Abstract. The connection between marine biogenic dimethyl sulfide (DMS) and the formation of aerosol particles in the Arctic atmosphere was evaluated by analyzing atmospheric DMS mixing ratio, aerosol particle size distribution and aerosol chemical composition data that were concurrently collected at Ny-Ålesund, Svalbard (78.5 • N, 11.8 • E), during April and May 2015. Measurements of aerosol sulfur (S) compounds showed distinct patterns during periods of Arctic haze (April) and phytoplankton blooms (May). Specifically, during the phytoplankton bloom period the contribution of DMS-derived SO 2− 4 to the total aerosol SO 2− 4 increased by 7-fold compared with that during the proceeding Arctic haze period, and accounted for up to 70 % of fine SO 2− 4 particles (< 2.5 µm in diameter). The results also showed that the formation of submicron SO 2− 4 aerosols was significantly associated with an increase in the atmospheric DMS mixing ratio. More importantly, two independent estimates of the formation of DMS-derived SO 2− 4 aerosols, calculated using the stable S-isotope ratio and the non-seasalt SO 2− 4 / methanesulfonic acid ratio, respectively, were in close agreement, providing compelling evidence that the contribution of biogenic DMS to the formation of aerosol particles was substantial during the Arctic phytoplankton bloom period.

Aerosols have been associated with large uncertainties in estimates of the radiation budget and cloud formation processes in the Arctic. This paper reports the results of a study of in situ measurements of hygroscopicity, fraction of volatile species, mixing state, and off-line morphological and elemental analysis of Aitken and accumulation mode particles in the Arctic (Ny-Ålesund, Svalbard) in May and September 2012. The accumulation mode particles were more abundant in May than in September. This difference was due to more air mass flow from lower latitude continental areas, weaker vertical mixing, and less wet scavenging in May than in September, which may have led to a higher amount of long-range transport aerosols entering the Arctic in the spring. The Aitken mode particles observed intermittently in May were produced by nucleation, absent significant external mixing, whereas the accumulation mode particles displayed significant external mixing. The occurrence of an external mixing state was observed more often in May than in September and more often in accumulation mode particles than in Aitken mode particles, and it was associated more with continental air masses (Siberian) than with other air masses. The external mixing of the accumulation mode particles in May may have been caused by multiple sources (i.e., long-range transport aerosols with aging and marine aerosols). These groups of externally mixed particles were subdivided into different mixing structures (internal mixtures of predominantly sulfates and volatile organics without nonvolatile species and internal mixtures of sulfates and nonvolatile components, such as sea salts, minerals, and soot). The variations in the mixing states and chemical species of the Arctic aerosols in terms of their sizes, air masses, and seasons suggest that the continuous size-dependent measurements observed in this study are useful for obtaining better estimates of the effects of these aerosols on climate change.

Platelet aggregation and adhesion are critically involved in both normal hemostasis and thrombosis during vascular injury. Before any surgery, it is important to identify the number of platelets and their functionality to reduce the risk of bleeding; therefore, platelet function testing is a requirement. We introduce a novel evaluation method of assessing platelet function with laser speckle contrast imaging. The speckle decorrelation time (SDT) of the blood flowing through a microfluidic channel chip provides a quantitative measure of platelet aggregation. We compared SDTs of whole blood and platelet-poor blood, i.e., whole blood stripped of its buffy coat region, and found a marked reduction in decorrelation time for platelet-poor blood. The measured SDT of platelet-poor blood was 1.04 ± 0.21 ms, while that of whole blood was 2.64 ± 0.83 ms. To further characterize the sensitivity of our speckle decorrelation time-based platelet function testing (SDT-PFT), we added various agonists involved in platelet aggregation, including adenosine diphosphate (ADP), epinephrine (EPI), and arachidonic acid (AA). In this study, the results show that whole blood with ADP resulted in the largest SDT, followed by whole blood with AA, whole blood with EPI, whole blood without agonist, and platelet-poor blood with or without agonist. These findings show that SDT-PFT has the potential for rapid screening of bleeding disorders and monitoring of anti-platelet therapies with only a small volume of blood.

The development of functional coating materials has resulted in many breakthroughs in the discovery of energy, environmental, and biomedical applications. Responsive polymeric hydrogels are an example of smart coating materials due to their stimuli-responsive characteristics upon changes in their local environment. This review focuses on the introduction of hydrogel nanoparticles and their applications in functional layers as responsive coating materials. Hydrogels are explained by the composition of cross-links and monomers used for preparation. In particular, an important class of responsive hydrogels, that is, nanosized hydrogel particles (nanogels), are described for thee synthesis, modification, and application in assembly of functional coating layers. Finally, nanogel functional layers for biological applications will be discussed with recent advances in biosensing, tissue engineering, and drug delivery.

The determination of the collection efficiency (CE) of particles during transport, vaporization, and ionization in the aerosol mass spectrometer (AMS), which uses vaporizer to evaporate non-refractory particles with subsequent ionization, is important for accurately quantifying the concentrations of chemical constituents. Particle bounce in the vaporizer can be considered as one of the most important parameters influencing the CE of particles. Substrates with various shapes (flat, cylindrical, reverse-conical, cup, trapezoidal, and reverse-T), materials (stainless steel, copper, tungsten, and molybdenum), pores with average sizes of 0.2, 1, 5, 20, and 100 mm, and mesh with a size of 79 mm, which can be a possible candidate for the vaporizer in the AMS, were constructed. Bounce fractions of sub-micrometer particles (polystyrene latex, oleic acid, and dioctyl phthalate) were determined using the differential mobility analyzer (DMA)-impactor technique under a constant impact velocity. For the porous substrate, the particle bounce fraction significantly decreased with increasing pore size and porosity, but there was an upper limit for the pore size above which the particle bounce fraction no longer decreased significantly (i.e., the rebounded particles successfully escaped from the pores). The mesh substrate also had a lower particle bounce fraction than the flat substrate. Among the tested materials, the copper substrate having the lowest hardness and elasticity had the lowest particle bounce fraction. In addition, the reverse-T shape substrate having more available surfaces for particle entrapment led to the reduction of particle bounce fraction. In terms of phase, the liquid particles had lower particle bounce fractions than the solid particles. Our results suggest that the vaporizer in the AMS should provide traps for multiple collisions of the rebounding particles with an appropriate porosity or mesh and should be made of lowhardness materials to minimize particle bounce.

No abstract

Ship-borne measurements of ambient aerosols were conducted during an 11 937 km cruise over the Arctic Ocean (cruise 1) and the Pacific Ocean (cruise 2). A frequent nucleation event was observed during cruise 1 under marine influence, and the abundant organic matter resulting from the strong biological activity in the ocean could contribute to the formation of new particles and their growth to a detectable size. Concentrations of particle mass and black carbon increased with increasing continental influence from polluted areas. During cruise 1, multiple peaks of hygroscopic growth factor (HGF) of 1.1-1.2, 1.4, and 1.6 were found, and higher amounts of volatile organic species existed in the particles compared to that during cruise 2, which is consistent with the greater availability of volatile organic species caused by the strong oceanic biological activity (cruise 1). Internal mixtures of volatile and nonhygroscopic organic species, nonvolatile and less-hygroscopic organic species, and nonvolatile and hygroscopic nss-sulfate with varying fractions can be assumed to constitute the submicrometer particles. On the basis of elemental composition and morphology, the submicrometer particles were classified into C-rich mixture, S-rich mixture, C/S-rich mixture, Na-rich mixture, C/P-rich mixture, and mineral-rich mixture. Consistently, the fraction of biological particles (i.e., P-containing particles) increased when the ship traveled along a strongly biologically active area.

&lt;p&gt;&lt;strong&gt;Abstract.&lt;/strong&gt; The connection between marine biogenic dimethyl sulfide (DMS) and the formation of aerosol particles in the Arctic atmosphere was evaluated by analyzing atmospheric DMS mixing ratios, aerosol particle size distributions and aerosol chemical composition data that were concurrently collected at Ny-&amp;#197;lesund, Svalbard (78.5&amp;#176;&amp;#8201;N, 11.8&amp;#176;&amp;#8201;E) during April and May 2015. Measurements of aerosol sulfur (S) compounds showed distinct patterns during periods of Arctic haze (April) and phytoplankton blooms (May). Specifically, during the phytoplankton bloom period the contribution of DMS-derived SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;2&amp;#8722;&lt;/sup&gt; to the total aerosol SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;2&amp;#8722;&lt;/sup&gt; increased by 7-fold compared with that during the proceeding Arctic haze period, accounting for up to 70&amp;#8201;% of fine SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;2&amp;#8722;&lt;/sup&gt; particles (&lt;&amp;#8201;2.5&amp;#8201;&amp;#181;m in diameter). The results also showed that a sharp increase in the atmospheric DMS mixing ratio during Arctic phytoplankton bloom events was directly associated with the formation of sub-micrometer SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;2&amp;#8722;&lt;/sup&gt; aerosols, and their subsequent growth to climate-relevant particles. Most importantly, two independent estimates of the formation of DMS-derived SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;2&amp;#8722;&lt;/sup&gt; aerosols, calculated using the stable S isotope ratio and non-sea-salt SO&lt;sub&gt;4&lt;/sub&gt;&lt;sup&gt;2&amp;#8722;&lt;/sup&gt;/methanesulfonic acid ratio, respectively, were in close agreement, providing compelling evidence that the contribution of biogenic DMS to the formation of aerosol particles was substantial during the Arctic phytoplankton bloom period.&lt;/p&gt;