The nanostructure and photoluminescence of polycrystalline Er-doped Y2O3 thin films, deposited by radical-enhanced atomic layer deposition (ALD), were investigated in this study. The controlled distribution of erbium separated by layers of Y2O3, with erbium concentrations varied from 6to14at.%, was confirmed by elemental electron energy loss spectroscopy (EELS) mapping of Er M4 and M5. This unique feature is characteristic of the alternating radical-enhanced ALD of Y2O3 and Er2O3. The results are also consistent with the extended x-ray absorption fine structure (EXAFS) modeling of the Er distribution in the Y2O3 thin films, where the EXAFS data were best fitted to a layer-like structure. X-ray diffraction (XRD) and selected-area electron diffraction (SAED) patterns revealed a preferential film growth in the [111] direction, showing a lattice contraction with increasing Er doping concentration, likely due to Er3+ of a smaller ionic radius replacing the slightly larger Y3+. Room-temperature photoluminescence characteristic of the Er3+ intra-4f transition at 1.54μm was observed for the 500Å, 8at.% Er-doped Y2O3 thin film, showing various well-resolved Stark features due to different spectroscopic transitions from the I13∕24→I15∕24 energy manifold. The result indicates the proper substitution of Y3+ by Er3+ in the Y2O3 lattice, consistent with the EXAFS and XRD analyses. Thus, by using radical-enhanced ALD, a high concentration of optically active Er3+ ions can be incorporated in Y2O3 with controlled distribution at a low temperature, 350°C, making it possible to observe room-temperature photoluminescence for fairly thin films (∼500–900Å) without a high temperature annealing.
Atomic layer deposition of titanium dioxide using tetrakis(dimethylamido)titanium (TDMAT) and water vapor is studied by reflection-absorption infrared spectroscopy (RAIRS) with a time resolution of 120 ms. At 190 °C and 240 °C, a decrease in the absorption from adsorbed TDMAT is observed without any evidence of an adsorbed product. Ex situ measurements indicate that this behavior is not associated with an increase in the impurity concentration or a dramatic change in the growth rate. A desorbing decomposition product is consistent with these observations. RAIRS also indicates that dehydroxylation of the growth surface occurs only among one type of surface hydroxyl groups. Molecular water is observed to remain on the surface and participates in reactions even at a relatively high temperature (110 °C) and with long purge times (30 s).
Background: Animal models are used to guide management of periprosthetic implant infections. No adequate model exists for periprosthetic shoulder infections, and clinicians thus have no preclinical tools to assess potential therapeutics. We hypothesize that it is possible to establish a mouse model of shoulder implant infection (SII) that allows noninvasive, longitudinal tracking of biofilm and host response through in vivo optical imaging. The model may then be employed to validate a targeting probe (1D9-680) with clinical translation potential for diagnosing infection and image-guided débridement. Methods: A surgical implant was press-fit into the proximal humerus of c57BL/6J mice and inoculated with 2 μL of 1 × 10 3 (e3), or 1 × 10 4 (e4), colony-forming units (CFUs) of bioluminescent Staphylococcus aureus Xen-36. The control group received 2 μL sterile saline. Bacterial activity was monitored in vivo over 42 days, directly (bioluminescence) and indirectly (targeting probe). Weekly radiographs assessed implant loosening. CFU harvests, confocal microscopy, and histology were performed. Results: Both inoculated groups established chronic infections. CFUs on postoperative day (POD) 42 were increased in the infected groups compared with the sterile group (P < .001). By POD 14, osteolysis was visualized in both infected groups. The e4 group developed catastrophic bone destruction by POD 42. The e3 group maintained a congruent shoulder joint. Targeting probes helped to visualize low-grade infections via fluorescence. Discussion: Given bone destruction in the e4 group, a longitudinal, noninvasive mouse model of SII and chronic osteolysis was produced using e3 of S aureus Xen-36, mimicking clinical presentations of chronic SII. Conclusion: The development of this model provides a foundation to study new therapeutics, interventions, and host modifications.
Feature profile evolution during shallow trench isolation etch in chlorine-based plasmas. II. Coupling reactor and feature scale models Modeling of fluorine-based high-density plasma etching of anisotropic silicon trenches with oxygen sidewall passivation J. Appl. Phys. 94, 6311 (2003); 10.1063/1.1621713Deep-submicron trench profile control using a magnetron enhanced reactive ion etching system for shallow trench isolationThe authors developed a cellular based Monte Carlo ͑MC͒ feature scale model capable of direct coupling to the dominant plasma species ratios from a reactor scale model in order to simulate the profile evolution of shallow trench isolation etch in chlorine-based plasmas and its variation from the center to the edge of the wafer. Carefully planned experiments along with scanning electron microscopy ͑SEM͒ were used to calibrate the MC model, where one to two plasma parameters were systematically varied. Simulated feature profiles were found to agree well with experimental observations, capturing details such as microtrenching, faceting, tapering, and bowing. The particle counts used to achieve these fits agreed well with those estimated from SEM, corroborating the chemistry and physics used in the feature scale model. In addition, the feature scale model uses a novel surface representation that eliminates the artificial flux fluctuations originating from the discrete cells used in the simulation and enables a much more precise calculation of the surface normal, which dictates the trajectory of reflected species.
Semiconductor nanowires are among the most promising candidates for next generation photovoltaics. This is due to their outstanding optical and electrical properties which provide large optical cross sections while simultaneously decoupling the photon absorption and charge carrier extraction length scales. These effects relax the requirements for both the minority carrier diffusion length and the amount of semiconductor needed. Metal-semiconductor core-shell nanowires have previously been predicted to show even better optical absorption than solid semiconductor nanowires and offer the additional advantage of a local metal core contact. Here, we fabricate and analyze such a geometry using a single Au-Cu2O core-shell nanowire photovoltaic cell as a model system. Spatially resolved photocurrent maps reveal that although the minority carrier diffusion length in the Cu2O shell is less than 1 μm, the radial contact geometry with the incorporated metal electrode still allows for photogenerated carrier collection along an entire nanowire. Current-voltage measurements yield an open-circuit voltage of 600 mV under laser illumination and a dark diode turn-on voltage of 1 V. This study suggests the metal-semiconductor core-shell nanowire concept could be extended to low-cost, large-scale photovoltaic devices, utilizing for example, metal nanowire electrode grids coated with epitaxially grown semiconductor shells.
Document VersionPublisher's PDF, also known as Version of Record (includes final page, issue and volume numbers)Please check the document version of this publication:• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website.• The final author version and the galley proof are versions of the publication after peer review.• The final published version features the final layout of the paper including the volume, issue and page numbers. Link to publication General rightsCopyright and moral rights for the publications made accessible in the public portal are retained by the authors and/or other copyright owners and it is a condition of accessing publications that users recognise and abide by the legal requirements associated with these rights.• Users may download and print one copy of any publication from the public portal for the purpose of private study or research.• You may not further distribute the material or use it for any profit-making activity or commercial gain • You may freely distribute the URL identifying the publication in the public portal ? Take down policyIf you believe that this document breaches copyright please contact us providing details, and we will remove access to the work immediately and investigate your claim. We report in this work the optical properties of Er 3+ -doped Y 2 O 3 , deposited by radical enhanced atomic layer deposition. Specifically, the 1.53 m absorption cross section of Er 3+ in Y 2 O 3 was measured by cavity ring-down spectroscopy to be ͑1.9± 0.5͒ ϫ 10 −20 cm 2 , about two times that for Er 3+ in SiO 2 . This is consistent with the larger Er 3+ effective absorption cross section at 488 nm, determined based on the 1.53 m photoluminescence yield as a function of the pump power. X-ray photoelectron spectroscopy and Rutherford backscattering spectroscopy were used to determine the film composition, which in turn was used to analyze the extended x-ray absorption fine structure data, showing that Er was locally coordinated to only O in the first shell and its second shell was a mixture of Y and Er. These results demonstrated that the optical properties of Er 3+ -doped Y 2 O 3 are enhanced, likely due to the fully oxygen coordinated, spatially controlled, and uniformly distributed Er 3+ dopants in the host. These findings are likely universal in rare-earth doped oxide materials, making it possible to design materials with improved optical properties for their use in optoelectronic devices.
This work presents a novel method for obtaining surface infrared spectra with sub-second time resolution during atomic layer deposition (ALD). Using a rapid-scan Fourier transform infrared (FT-IR) spectrometer, we obtain a series of synchronized interferograms (120 ms) during multiple ALD cycles to observe the dynamics of an average ALD cycle. We use a buried metal layer (BML) substrate to enhance absorption by the surface species. The surface selection rules of the BML allow us to determine the contribution from the substrate surface as opposed to that from gas-phase molecules and species adsorbed at the windows. In addition, we use simulation to examine the origins of increased reflectivity associated with phonon absorption by the oxide layers. The simulations are also used to determine the decay in enhancement by the buried metal layer substrate as the oxide layer grows during the experiment. These calculations are used to estimate the optimal number of ALD cycles for our experimental method.
BACKGROUND-Intrawound vancomycin powder (VP) has been rapidly adopted in spine surgery with apparent benefit demonstrated in limited, retrospective studies. Randomized trials, basic science, and dose response studies are scarce. PURPOSE-This study aims to test the efficacy and dose effect of VP over an extended time course within a randomized, controlled in vivo animal experiment. STUDY DESIGN/SETTING-Randomized controlled experiment utilizing a mouse model of spine implant infection with treatment groups receiving vancomycin powder following bacterial inoculation. METHODS-Utilizing a mouse model of spine implant infection with bioluminescent Staphylococcus aureus, 24 mice were randomized into 3 groups: 10 infected mice with VP treatment (+VP), 10 infected mice without VP treatment (No-VP), and 4 sterile controls (SC). Four milligrams of VP (mouse equivalent of 1 g in a human) were administered before wound closure. Bioluminescence imaging was performed over 5 weeks to quantify bacterial burden. Electron microscopy (EM), bacterial colonization assays (Live/Dead) staining, and colony forming units (CFU) analyses were completed. A second dosing experiment was completed with 34 mice randomized into 4 groups: control, 2 mg, 4 mg, and 8 mg groups. RESULTS-The (+VP) treatment group exhibited significantly lower bacterial loads compared to the control (No-VP) group, (p<.001). CFU analysis at the conclusion of the experiment revealed 20% of mice in the +VP group and 67% of mice in the No-VP group had persistent infections, and the (+VP) treatment group had significantly less mean number of CFUs (p<.03). EM and Live/ Dead staining revealed florid biofilm formation in the No-VP group. Bioluminescence was suppressed in all VP doses tested compared with sterile controls (p<.001). CFU analysis revealed a
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.