El chile Manzano o Cera (Capsicum pubescens), es una planta perenne originaria de las tierras altas de América del Sur. Durante su almacenamiento, el principal problema que presenta es su testa, lo cual ocasiona una disminución de la germinación en condiciones naturales. Debido a que existe poca información sobre la germinación, es necesario implementar alternativas que garanticen el recurso dentro de un programa de mejoramiento genético. El objetivo fue evaluar el efecto de ácido sulfúrico (H2SO4), peróxido de hidrógeno (H2O2) y ácido giberélico-3 (C19H22O6) sobre el porcentaje de emergencia y características de plántulas de semillas de C. pubescens. El experimento se realizó en la Unidad de Manejo y Conservación de Recursos Genéticos de la Facultad de Ciencias Biológicas y Agropecuarias de la Universidad Veracruzana. Se utilizaron semillas de C. pubescens provenientes de la localidad de Huatusco, Veracruz, México, almacenadas a temperatura ambiente durante un año. Los tratamientos estudiados fueron: inmersión en H2SO4 (100, 75, 60 %; 30 min); inmersión en H2O2 (20, 10, 15 %; 15 min), inmersión en C19H22O6 (25, 20, 15 mg; 24 h) y el tratamiento testigo. Los resultados en el presente estudio revelan diferencias estadísticas significativas (P ≤ 0,01) para todas las variables evaluadas. El mejor porcentaje de germinación se provocó con inmersión en C19H22O6 (15 mg; 24 h) y H2O2 (20 %; 15 min). El tratamiento con H2SO4 fue perjudicial ya que no hubo emergencia.
Para cultivar una especie silvestre es necesario modificar el esquema genético resultante de los procesos de selección natural a uno adaptado a las condiciones manejadas por el hombre, e implica detectar áreas geográficas similares a aquellas donde se originó la especie. En este estudio se analiza un modelo de áreas geográficas potenciales para la adaptación de Capsicum pubescens Ruiz & Pav. con el objetivo de detectar las condiciones de nicho ecológico apropiado, determinar zonas potenciales en México y describir las relaciones entre el medio ambiente y las características morfológicas del fruto. Se utilizó el algoritmo reciente de máxima entropía (MaxEnt) para modelar el nicho de C. pubescens dentro de una región de importancia en el centro de Veracruz, México. Se utilizó un total de 44 sitios de presencia y cuatro variables bioclimáticas para detectar nichos adecuados para la especie; así mismo, se realizó un análisis de regresión por mínimos cuadrados parciales (PLS) combinando los sitios de presencia, variables bioclimáticas y características morfológicas del fruto. Se construyó un mapa final de idoneidad identificando las áreas adecuadas para el crecimiento de C. pubescens. Las contribuciones de las variables predictoras al modelo fueron preipitación anual (Bio12) 43.9 %, capa de potasio (K) 23 %, altitud (DEM) 22.3 % y temperatura media anual (Bio1) 10.7 %, con valor del área bajo la curva de 99.7 %. Los mínimos cuadrados parciales corroboraron la importancia de las covariables, que intervienen en la expresión de características morfológicas del fruto, ayudando a entender mejor las relaciones entre especies y el medio ambiente. Áreas aún no exploradas arrojaron probabilidades de ocurrencia mayores a 90 %, principalmente en las zonas montañosas de Chihuahua, Tamaulipas, Nuevo León y la Sierra de Santa Martha al sur del estado de Veracruz. Se identificó un grupo de accesiones sobresalientes que podrían servir como base para iniciar un programa de mejoramiento genético en esta especie.
<abstract> <p>Due to the growing interest in developing bioplastic films from renewable sources, the performance of biocomposite films produced of native starch from cassava clones reinforced with cassava bagasse was explored. The biocomposites were prepared from the starch of cassava clones MMEXV5, MMEXV40, and MMEXCH23, reinforced with bagasse at 1%, 5%, and 15%. Their structural, mechanical, and thermal properties were subsequently assessed. When analyzing the starch, differences in the intensities of the Raman spectra exhibit a possible variation in the amylose-amylopectin ratio. In the biocomposites, the bagasse was efficiently incorporated into polymeric matrixes and their thermogravimetric analysis revealed the compatibility of the matrix-reinforcement. The starch films from the MMEXV40 clone showed better tension (2.53 MPa) and elastic modulus (60.49 MPa). The assessed mechanical properties were also affected by bagasse concentration. Because of the above, the MMEXV40 cassava clone showed potential to develop polymeric materials, given its tuberous roots high yield, starch extraction, and good performance in its mechanical properties. At the same time, the starch source (clone) and the bagasse concentration interfere with the final properties of the biocomposites.</p> </abstract>
The objective of the work was to evaluate the agronomic performance and seed yield of tropical corn (Zea mays L.) of single and tri-linear crosses. In the spring-summer of 2015 and 2016, two essays were established in the states of Veracruz and Tabasco, Mexico. In the first essay, a group of 12 single crosses was evaluated, and in the second, a group of 18 tri-linear crosses was evaluated. In both essays, the treatments were distributed under a completely randomized block design with three replicates in 5 m long, two-row plots and 0.8 m between rows, with an initial population density of 62.500 plants ha-1. Within the simple cross trial, hybrids HE-3W, COMERCIAL 1, LT-164xLT-165, and HE-1W presented seed yields above the general mean (3384 kg ha-1). Within this outstanding group is the LT-164xLT-165 cross, which participates as a female parent in the formation of the recently released commercial hybrid H-567. In the tri-linear crosses essay, a group of varieties and hybrids including H-567, (LT-164xLT-165) xLT-156, (LT-164xLT-165) xLT-155, (LT-154xLT-155) xLT-165, VS-536, H-520, VS-563, (LT-154xLT-155) xLT-170, (LT-171xLT-172) xLT-156, (LT-164xLT-165) xLT-164, and (LT-171xLT-172) xLT-170 recorded seed yields of 6669.8, 6515.4, 6498.6, 6431.1, 6260, 6024.7, 5935.4, 5664.3, 5580.8, and 5527.1 kg ha-1, respectively. The LT-154, LT-155, and LT-156 lines are common as a male and female parent, suggesting a good genetic combination. The prevailing environmental conditions during the development of the experiments did not significantly influence the productivity of the crosses. There is genetic variability that can be used to continue developing lines, open pollination varieties, and corn hybrids.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.