No abstract

The detection of peptides is an important bioanalytical challenge, as they are a generic class of potent molecules of biomedical and biopharmaceutical significance. In this work, the electrochemistry of seven oligopeptides at microscaled interfaces between two immiscible electrolyte solutions (microITIES) was investigated. Their transfer across the polarized interface was assisted by dibenzo-18-crown-6 (DB18C6). The ion transfer potentials of these oligopeptides were dependent on their hydrophobicities and their interaction with DB18C6. Micropore arrays, which were fabricated in silicon by a combination of wet and dry etch techniques, were used to enhance mass transfer and thus analytical sensitivities. The use of a gellified organic phase allowed the implementation of voltammetric stripping techniques at the liquid-organogel interface. The combination of interface miniaturization and stripping voltammetry provided limits of detection at submicromolar concentration levels. The sensitivities (calibration graph slopes) were -3205 nA microM(-1) cm(-2) for Phe-Phe, -1791 nA microM(-1) cm(-2) for Leu-Leu, -6014 nA microM(-1) cm(-2) for Lys-Lys, and -9611 nA microM(-1) cm(-2) for Lys-Lys-Lys. Mixtures of peptides were also investigated with this technique, illustrating the possibility to detect certain mixture combinations.

An electrochemical method was developed for rapid and sensitive detection of the herbicide paraquat in aqueous samples using mesoporous silica thin film modified glassy carbon electrodes (GCE). Vertically aligned mesoporous silica thin films were deposited onto GCE by electrochemically assisted self-assembly (EASA). Cyclic voltammetry revealed effective response to the cationic analyte (while rejecting anions) thanks to the charge selectivity exhibited by the negatively charged mesoporous channels. Square wave voltametry (SWV) was then used to detect paraquat via its one electron reduction process. Influence of various experimental parameters (i.e., pH, electrolyte concentration, and nature of electrolyte anions) on sensitivity was investigated and discussed with respect to the mesopore characteristics and accumulation efficiency, pointing out the key role of charge distribution in such confined spaces on these processes. Calibration plots for paraquat concentration ranging from 10 nM to 10 μM were constructed at mesoporous silica modified GCE which were linear with increasing paraquat concentration, showing dramatically enhanced sensitivity (almost 30 times) as compared to nonmodified electrodes. Finally, real samples from Meuse River (France) spiked with paraquat, without any pretreatment (except filtration), were analyzed by SWV, revealing the possible detection of paraquat at very low concentration (10-50 nM). Limit of detection (LOD) calculated from real sample analysis was found to be 12 nM, which is well below the permissible limits of paraquat in drinking water (40-400 nM) in various countries.

No abstract

Electrochemical methods for the detection of amino acids, peptides, and proteins in a variety of media are reviewed. Label-free strategies in which the detection is based on the inherent electrochemical properties of the analyte are discussed. Various processes such as direct or mediated (in solution or immobilised) redox processes and interfacial ion transfers have been employed for the electrochemical detection and determination of the target analytes. The various methods covered encompass voltammetry at uncoated and modified electrodes and at immiscible liquid-liquid interfaces, potentiometry at polymer membrane electrodes and electrochemical impedance spectroscopy. The determination of the target analytes in complex biological matrices is discussed. The various approaches highlighted here illustrate the rich capabilities of electrochemical methods as simple, low-cost, sensitive tools for the determination of these important biological analytes at trace and ultra-trace levels.

The interaction of proteins with interfaces and surfaces provides a basis for studying their behaviour and methods to detect them. This paper is concerned with elucidation of the mechanism of electrochemical detection of haemoglobin (Hb) at the interface between aqueous and organic electrolyte solutions. The adsorption of Hb at the interface was investigated by alternating current (AC) voltammetry. It was found that addition of Hb to the aqueous phase induced a shift of the potential of zero charge at the liquid/liquid interface, due to interfacial adsorption of Hb. The influence of the nature and the concentration of the organic phase electrolyte on the electrochemical signal was investigated by cyclic voltammetry (CV). It was found that the electrochemical signal, in the presence of aqueous phase Hb, was due to the facilitated transfer of the anion of the organic phase electrolyte to the aqueous phase. The transfer current was dependent on both the nature and concentration of the organic phase electrolyte anion. These results confirm that adsorbed Hb molecules at the liquid/liquid interface interact with small ionised molecules and facilitate their transfer across the interface. The results will provide a basis for both biomolecular detection methods and for the study of protein-small ionised molecule interactions.

No abstract

In this work, we fabricate gold nanowires with well controlled critical dimensions using a recently demonstrated facile approach termed nanoskiving. Nanowires are fabricated with lengths of several hundreds of micrometers and are easily electrically contacted using overlay electrodes. Following fabrication, nanowire device performance is assessed using both electrical and electrochemical characterization techniques. We observe low electrical resistances with typical linear Ohmic responses from fully packaged nanowire devices. Steady-state cyclic voltammograms in ferrocenemonocarboxylic acid demonstrate scan rate independence up to 1000 mV s(-1). Electrochemical responses are excellently described by classical Butler-Volmer kinetics, displaying a fast, heterogeneous electron transfer kinetics, k(0) = 2.27 ± 0.02 cm s(-1), α = 0.4 ± 0.01. Direct reduction of hydrogen peroxide is observed at nanowires across the 110 pM to 1 mM concentration range, without the need for chemical modification, demonstrating the potential of these devices for electrochemical applications.