Cadmium zinc-selenide (Cd0.7Zn0.3Se) thin films were deposited on the ITO substrate using chemical bath deposition techniques by optimizing the deposition parameters. The as-deposited films were annealed in air at 200, 300 and 400 °C for 1 h. The composition, surface morphology and structural properties of the as-deposited and annealed Cd0.7Zn0.3Se thin films were studied using x-ray photoelectron spectroscopy, scanning electron microscopy and x-ray diffraction techniques. The as-deposited films exhibited the hexagonal phase of CdSe and ZnSe. The films annealed at 200 °C showed the dominant cubic phase of CdSe and the hexagonal phase of ZnSe. However, the cubic structure of Cd0.7Zn0.3Se was transformed into a hexagonal structure after annealing at 300 and 400 °C. The lattice parameter a for the cubic structure was 6.0865 Å, whereas for the hexagonal structure a varied from 4.3035 to 4.2938 Å and c varied from 7.0916 to 6.9868 Å. The optical absorption spectra were recorded within the range 350–800 nm. The optical band gaps were 2.08 eV, 2.03 eV, 1.91 eV and 1.72 eV for the as-deposited films and those annealed at 200 °C, 300 °C and 400 °C, respectively. The drastic decrease in the optical band gap at 300 and 400 °C was due to the indium diffusion into the Cd0.7Zn0.3Se matrix.
Recently, because of the advent of Smart Grid and integration of distributed generations, electrical power grids are facing uncountable challenges. Increase of fault current is one of such serious challenges and there are some fault current limiters (FCLs) that can limit the fault current. Existing grid protection FCLs, however, simply limit the fault current passively and can allow the existing protection coordination schemes to fail. This phenomenon leads to catastrophic failure in the complex system and may cause unpredictable power grid operation. Unlike a FCL, a superconducting fault current controller (SFCC) employs a full-bridge thyristor rectifier, a high temperature superconducting (HTS) DC reactor, and an embedded control unit to maintain the fault current level at a proper value by adjusting the phase angle of thyristors. This paper contains experimental and numerical analysis to design and fabricate a SFCC system for protection and stability improvement in power grids. At first, fundamental characteristics of a SFCC system were introduced. System circuit diagram and operational principles were proposed. Secondly, the developed small-scale SFCC system was introduced and verified. A 40 Vrms/30 Arms class prototype SFCC employing HTS DC reactor was fabricated and short circuit tests that simulate various fault conditions were implemented to verify the control performance of the fault current. Finally, the practical feasibility of application of the SFCC system to the power system was studied. The problems caused by three-phase faults from the power grid were surveyed and transient stability analysis of the power system was conducted by simulations. From the experimental and simulation results, we can verify the feasibility of the SFCC in power system.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.