Since biologically active peptides usually exhibit their effects in low concentrations, the development of sensitive analytical methods has become a challenge. In this paper, a multidimensional system is presented, consisting of a size-exclusion chromatographic (SEC) separation followed by a trapping procedure on a 4 mm x 3 mm ID reversed-phase C18 (RP18) column with subsequent elution of the trapped fraction and separation by capillary zone electrophoresis (CZE). The system has been tested with mixtures of six enkephalins and albumin, mimicking biological matrices such as plasma and cerebrospinal fluid. After separation of albumin from the enkephalins in the SEC dimension a heart-cut of 200 micro L, containing the enkephalin peak, is taken, concentrated on the RP18 microcolumn and, after elution with a 20 micro L plug of 80% acetonitrile, electrokinetically injected into the CZE system, where stacking and separation is achieved. While validation shows generally good linearity and reproducibility, the quantitation limit with UV detection is acceptable (2.5 micro g/ mL with an injection volume of 50 micro L).

On-line coupled analytical techniques can be advantageous in the assay of smaller peptides in complex biological matrices such as plasma, cerebrospinal fluid (CSF) and tissues. The present study shows the feasibility of a recently developed system, consisting of a size-exclusion chromatographic (SEC) separation followed by a trapping procedure on an RP18 microcolumn with subsequent elution of the trapped fraction and separation by capillary zone electrophoresis (CZE) for the quantification of structural-related peptides in biological matrices, as demonstrated for a number of enkephalins in CSF. After SEC separation of the enkephalins from large proteins present in CSF a heart-cut of 200 nuL, containing the enkephalin peak, is taken, concentrated on the RP18 microcolumn and, after elution of the enkephalins with 80% acetonitrile, a fraction of the eluate is electrokinetically injected into the CZE system, where stacking and separation is achieved. The degradation of the peptides, caused by endogenous peptidases in the matrix, is sufficiently inhibited with imipramine HCl. The assay has a satisfactory linearity and intraday (9.70-16.3%) precision considering the complexity of this multidimensional separation system. The sensitivity of the method, with a concentration limit of quantification of 2.5 nug/mL, is comparable with other CZE assays for peptides and sufficient for the quantification of peptide drugs in biological matrices.

An on-capillary adsorptive phase in combination with capillary electrophoresis (CE), frequently referred to as preconcentration CE, for quantitative analysis of low peptide concentrations was developed. The capillary containing the on-line analyte preconcentrator can be constructed within 5 min from commercially available extraction disks. These disks contain poly(styrenedivinylbenzene) adsorbent particles incorporated in a matrix of inert Teflon, creating a mechanically stable sorbent. Therefore, no frits are needed in the capillary to hold the stationary phase in place. Several parameters, such as the required minimal elution volume, required elution strength, sample application speed or ionic strength, and the capacity were investigated and special interest was given to the quantitative properties of the method. Instead of nL injections, volumes up to a least 25 microL are possible, yielding improvements in detection limits of 3-4 orders of magnitude. The observed limit of detection for both model peptides was 20 pg, corresponding to a 20 microL injection of a 1 ng/mL solution of both model peptides. Using low-wavelength UV detection, reproducibility and linearity in the low nanogram range were satisfactory. No influence of matrix salt concentrations was observed, extending the use of CE to all kinds of samples.

Although capillary zone electrophoresis (CZE) is known for its high resolution power and low mass detection limits, the concentration detection limits are rather poor when ultraviolet absorbance detection is used. To overcome this limitation, several on-column transient isotachophoresis (tITP) protocols have been developed and validated for the determination of both cationic and anionic model peptides, separately. Using this preconcentration method, up to 72% of the capillary can be filled with sample solution, without any loss in resolution. Thus, without any modification of the hardware set-up, the sensitivity is increased about two orders of magnitude. For the model cationic peptides (gonadorelin, angiotensin II) good linearity and reproducibility is observed in the 20 to 100 ng/mL concentration range. For the anionic peptides (N-t-Boc-Pentagastrin and two related peptides), a tITP method was developed using a dynamically coated capillary. The coating was prepared by adding Fluorad FC-135 to the leading electrolyte buffer. In this way a positively charged bilayer was formed on the inside of the capillary, producing an electroosmotic flow towards the outlet using reversed polarity conditions. In this way, acceptable analysis times were achieved. Using the developed tITP method, up to 72% of the capillary can be filled with sample solution as well. The anionic peptides are separated even better than when using CZE conditions. Linearity and reproducibility in the 20-100 ng/mL range proved to be excellent.

No abstract

No abstract

No abstract

No abstract