It is well known that heat transfer in dropwise condensation (DWC) is superior to that in filmwise condensation (FWC) by at least one order of magnitude. Surfaces with larger contact angle (CA) can promote DWC heat transfer due to the formation of “bare” condensation surface caused by the rapid removal of large condensate droplets and high surface replenishment frequency. Superhydrophobic surfaces with high contact angle (> 150°) of water and low contact angle hysteresis (< 5°) seem to be an ideal condensing surface to promote DWC and enhance heat transfer, in particular, for the steam-air mixture vapor. In the present paper, steam DWC heat transfer characteristics in the presence of noncondensable gas (NCG) were investigated experimentally on superhydrophobic and hydrophobic surfaces including the wetting mode evolution on the roughness-induced superhydrophobic surface. It was found that with increasing NCG concentration, the droplet conducts a transition from the Wenzel to Cassie-Baxter mode. And a new condensate wetting mode—a condensate sinkage mode—was observed, which can help to explain the effect of NCG on the condensation heat transfer performance of steam-air mixture on a roughness-induced superhydrophobic SAM-1 surface.

No abstract

No abstract

An experimental investigation of an oscillating heat pipe (OHP) with a superhydrophobic inner surface coated with a superhydrophobic self-assembled monolayer (SAM) of n-octadecyl mercaptan was conducted. The experimental results show that the oscillating motion in an OHP with a superhydrophobic surface can be generated and the OHP can function well. This is very different from the conventional wicked heat pipe, which cannot function if the inner surface is hydrophobic. The functionality of a superhydrophobic OHP is not sensitive to the wetting condition of the inner surface of the OHP. The investigation results in a better understating of heat transfer mechanism occurring in an OHP.

With ever increasing technological advances in electronics, modern computer components continue to produce higher power densities that present a challenge to thermal management. A radial flat-plate oscillating heat pipe (RFP-OHP) heat spreader is investigated to study the effect of central heating on the heat transport capability in an OHP. The investigated OHP has dimensions of 100 mm × 100 mm × 2.5 mm with central heating using a 30 mm × 30 mm heater. Experimental results show that when heat is added to the center section of one side of the radial flat-plate OHP, and when heat is removed from the whole surface of another side of the heat pipe, the startup power for the oscillating motion increases. In addition, the spacer effect on the heat transport capability including the startup is investigated experimentally. The spacer added between the cooling block and OHP could lower the startup power for oscillatory motion. When compared to a copper slab of the same dimensions in the same test configuration, the temperature difference for the OHP with and without the additional copper spacer was reduced by a maximum of 46% and 25%, respectively, at a power input of 525 W and a heat flux of 58 W/cm2.