Abstract. The meso-scale chemistry-transport model CHIMERE is used to assess our understanding of major sources and formation processes leading to a fairly large amount of organic aerosols – OA, including primary OA (POA) and secondary OA (SOA) – observed in Mexico City during the MILAGRO field project (March 2006). Chemical analyses of submicron aerosols from aerosol mass spectrometers (AMS) indicate that organic particles found in the Mexico City basin contain a large fraction of oxygenated organic species (OOA) which have strong correspondence with SOA, and that their production actively continues downwind of the city. The SOA formation is modeled here by the one-step oxidation of anthropogenic (i.e. aromatics, alkanes), biogenic (i.e. monoterpenes and isoprene), and biomass-burning SOA precursors and their partitioning into both organic and aqueous phases. Conservative assumptions are made for uncertain parameters to maximize the amount of SOA produced by the model. The near-surface model evaluation shows that predicted OA correlates reasonably well with measurements during the campaign, however it remains a factor of 2 lower than the measured total OA. Fairly good agreement is found between predicted and observed POA within the city suggesting that anthropogenic and biomass burning emissions are reasonably captured. Consistent with previous studies in Mexico City, large discrepancies are encountered for SOA, with a factor of 2–10 model underestimate. When only anthropogenic SOA precursors were considered, the model was able to reproduce within a factor of two the sharp increase in OOA concentrations during the late morning at both urban and near-urban locations but the discrepancy increases rapidly later in the day, consistent with previous results, and is especially obvious when the column-integrated SOA mass is considered instead of the surface concentration. The increase in the missing SOA mass in the afternoon coincides with the sharp drop in POA suggesting a tendency of the model to excessively evaporate the freshly formed SOA. Predicted SOA concentrations in our base case were extremely low when photochemistry was not active, especially overnight, as the SOA formed in the previous day was mostly quickly advected away from the basin. These nighttime discrepancies were not significantly reduced when greatly enhanced partitioning to the aerosol phase was assumed. Model sensitivity results suggest that observed nighttime OOA concentrations are strongly influenced by a regional background SOA (~1.5 μg/m3) of biogenic origin which is transported from the coastal mountain ranges into the Mexico City basin. The presence of biogenic SOA in Mexico City was confirmed by SOA tracer-derived estimates that have reported 1.14 (±0.22) μg/m3 of biogenic SOA at T0, and 1.35 (±0.24) μg/m3 at T1, which are of the same order as the model. Consistent with other recent studies, we find that biogenic SOA does not appear to be underestimated significantly by traditional models, in strong contrast to what is observed for anthropogenic pollution. The relative contribution of biogenic SOA to predicted monthly mean SOA levels (traditional approach) is estimated to be more than 30% within the city and up to 65% at the regional scale which may help explain the significant amount of modern carbon in the aerosols inside the city during low biomass burning periods. The anthropogenic emissions of isoprene and its nighttime oxidation by NO3 were also found to enhance the SOA mean concentrations within the city by an additional 15%. Our results confirm the large underestimation of the SOA production by traditional models in polluted regions (estimated as 10–20 tons within the Mexico City metropolitan area during the daily peak), and emphasize for the first time the role of biogenic precursors in this region, indicating that they cannot be neglected in urban modeling studies.

Two new postprocessing methods are proposed to reduce numerical weather prediction’s systematic and random errors. The first method consists of running a postprocessing algorithm inspired by the Kalman filter (KF) through an ordered set of analog forecasts rather than a sequence of forecasts in time (ANKF). The analog of a forecast for a given location and time is defined as a past prediction that matches selected features of the current forecast. The second method is the weighted average of the observations that verified when the 10 best analogs were valid (AN). ANKF and AN are tested for 10-m wind speed predictions from the Weather Research and Forecasting (WRF) model, with observations from 400 surface stations over the western United States for a 6-month period. Both AN and ANKF predict drastic changes in forecast error (e.g., associated with rapid weather regime changes), a feature lacking in KF and a 7-day running-mean correction (7-Day). The AN almost eliminates the bias of the raw prediction (Raw), while ANKF drastically reduces it with values slightly worse than KF. Both analog-based methods are also able to reduce random errors, therefore improving the predictive skill of Raw. The AN is consistently the best, with average improvements of 10%, 20%, 25%, and 35% with respect to ANKF, KF, 7-Day, and Raw, as measured by centered root-mean-square error, and of 5%, 20%, 25%, and 40%, as measured by rank correlation. Moreover, being a prediction based solely on observations, AN results in an efficient downscaling procedure that eliminates representativeness discrepancies between observations and predictions.

Investigating the characteristics of modelforecast errors using various statistical and object-oriented methods is necessary for providing useful guidance to endusers and model developers as well. To this end, the random and systematic errors (i.e., biases) of the 2-m temperature and 10-m wind predictions of the NCAR-AirDat weather research and forecasting (WRF)-based real-time four-dimensional data assimilation (RTFDDA) and forecasting system are analyzed. This system has been running operationally over a contiguous United States (CONUS) domain at a 4-km grid spacing with four forecast cycles daily from June 2009 to September 2010. In the result an exceptionally useful forecast dataset was generated and used for studying the error properties of the model forecasts, in terms of both a longer time period and a broader coverage of geographic regions than previously studied. Spatiotemporal characteristics of the errors are investigated based on the 24-h forecasts between June 2009 and April 2010, and the 72-h forecasts between May and September 2010. It was found that the biases of both wind and temperature forecasts vary greatly seasonally and diurnally, with dependency on the forecast length, station elevation, geographical location, and meteorological conditions. The temperature showed systematic cold biases during the daytime at all station elevations and warm biases during the nighttime above 1,000 m above sea level (ASL), while below 600 m ASL cold biases occurred during the nighttime. The forecasts of surface wind speed exhibited strong positive biases during the nighttime, while the negative biases were observed in the spring and summer afternoons. The surface wind speed was mostly over-predicted except for the stations located between 1,000 and 2,100 m ASL, for which negative biases were identified for most forecast cycles. The highest wind-speed errors were found over the high terrain and near sea-level stations. The wind-direction errors were relatively large at the high-terrain elevation in the Rocky and Appalachian mountain ranges and the western coastal areas and the error structure exhibited notable diurnal variability.

ABSTRACT:The Diebold-Mariano test for predictive accuracy has been used widely and adapted for economic forecasts, but has not seen much activity in weather forecast verification. The technique is applied to both simulated verification sets as well as weather data at eight stations in Utah, and a loss function based on dynamic time warping (DTW) is used. Results of the simulation experiment show that the DTW technique can be useful if timing errors are the concern. Real test cases demonstrate the difficulty in automating some of the more advanced methods proposed here, but also show the utility in even the most basic test, which is an improvement over similar tests that do not account for temporal and/or contemporaneous correlation.

Abstract. The meso-scale chemistry-transport model CHIMERE is used to assess our understanding of major sources and formation processes leading to a fairly large amount of organic aerosols (OA, including primary OA (POA) and secondary OA (SOA)) observed in Mexico City during the MILAGRO field project (March 2006). Chemical analyses of submicron aerosols from aerosol mass spectrometers (AMS) indicate that organic particles found in the Mexico City basin contain a large fraction of oxygenated organic species (OOA) which have strong correspondence with SOA, and that their production actively continues downwind of the city. The SOA formation is modeled here by the one-step oxidation of anthropogenic (i.e. aromatics, alkanes), biogenic (i.e. monoterpenes and isoprene), and biomass-burning SOA precursors and their partitioning into both organic and aqueous phases. The near-surface model evaluation shows that predicted OA correlates reasonably well with measurements during the campaign, however it remains a factor of 2 lower than the measured total OA. Fairly good agreement is found between predicted and observed POA within the city suggesting that anthropogenic and biomass burning emissions are reasonably captured. Consistent with previous studies in Mexico City, large discrepancies are encountered for SOA, with a factor of 2–10 model underestimate. When only anthropogenic SOA precursors were considered, the model was able to reproduce within a factor of two the sharp increase in SOA concentrations during the late morning at both urban and near-urban locations but the discrepancy increases rapidly later in the day, consistent with previous results, and is especially obvious when the column-integrated SOA mass is considered instead of the surface concentration. The increase in the missing SOA mass in the afternoon coincides with the sharp drop in POA suggesting a tendency of the model to excessively evaporate the freshly formed SOA. Predicted SOA concentrations in our base case were extremely low when photochemistry was not active, especially overnight, as the SOA formed in the previous day was mostly quickly advected away from the basin. These nighttime discrepancies were not significantly reduced when greatly enhanced partitioning to the aerosol phase was assumed. Model sensitivity results suggest that observed nighttime SOA concentrations are strongly influenced by a regional background SOA (~1.5 μg/m3) of biogenic origin which is transported from the coastal mountain ranges into the Mexico City basin. The relative contribution of biogenic SOA to monthly mean modeled SOA levels is estimated to be more than 30% within the city and up to 65–90% at the regional scale (even in the immediate vicinity of the city) which may help explain the significant amount of modern carbon in the aerosols inside the city during low biomass burning periods. The anthropogenic emissions of isoprene and its nighttime oxidation by NO3 were also found to enhance the SOA mean concentrations within the city by an additional 15%. Our results confirm the large underestimation of the SOA production by traditional models in polluted regions (estimated as 10–20 Tons within the Mexico City metropolitan area during the daily peak), and emphasize for the first time the role of biogenic precursors in this region, indicating that they cannot be neglected in modeling studies.

No abstract

Since 2007, meteorologists of the U.S. Army Test and Evaluation Command (ATEC) at Dugway Proving Ground (DPG), Utah, have relied on a mesoscale ensemble prediction system (EPS) known as the Ensemble Four-Dimensional Weather System (E-4DWX). This article describes E-4DWX and the innovative way in which it is calibrated, how it performs, why it was developed, and how meteorologists at DPG use it. E-4DWX has 30 operational members, each configured to produce forecasts of 48 h every 6 h on a 272-processor high performance computer (HPC) at DPG. The ensemble’s members differ from one another in initial-, lateral-, and lower-boundary conditions; in methods of data assimilation; and in physical parameterizations. The predictive core of all members is the Advanced Research core of the Weather Research and Forecasting (WRF) Model. Numerical predictions of the most useful near-surface variables are dynamically calibrated through algorithms that combine logistic regression and quantile regression, generating statistically realistic probabilistic depictions of the atmosphere’s future state at DPG’s observing sites. Army meteorologists view E-4DWX’s output via customized figures posted to a restricted website. Some of these figures summarize collective results—for example, through means, standard deviations, or fractions of the ensemble exceeding thresholds. Other figures show each forecast, individually or grouped—for example, through spaghetti diagrams and time series. This article presents examples of each type of figure.

This study investigates the impact of four-dimensional data assimilation (FDDA) on urban climate analysis, which employs the NCAR (National Center for Atmospheric Research) WRF (the weather research and forecasting model) based on climate FDDA (CFDDA) technology to develop an urban-scale microclimatology database for the Shenzhen area, a rapidly developing metropolitan located along the southern coast of China, where uniquely high-density observations, including ultrahigh-resolution surface AWS (automatic weather station) network, radio sounding, wind profilers, radiometers, and other weather observation platforms, have been installed. CFDDA is an innovative dynamical downscaling regional climate analysis system that assimilates diverse regional observations; and has been employed to produce a 5 year multiscale high-resolution microclimate analysis by assimilating high-density observations at Shenzhen area. The CFDDA system was configured with four nested-grid domains at grid sizes of 27, 9, 3, and 1 km, respectively. This research evaluates the impact of assimilating high-resolution observation data on reproducing the refining features of urban-scale circulations. Two experiments were conducted with a 5 year run using CFSR (climate forecast system reanalysis) as boundary and initial conditions: one with CFDDA and the other without. The comparisons of these two experiments with observations indicate that CFDDA greatly reduces the model analysis error and is able to realistically analyze the microscale features such as urbanrural-coastal circulation, land/sea breezes, and local-hilly terrain thermal circulations. It is demonstrated that the urbanization can produce 2.5 k differences in 2 m temperatures, delays/speeds up the land/sea breeze development, and interacts with local mountain-valley circulations.