Molecularly imprinted microspheres (MIMs, >3 microm) and nanospheres (MINs, approximately 450 nm) for the environmental endocrine disruptor di(2-ethylhexyl)phthalate (DEHP) were prepared by a precipitation polymerization (PP) procedure. The effect of the dispersive solvents acetonitrile (ACN) and cyclohexane (CH), the cross-linkers ethylene glycol dimethacrylate (EDMA) and trimethylpropane trimethacrylate (TRIM), and the template on particle size and morphology of polymers was investigated in detail by scanning electron microscopy (SEM) and BET adsorption isotherm determination. When used as HPLC stationary phase, the microspheres exhibited strong affinity for the template DEHP with an imprint factor (IF) higher than 8.0 in ACN/water (60:40, v/v) as mobile phase. Furthermore, baseline separation of DEHP from benzyl butyl phthalate (BBP) and dibutyl phthalate (DBP) could be achieved. In contrast, no or only poor separation could be observed with non-imprinted polymeric polymers (NIPs) or imprinted bulk polymers (MIB), respectively. Similarly, the obtained MINs exhibited an imprinting effect in pure ACN, i.e. the bond amount of DEHP was significantly higher compared to NIPs, as was shown in rebinding experiments. Besides their use as an HPLC stationary phase, MIMs might further be applicable for SPE sample cleanup, while MINs could be used as a recognition layer on sensor surfaces.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.