), coated with gelatin (5% w/v), or treated with oxygen plasma (25 W, 90 s) to modify their surface chemistry and wettability. The disks were then seeded with rat hepatocytes (10(6)/mL) and cultured for a period of 2 weeks. All surface treatments resulted in increased hydrophilicity, the greatest being obtained by collagen treatment (contact angle < 10 degrees ), and a minimal decrease in void fraction (5%). DNA content after a 2-week culture period increased proportionally with the wettability of the treated foam surface. Urea synthesis in untreated foams averaged 15.3 +/- 2.3 microg/h/microg DNA, which was significantly higher than that for controls, whereas gelatin and collagen treated foams exhibited urea synthetic rates below the control levels at all times. The DNA content decreased significantly by about 50% between days 1 and 12. PLGA foams, treated and untreated, represent a promising scaffold for scaling up hepatocyte cultures.

The purpose of this study was to compare the effect of polymer foam morphology and density prior to compaction on the kinetics of isoniazid (INH) release from the final highdensity extruded matrices. The feasibility of preparing low density foams of several biopolymers, including poly(Llactide) (PLLA), poly(glycolide) (PGA), poly(DL-lactide-coglycolide) (PLGA), poly(␥-benzyl-L-glutamate) (PBLG), and poly(propylene fumarate) (PPF), via a lyophilization technique was investigated. Low-density foams of PLGA, PBLG, and a mixture of PLGA and PPF were successfully fabricated by lyophilization of the frozen polymer solutions either in glacial acetic acid or in benzene. The morphology of these foams depends on the polymer as well as the solvent used in the fabrication process. Thus, PLGA produces a capillary structure when lyophilized from benzene solution and a leaflet structure from glacial acetic acid, but PBLG yields a leaflet structure from benzene. Matrices were prepared by impregnating these foams with aqueous solutions of INH, removing the water by a second lyophilization, and then compressing the low-density INH containing foams by compaction and high-pressure extrusion. The resulting nonporous matrices had densities of approximately 1.30 g/cm 3 . In vitro kinetics were in accord with the Roseman-Higuchi diffusion model and demonstrate that release rates depend on the initial foam density, while foam structure has little influence on the release kinetics.