The slow-down in traditional silicon complementary metal-oxide-semiconductor (CMOS) scaling (Moore's law) has created an opportunity for a disruptive innovation to bring the semiconductor industry into a postsilicon era. Due to their ultrathin body and ballistic transport, carbon nanotubes (CNTs) have the intrinsic transport and scaling properties to usher in this new era. The remaining challenges are largely materials-related and include obtaining purity levels suitable for logic technology, placement of CNTs at very tight (∼5 nm) pitch to allow for density scaling and source/drain contact scaling. This review examines the potential performance advantages of a CNT-based computing technology, outlines the remaining challenges, and describes the recent progress on these fronts. Although overcoming these issues will be challenging and will require a large, sustained effort from both industry and academia, the recent progress in the field is a cause for optimism that these materials can have an impact on future technologies.

The motivation of this study is to determine if small amounts of designer additives placed at the polymer-fullerene interface in bulk heterojunction (BHJ) solar cells can influence their performance. A series of AB-alternating side-chain-functionalized poly(thiophene) analogues, P1-6, are designed to selectively localize at the interface between regioregular poly(3-hexylthiophene) (rr-P3HT) and PC(n)BM (n = 61, 71). The side chains of every other repeat unit in P1-6 contain various terminal aromatic moieties. BHJ solar cells containing ternary mixtures of rr-P3HT, PC(n)BM, and varying weight ratios of additives P1-6 are fabricated and studied. At low loadings, the presence of P1-6 consistently increases the short circuit current and decreases the series resistance of the corresponding devices, leading to an increase in power conversion efficiency (PCE) compared to reference P3HT/PC(61)BM cells. Higher additive loadings (>5 wt %) lead to detrimental nanoscale phase separation within the active layer blend and produce solar cells with high series resistances and low overall PCEs. Small-perturbation transient open circuit voltage decay measurements reveal that, at 0.25 wt % incorporation, additives P1-6 increase charge carrier lifetimes in P3HT/PC(61)BM solar cells. Pentafluorophenoxy-containing polymer P6 is the most effective side-chain-functionalized additive and yields a 28% increase in PCE when incorporated into a 75 nm thick rr-P3HT/PC(61)BM BHJ at a 0.25 wt % loading. Moreover, devices with 220 nm thick BHJs containing 0.25 wt % P6 display PCE values of up to 5.3% (30% PCE increase over a control device lacking P6). We propose that additives P1-6 selectively localize at the interface between rr-P3HT and PC(n)BM phases and that aromatic moieties at side-chain termini introduce a dipole at the polymer-fullerene interface, which decreases the rate of bimolecular recombination and, therefore, improves charge collection across the active layer.

A thin‐film transistor: An n‐type polymer semiconductor, poly(2,3‐bis(perfluorohexyl)thieno[3,4‐b]pyrazine), was synthesized through a Pd‐catalyzed polycondensation employing a perfluorinated multiphase solvent system. This is the first example of an n‐type polymer semiconductor with exclusive solubility in fluorinated solvents. The fabrication of organic field effect transistors containing this new n‐type polymer semiconductor is shown (see picture).

No abstract

An elastomeric polymer composite that can be disassembled at will into its individual components when exposed to mild bases is presented. The composite is formed of a poly(olefin sulfone) and a silicone bound together using "click" chemistry. The mechanical properties of the composites can be varied depending on their formulation. Its base-triggered decomposition is advantageous from the point of view of composite recycling and controlled release of chemicals.