Chip Scale Packages (CSP) are ideal intermediates between Direct Chip Attach (DCA) and Ball Grid Array (BGA) technologies in terms of both size and cost. Depending upon the application, chip scale packages are either underfilled for better solder joint reliability or are attached with a heat sink to keep the operating temperature of the chip under control. In many applications, as discussed in this paper, both an underfill and a heat sink are required. Quite expectedly the addition of two more materials, heat sink and adhesive, in the board level assembly results in fresh reliability concerns. In particular, the requirements on the underfill material and the heat sink attach adhesive are more rigorous and needless to say, a proper understanding of process and material issues is needed to make such a choice. The inelastic strains experienced by the solder joint (related to the underfill) and the peeling stresses at the heat sink attach adhesive interfaces (related to the thermal adhesive) are used as metric for comparing the number of material choices that are available. Based on the results, it is shown that it is important to choose materials that are thermo-mechanically matched with the rest of the system.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.