Laser damage mitigation' is a process developed to prevent the growth of nanosecond laser-initiated damage sites under successive irradiation. It consists of re-fusing the damage area with a CO2 laser. In this paper we investigate the stress field created around mitigated sites which could have an influence on the efficiency of the process. A numerical model of CO2 laser interaction with fused silica is developed. It takes into account laser energy absorption, heat transfer, thermally induced stress and birefringence. Residual stress near mitigated sites in fused silica samples is characterized with specific photoelastic methods and theoretical data are compared to experiments. The stress distribution and quantitative values of stress levels are obtained for sites treated with the CO2 laser in various conditions of energy deposition (beam size, pulse duration, incident power). The results provided evidence that the presence of birefringence/residual stress around the mitigated sites has an effect on their laser damage resistance.

No abstract

International audienceIn order to resolve problems concerning the understanding and the control of laser-induced damage of silica optical elements, a collaboration between the CEA and different university laboratories has been undertaken. Ultra-pure silica model samples, seeded with gold nanoparticles whose diameter did not exceed 5 nm, were prepared. The aim in using these samples was to observe the mechanism of damage initiation that could be attributed to inclusions of nanometric size. This paper presents the different steps encountered during this study: preparation of the samples, the laser-induced damage tests, the Nomarski and atomic-force microscope observations of this damage and a series of experiments using a time-of-flight mass spectrometer at Argonne National Laboratory. The experimental data are then interpreted, and, in particular, compared to numerical simulations. A very encouraging result is the existence of a pre-damage phase at very low fluences that is not detectable by classical optical devices. The experimental means developed for such model samples should be transposable to the analysis of industrial glasses

A self-consistent approach is proposed to determine the temperature dependent thermal conductivity k(T) of fused silica, for a range of temperatures up to material evaporation using a CO2 laser irradiation. Calculation of the temperature of silica using a two-dimensional axi-symmetric code was linked step by step as the laser power was increased with experimental measurements using infrared thermography. We show that previously reported k(T) does not reproduce the temporal profile as well as our adaptive fit which shows that k(T) evolves with slope discontinuities at the annealing temperature and the softening temperature.