Aerial surfaces of plants are covered by a waxy cuticle protecting plants from excessive water loss and UV light. In the present study, composition and morphology of cuticular waxes of northern wild berry species bilberry (Vaccinium myrtillus L.), lingonberry (V. vitis-idaea L.), bog bilberry (V. uliginosum L.) and crowberry (Empetrum nigrum L.) were investigated. Scanning electron microscopy (SEM) revealed differences in epicuticular wax morphologies and gas chromatographymass spectrometry (GC-MS) analysis confirmed variation in chemical composition of cuticular waxes between the berry species. The dominant compounds in bilberry and lingonberry cuticular waxes were triterpenoids while fatty acids and alkanes were the dominant ones in bog bilberry and crowberry, respectively. Wax extracted by supercritical fluid extraction (SFE) from industrial press cakes of bilberry and lingonberry contained linoleic acid and γ-linolenic acid as the dominant compounds. Furthermore, in vitro sun protection factor (SPF) of berry waxes depicted good UV-B absorbing capacities.
Historically Triticum aestívum L. and Secale cereále L. are widely used in the production of bakery products. From the total volume of grain cultivated, roughly 85% is used for the manufacturing of flour, while the remaining part is discarded or utilized rather inefficiently. The limited value attached to bran is associated with their structural complexity, i.e., the presence of cellulose, hemicellulose, and lignin, which makes this material suitable mostly as a feed supplement, while in food production its use presents a challenge. To valorize these materials to food and pharmaceutical applications, additional pre-treatment is required. In the present study, an effective, sustainable, and eco-friendly approach to ferulic acid (FA) production was demonstrated through the biorefining process accomplished by non-starch polysaccharides degrading enzymes. Up to 11.3 and 8.6 g kg−1 of FA was released from rye and wheat bran upon 24 h enzymatic hydrolysis with multi-enzyme complex Viscozyme® L, respectively.
The amplified production of fruit as well as burgeoning demand for plant-made food products have resulted in a sharp increase of waste. Currently, millions of tons of by-products are either being discarded or utilized rather ineffectively. However, these by-products may be processed and further incorporated as functional ingredients in making high-value food products with many physiological and biochemical effects. The chemical analysis of pomace oils using gas chromatography-mass spectrometry (GC/MS) and reversed-phase-liquid chromatography coupled with fluorescence detector (RP-HPLC/FLD) systems led to the identification and quantification of 56 individual lipophilic compounds including unsaturated, polyunsaturated and saturated fatty acids, as well as phytosterols and four homologs of tocopherol. The oils recovered from by-products of Malus spp. (particularly cv. “Ola”) are rich in fatty acids such as linolenic (57.8%), α-linolenic (54.3%), and oleic (25.5%). The concentration of total tocopherols varied among the Malus species and dessert apples investigated, representing the range of 16.8–30.9 mg mL−1. The highest content of total tocopherols was found in M. Bernu prieks, followed by M. cv. “Ola”, and M. × Soulardii pomace oils. A significantly higher amount of δ-tocopherol was established in the oil of M. Bernu prieks, indicating that this species could be utilized as a natural and cheap source of bioactive molecules. β-Sitosterol was the prevalent compound determined in all tested pomace oils with a percentage distribution of 10.3–94.5%. The main triterpene identified in the oils was lupeol, which varied in the range of 0.1–66.3%. A targeted utilization of apple pomace would facilitate management of tons of by-products and benefit the environment and industry.
Biorefining by enzymatic hydrolysis (EH) of lignocellulosic waste material due to low costs and affordability has received enormous interest amongst scientists as a potential strategy suitable for the production of bioactive ingredients and chemicals. In this study, a sustainable and eco-friendly approach to extracting bound ferulic acid (FA) was demonstrated using single-step EH by a mixture of lignocellulose-degrading enzymes. For comparative purposes of the efficiency of EH, an online extraction and analysis technique using supercritical fluid extraction–supercritical fluid chromatography–mass spectrometry (SFE-SFC-MS) was performed. The experimental results demonstrated up to 369.3 mg 100 g−1 FA release from rye bran after 48 h EH with Viscozyme L. The EH of wheat and oat bran with Viscoferm for 48 h resulted in 255.1 and 33.5 mg 100 g−1 of FA, respectively. The release of FA from bran matrix using supercritical fluid extraction with carbon dioxide and ethanol as a co-solvent (SFE-CO2-EtOH) delivered up to 464.3 mg 100 g−1 of FA, though the extractability varied depending on the parameters used. The 10-fold and 30-fold scale-up experiments confirmed the applicability of EH as a bioprocessing method valid for the industrial scale. The highest yield of FA in both scale-up experiments was obtained from rye bran after 48 h of EH with Viscozyme L. In purified extracts, the absence of xylose, arabinose, and glucose as the final degradation products of lignocellulose was proven by high-performance liquid chromatography with refractive index detection (HPLC-RID). Up to 94.0% purity of FA was achieved by solid-phase extraction (SPE) using the polymeric reversed-phase Strata X column and 50% EtOH as the eluent.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.