The nanoprecipitation method has been investigated to obtain particles in a nanometric and micrometric scale. The particles obtained by this method have been applied in recent years in the food and agricultural industries. Variations of the method as flash nanoprecipitation (FNP) and two-step nanoprecipitation are explained in this article, besides its relation with the ouzo effect.This work presents an overview of the nanoprecipitation method, its advantages, and the potential applications in the food and agricultural industries for improving the quality of food products.

Cereal Chem. 84(3):207-213Wheat flours commercially produced at 74, 80, and 100% extraction rates made from hard white winter wheat (WWF) and hard red winter wheat (WRF) were used to produce tortillas at a commercial-scale level. Flour characteristics for moisture, dry gluten, protein, ash, sedimentation volume, falling number, starch damage, and particle-size distribution were obtained. Farinograms and alveograms were also obtained for flourwater dough. A typical northern Mexican formula was used in the laboratory to test the tortilla-making properties of the flours. Then commercialscale tortilla-baking trials were run on each flour. The baked tortillas were stored at room and refrigeration temperatures for 0, 1, 2, and 3 days. Maximum stress and rollability were measured every day. Tortilla moisture, color, diameter, weight, and thickness were measured for each treatment.Finally, tortilla acceptability was tested by an untrained sensory panel. Analyses of variance (ANOVA) were performed on the data. WWF had higher protein content, dry gluten, sedimentation volume, and water absorption than the WRF. The WWF was the strongest flour based on farinograph development time and alveograph deformation work. It also produced the most extensible dough measured with the alveograph (P/L). Flour protein and ash contents, water absorption, and tenacity increased directly with the flour extraction rate. Both WWF and WRF performed well in commercial-scale baking trials of tortillas. Tortillas made with both types of flours at 74 and 80% extraction rates had the best firmness and rollability. However, tortillas made with WWF 80% had the best color (highest L value). Tortillas prepared with 100% extraction rate flour were also well accepted by the sensory panel, had good textural characteristics, and became only slightly firm and slightly less rollable after three days of storage at room temperature.

Quercetin is a hydrophobic flavonoid with high antioxidant activity. However, for biological applications, the bioavailability of quercetin is low due to physiological barriers. For this reason, an alternative is the protection of quercetin in matrices of biopolymers as zein. The objective of this work was to prepare and characterize quercetin‐loaded zein nanoparticles by electrospraying and its study of in vitro bioavailability. The physicochemical parameters such as viscosity, density, and electrical conductivity of zein solutions showed a dependence of the ethanol concentration. In addition, rheological parameters demonstrated that solutions of zein in aqueous ethanol present Newtonian behavior, rebounding in the formation of nanoparticles by electrospraying, providing spherical, homogeneous, and compact morphologies, mainly at a concentration of 80% (v/v) of ethanol and of 5% (w/v) of zein. The size and shape of quercetin‐loaded zein nanoparticles were studied by transmission electron microscopy (TEM), observing that it was entrapped, distributed throughout the nanoparticle of zein. Analysis by Fourier transform‐infrared (FT‐IR) of zein nanoparticles loaded with quercetin revealed interactions via hydrogen bonds. The efficacy of zein nanoparticles to entrap quercetin was particularly high for all quercetin concentration evaluated in this work (87.9 ± 1.5% to 93.0 ± 2.6%). The in vitro gastrointestinal release of trapped quercetin after 240 min was 79.1%, while that for free quercetin was 99.2%. The in vitro bioavailability was higher for trapped quercetin (5.9%) compared to free quercetin (1.9%), than of gastrointestinal digestion. It is concluded, that the electrospraying technique made possible the obtention of quercitin‐loaded zein nanoparticles increasing their bioavailability. Practical Application This type of nanosystems can be used in the food and pharmaceutical industry. Quercetin‐loaded zein nanoparticles for its improvement compared to free quercetin can be used to decrease the prevalence of chronic degenerative diseases by increasing of the bioavailability of quercetin in the bloodstream. Other application can be as an antioxidant system in functional foods or oils to increase shelf life.

Currently, electrospraying is a novel process for obtaining the nanoparticles from biopolymers. Zein nanoparticles have been obtained by this method and used to protect both hydrophilic and hydrophobic antioxidant molecules from environmental factors. The objective of this work was to prepare and characterize gallic acid‐loaded zein nanoparticles obtained by the electrospraying process to provide protection to gallic acid from environmental factors. Thus, it was related to the concentration of gallic acid in physicochemical and rheological properties of the electrosprayed solution, and also to equipment parameters, such as voltage, flow rate, and distance of the collector in morphology, and particle size. The physicochemical properties showed a relationship in the formation of a Taylor cone, in which at a low concentration of gallic acid (1% w/v), low viscosity (0.00464 ± 0.00001 Pa·s), and density (0.886 ± 0.00002 g/cm3), as well as high electrical conductivity (369 ± 4.3 µs/cm), forms a stable cone‐jet mode. The rheological properties and the Power Law model of the gallic acid‐zein electrosprayed solution demonstrated Newtonian behavior (n = 1). The morphology and size of the particle were dependent on the concentration of gallic acid. Electrosprayed parameters with high voltage (15 kV), low flow rate (0.1 mL/hr), and short distance (10 cm) exhibited a smaller diameter and spherical morphology. FT–IR showed interaction in the gallic acid‐loaded zein nanoparticle by hydrogen bonds. Therefore, the electrospraying process is a feasible technique for obtaining gallic acid‐loaded zein nanoparticles and providing potential protection to gallic acid from environmental factors.

Stenocereus thurberi is an endemic species in northwestern Mexico. It produces colorful fruits called pitayas that have an edible pulp. They have phytochemical compounds associated with biological activities. Ultrafiltration is a widely used method for the clarification of fruit juices and the recovery of phytochemicals. However, its effect has not been extensively studied in extracts. Therefore, the objective of this work is to study the effect of the ultrafiltration of pitaya extract (Stenocereus thurberi) on its phytochemical content, antioxidant capacity, and identification of phenolic compounds by UPLC-DAD-MS, providing greater knowledge about the pitaya. In this study, two extracts were analyzed, the unclarified extract (UE) and the clarified extract (CE). The antioxidant capacity was higher in the CE with 15.93 ± 0.42 mM TE/g, DPPH and 18.37 ± 0.016 mM TE/g, ABTS. The UPLC-MS analysis indicated the decrease in phenolic compounds in the CE and the presence of gallic acid and resorcinol, compounds that had not been identified in other species of Stenocereus spp. The correlation analysis indicated that all the phytochemicals present in the pitaya contribute significantly to the antioxidant capacity. The ultrafiltration process could be a viable option to improve the biological activity of the natural extracts.

No abstract

Currently, microporous polymer materials are being studied extensively due to their attractive properties which allow for a wide potential of applications, such as prolonged-release systems (PRS). The objective of the present work was to prepare and characterize porous microparticles of wheat gluten (WG) using the electrospray technique. The effect of the physicochemical parameters of the solution and electrospray technique parameters on the morphology and size of the materials obtained was studied. For all of the concentrations of WG, porous microparticles with sphere geometry were obtained. At higher concentrations of WG (8% w/v), higher values of viscosity (0.32405 ± 0.002 Pa·s), density (0.997 ± 0.0005 g/cm 3 ), and particle size (1.42 ± 0.71 μm) were obtained, while at lower concentration, high stability rheological is presented, which exhibited Newtonian fluid behavior. Characterization by scanning electron microscopy (SEM), Fourier transform-infrared spectroscopy (FT-IR), and X-ray diffraction indicated that the material obtained has a potential application in the PRS industry. K E Y W O R D SFourier transform-infrared spectroscopy, porous microparticles, rheology, wheat gluten, X-ray

Evaluating the biological potential of wheat grain cultivated in northwestern Mexico is important because it mainly varies according to the cultivar and production area. The aim of the present study was to evaluate ferulic acid (FA) bioaccessibility in breads supplemented with bioprocessed bran. Bran that was bioprocessed with xylanase enzyme (EB), yeast fermentation (FB), and a combination of both treatments (FEB) showed a higher total phenol content and antioxidant capacity compared with native bran (NB), and the majority of these components were found in a bound fraction. For NB and bioprocessed bran, FA was found at higher levels compared to the other hydroxycinnamic acids evaluated. Bioprocessing increased the free FA content six-fold compared to NB. The % bioaccessibility of FA in different breads increased in the following order: FEB