No abstract

No abstract

The As flux effect on InAs quantum dots formed by gas source molecular beam epitaxy on InP substrates, oriented following the (311)B crystallographic direction has been studied. Atomic force microscopy images show that the quantum dot (QD) density dramatically increases and quantum dot sizes decrease, when decreasing the As pressure. Moreover, the size dispersion is narrowed. Photoluminescence measurements on the high QD density samples is shifted to higher energy, toward the telecommunication important 1.55 µm emission.

A micropyramid structure was formed on the surface of a monocrystalline silicon wafer (100) using a wet chemical anisotropic etching technique. The main objective was to evaluate the performance of the etchant based on the silicon surface reflectance. Different isopropyl alcohol (IPA) volume concentrations (2, 4, 6, 8, and 10%) and different etching times (10, 20, 30, 40, and 50 min) were selected to study the total reflectance of silicon wafers. The other parameters such as NaOH concentration (12% wt.), the temperature of the solution (81.5°C), and range of stirrer speeds (400 rpm) were kept constant for all processes. The surface morphology of the wafer was analyzed by optical microscopy and atomic force microscopy (AFM). The AFM images confirmed a well-uniform pyramidal structure with various average pyramid sizes ranging from 1 to 1.6 μm. A UV-Vis spectrophotometer with integrating sphere was used to obtain the total reflectivity. The textured silicon wafers show high absorbance in the visible region. The optimum texture-etching parameters were found to be 4–6% vol. IPA and 40 min at which the average total reflectance of the silicon wafer was reduced to 11.22%.

In the current study, we investigated the anticancer potential against human colon cells (Caco-2) of colloidal nanosilver (CN–Ag) produced in Syria using bioactive compounds in the aqueous extract of Eucalyptus camaldulensis leaves (AEECL). The formation of AgNPs was confirmed by UV-visible spectroscopy analysis with surface plasmon peak at 449 nm and their average size was found to be 12, 10, 23 nm by SEM, DLS and NTA respectively. This small size has confirmed the effective role of AEECL as capping agent. Further morphological characterization was done by EDS showed the presence of metallic silver. Zeta potential value (-23 mV) indicated the repulsion among the particles and stability of the formulation nanosilver. The anticancer effect of synthesized CN–Ag against Caco-2 has been tested. The cytotoxicity assay showed a dose-dependent and a time-dependent effect of CN–Ag. The high cytotoxicity of CN–Ag at low concentration (5μ/mL) open new prospects for the development of novel therapeutic approaches against human colon cancer Caco-2.

Hypericum perforatum Linn ( St. John’s wort ) is a popular and widespread medicine in Syria, which is used for a wide range of conditions, including gastrointestinal diseases, heart disease, skin diseases, and psychological disorders. This widespread use prompted us to identify the main compounds of this plant from Syria that are responsible for its medicinal properties, especially since its components differ between countries according to the nature of the soil, climate, and altitude. This is, to the best of our knowledge, the first report in which St. John’s wort , a plant native to Syria, is extracted using different solvents and its most important compounds are identified. In this study, the dried above-ground parts, i.e., leaves, stem, petals, and flowers, were extracted using different solvents (water, ethanol, methanol, and acetone) and extraction protocols. By increasing the polarity of the solvent, higher yields were obtained, indicating that mainly hydrophobic compounds were extracted. Therefore, we conclude that extraction using the tea method or using a mixture of water and organic solvents resulted in higher yields compared with pure organic solvents or continuous boiling with water for long periods. The obtained extracts were analyzed using high-performance liquid chromatography equipped with a diode array detector (HPLC–DAD), coupled with UV–visible spectrophotometry at a full spectrum (200–800 nm). The HPLC spectra of the extracts were almost identical at three wavelengths (260 nm for phloroglucinols (hyperforin and derivates), 590 nm for naphthodianthrones (hypericins), and 350 nm for other flavonols, flavones, and caffeoylquinic acids), with differences observed only in the intensity of the peaks. This indicates that the same compounds were obtained using different solvents, but in different amounts. Five standards (chlorogenic acid, quercetin, quercitrin hydrate, hyperoside, and hypericin) were used, and a comparison with retention times and ultraviolet (UV) spectra reported in the literature was performed to identify 10 compounds in these extracts: hyperforin, adhyperforin, hypericin, rutin, quercetin, quercitrin, quercitrin hydrate, hyperoside, biapigenin, and chlorogenic acid. Although the European Pharmacopoeia still describes ultraviolet spectroscopy as a method for determining the quantity of Hyperici herba, interference from other metabolites can occur. Combined HPLC–DAD and electrospray ionization–mass spectrometry (LC-ESI-MS) in the positive mode have therefore also been used to confirm the presence of these compounds in the extracts by correlating known masses with the identified masses or through characteristic fragmentation patterns. Total phenolic contents of the extracts were determined by the Folin–Ciocalteu assay, and antioxidant activity was evaluated as free radical scavenging capacity using 2,2-diphenyl-1-picrylhydrazyl (DPPH) and 2,2′-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid) (ABTS) assays. The resul...

Environmentally green synthesis of stable polyvinyl pyrrolidone (PVP)-capped silver nanoparticles (PVP-AgNPs) was successfully carried out. The present study focused on investigating the influence of adding PVP during the synthesis process on the size, optical properties and antibacterial effect of silver nanoparticles produced. An aqueous extract of Eucalyptus camaldulensis leaves was used as a reducing agent. The effects of different PVP concentrations and reducing time on the synthesis of nanoparticles (NPs) were characterized by UV–Vis spectrophotometry, scanning electron microscopy (SEM), energy dispersive spectrum (EDX), Fourier transform infrared spectroscopy (FTIR), dynamic light scattering (DLS) and nano tracker analysis (NTA). The addition of PVP was studied. The prepared PVP-AgNPs were spherical with an average size of 13 nm. FTIR analysis confirmed that PVP protects AgNPs by a coordination bond between silver nanoparticles and both N and O of PVP. DLS results indicated the good dispersion of silver nanoparticles. PVP-AgNPs were found to be stable for nearly 5 months. Antibacterial studies through the agar well diffusion method confirmed that silver nanoparticles synthesized using PVP had no inhibitor activity toward Gram-positive and Gram-negative bacteria as opposed to silver nanoparticles prepared without adding PVP, which showed a significant antibacterial activity towards some of the tested pathogens.

In this paper, zinc sulfide nanoparticle (ZnS-NP) thin films were deposited onto glass substrates by chemical bath deposition using zinc sulfate as the cation precursor and thiourea as the anionic precursor. Different bath temperatures (65, 70, 75, and 80°C) and different deposition times (20, 30, 40, and 50 min) were selected to study the performance of ZnS thin films. Topographical and optical characterizations of the films were studied using the atomic force microscope (AFM) and UV-Vis spectroscope. The best ZnS thin films were deposited at a bath temperature (70°C) and a deposition time (30 min) with homogeneous distribution, high density, and small average diameter (106 nm). The energy gap (Eg) was found to be in the range of 4.05-3.97 eV for the ZnS films. Optical constants (refractive index, n, extinction coefficient, k, and dielectric constant, ε) of the films were obtained in the wavelength range 300-500 nm by using spectrophotometric measurement. The dispersion of the refractive index is analyzed by using a single oscillator model. The oscillator energy E0 and dispersion energy Ed were determined using the Wemple-DiDomenico single oscillator model. Urbach’s energy increases from 0.907 eV to 2.422 eV with increasing of deposition time. The calculated radius of nanoparticles using Brus equation was 1.9, 2.3, 2.45, and 2.51 nm at deposition times 20, 30, 40, and 50 min, respectively.