Electronic devices in contact or in close proximity to the human body can use its conductive properties to establish body coupled communication (BCC) between each other. This human centric communication paradigm can be used for wireless body-area networks to reduce the impact of interference on/from RF systems, to avoid the fading effect that the body has on radio systems and to enable power efficient, high data-rate wireless links.BCC, without skin contact, can be realized via two electrode RX/TX devices capacitively coupled to the human body (Fig. 11.5.1); TX generates a variable electric field while RX senses the variable potential of the body with respect to the environment. The signal transfer along the body has high-pass characteristics with a corner frequency determined by the input impedance of the RX device. A signal attenuation of less than 70dB has been measured between devices placed at various positions on the human body (Fig. 11.5.1,[1,2]). Concerning interference, the body-channel is especially affected by interference below 1MHz while for higher frequencies the observed interference level is below -75dBm (Fig. 11.5.1). However, in the FM band the body starts acting as an antenna and this level may rise to -30dBm [4]. The BCC implementation in [3] used wideband digital TX signals and was very low-power but a cognitive FSK approach [4] was preferred to it due to the afore-mentioned high levels of FM interference above 50MHz.Here, as in [3], we couple a wideband digital signal to the human body but instead of a 50Ω input resistance for the RX we use high resistance so that the RX can effectively sense the 1 to 30MHz band, thus avoiding the FM band. Moreover, for further interference suppression, we designed a novel correlation-based RX that attenuates any signal that is poorly correlated to the expected one.The transceiver architecture is shown in Fig. 11.5.2. Figure 11.5.3 shows functional and measured waveforms. The TX performs Manchester encoding on the digital data-stream so that at least one voltage transition occurs per bit. The RX input stage is a clamped low-noise amplifier (LNA). For each bit-period the electrodes are shorted for a short time (20% duty cycle) and the DC level of the amplifier is restored. For the rest of the period the input resistance is very high and the input signal is amplified. This approach suppresses low frequency interference while the fast voltage transitions from the TX are amplified when they occur during the RX period. The bandwidth of the LNA is limited to 30MHz so that high frequency interference is attenuated. The interference is further suppressed by correlating the output of the LNA with a one-bit data template with transitions in the middle of the RX period (Fig. 11.5.3). For this purpose, the received signal is multiplied by -1 in the first half of the period and by +1 in the second half and the result integrated. The computed data correlation is maximal for digital-like transitions occurring in the middle of the RX period, while any other signal is str...
Audio one-bit Σ∆ DA converters can have high resolution and low distortion. Switched-capacitor (SC) and continuous-time (CT) DAC's are comparable in performance, but the fault mechanisms and application issues are quite different. The Real-Time DEM algorithm presented here can only be used with CT DAC's. Those are limited in performance by clock jitter and inter symbol interference (ISI). Noise from clock jitter is proportional to the stepsize in the output signal and to the number of transitions. The stepsize and the oversampling rate will decrease if a CT multibit DAC is used, thus reducing the stepsize and the number of transitions. This reduces clock-jitter induced noise.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.