Miniaturised liquid/liquid interfaces provide benefits for bioanalytical detection with electrochemical methods. In this work, microporous silicon membranes which can be used for interface miniaturisation were characterized by simulations and experiments. The microporous membranes possessed hexagonal arrays of pores with radii between 10 and 25 microm, a pore depth of 100 microm and pore centre-to-centre separations between 99 and 986 microm. Cyclic voltammetry was used to monitor ion transfer across arrays of micro-interfaces between two immiscible electrolyte solutions (microITIES) formed at these membranes, with the organic phase present as an organogel. The results were compared to computational simulations taking into account mass transport by diffusion and encompassing diffusion to recessed interfaces and overlapped diffusion zones. The simulation and experimental data were both consistent with the situation where the location of the liquid/liquid (l/l) interface was on the aqueous side of the silicon membrane and the pores were filled with the organic phase. While the current for the forward potential scan (transfer of the ion from the aqueous phase to the organic phase) was strongly dependent on the location of the l/l interface, the current peak during the reverse scan (transfer of the ion from the organic phase to the aqueous phase) was influenced by the ratio of the transferring ion's diffusion coefficients in both phases. The diffusion coefficient of the transferring ion in the gelified organic phase was ca. nine times smaller than in the aqueous phase. Asymmetric cyclic voltammogram shapes were caused by the combined effect of non-symmetrical diffusion (spherical and linear) and by the inequality of the diffusion coefficient in both phases. Overlapping diffusion zones were responsible for the observation of current peaks instead of steady-state currents during the forward scan. The characterisation of the diffusion behaviour is an important requirement for application of these silicon membranes in electroanalytical chemistry.

The behaviour of two biological macromolecules, bovine pancreatic insulin and hen-egg-white lysozyme (HEWL), at aqueous-organogel interfaces confined within an array of solid-state membrane micropores was investigated via cyclic voltammetry (CV). The behaviour observed is discussed in terms of possible charge transferring species and mass transport in the interfacial reaction. Comparison of CV results for HEWL, insulin, and the well-characterised model ion tetraethylammonium cation (TEA(+)) revealed that the biomacromolecules undergo an interfacial reaction comprising biomacromolecular adsorption and facilitated transfer of electrolyte anions from the organic phase to a protein layer on the aqueous side of the interface, whereas TEA(+) undergoes a simple ion transfer process. Evidence for biomacromolecular adsorption on the aqueous side of the micro-interfaces is provided by comparison of the CVs for TEA(+) ion transfer in the presence and absence of the biomacromolecules. Similar experiments in the presence of the low generation polypropylenimine tetraamine dendrimer, (DAB-AM-4), a smaller synthetic molecule, revealed it to be non-adsorbing. The behaviour of biological macromolecules at miniaturised aqueous-organogel interfaces involves adsorption on the aqueous side of the interface and transfer of organic phase electrolyte anions across the interface to associate with the adsorbed biomacromolecule. The data presented support the previously suggested mechanism for biomacromolecular voltammetry at liquid-liquid interfaces, involving adsorption and facilitated ion-transfer of organic electrolyte anions.

Ion transfer across interfaces between immiscible liquids provides a means for the nonredox electrochemical detection of ions. Miniaturization of such interfaces brings the benefits of enhanced mass transport. Here, the electrochemical behavior of geometrically regular arrays of nanoscale interfaces between two immiscible electrolyte solutions (nanoITIES arrays) is presented. These were prepared by supporting the two electrolyte phases within silicon nitride membranes containing engineered arrays of nanopores. The nanoITIES arrays were characterized by cyclic voltammetry of the interfacial transfer of tetraethylammonium cation (TEA(+)) between the aqueous phase and the gelled organic phase. Effects of pore radius, pore center-to-center separation, and number of pores in the array were examined. The ion transfer produced apparent steady-state voltammetry on the forward and reverse sweeps at all experimentally accessible scan rates and at all nanopore array designs. However, background-subtraction of the voltammograms revealed the evolution of a peak-shaped response on the reverse sweep with increasing scan rate, indicative of pores filled with the organic phase to a certain extent. The steady-state voltammetric behavior at the nanoITIES arrays on the forward sweep for arrays with significant diffusion zone overlap between adjacent nanoITIES is indicative of the dominance of radial diffusion to interfaces at the edge of the arrays over linear diffusion to interfaces within the arrays. This implies that nanoITIES arrays, which occupy an overall area of micrometer dimensions, behave like a single microITIES of corresponding area to the nanoITIES array.

The interaction of proteins with interfaces and surfaces provides a basis for studying their behaviour and methods to detect them. This paper is concerned with elucidation of the mechanism of electrochemical detection of haemoglobin (Hb) at the interface between aqueous and organic electrolyte solutions. The adsorption of Hb at the interface was investigated by alternating current (AC) voltammetry. It was found that addition of Hb to the aqueous phase induced a shift of the potential of zero charge at the liquid/liquid interface, due to interfacial adsorption of Hb. The influence of the nature and the concentration of the organic phase electrolyte on the electrochemical signal was investigated by cyclic voltammetry (CV). It was found that the electrochemical signal, in the presence of aqueous phase Hb, was due to the facilitated transfer of the anion of the organic phase electrolyte to the aqueous phase. The transfer current was dependent on both the nature and concentration of the organic phase electrolyte anion. These results confirm that adsorbed Hb molecules at the liquid/liquid interface interact with small ionised molecules and facilitate their transfer across the interface. The results will provide a basis for both biomolecular detection methods and for the study of protein-small ionised molecule interactions.

In this work, we fabricate gold nanowires with well controlled critical dimensions using a recently demonstrated facile approach termed nanoskiving. Nanowires are fabricated with lengths of several hundreds of micrometers and are easily electrically contacted using overlay electrodes. Following fabrication, nanowire device performance is assessed using both electrical and electrochemical characterization techniques. We observe low electrical resistances with typical linear Ohmic responses from fully packaged nanowire devices. Steady-state cyclic voltammograms in ferrocenemonocarboxylic acid demonstrate scan rate independence up to 1000 mV s(-1). Electrochemical responses are excellently described by classical Butler-Volmer kinetics, displaying a fast, heterogeneous electron transfer kinetics, k(0) = 2.27 ± 0.02 cm s(-1), α = 0.4 ± 0.01. Direct reduction of hydrogen peroxide is observed at nanowires across the 110 pM to 1 mM concentration range, without the need for chemical modification, demonstrating the potential of these devices for electrochemical applications.

No abstract

The transport equation for the rotating disk electrode is solved numerically with appropriate boundary conditions for reversible and nonreversible redox reactions. A comparison of the computational mode with experimentel data is presented. The adaption of a steady state under variations of experimental parameters I J (scan rate) and w (angular frequency of rotation) is investigated. It is shown that a triangular voltage scan can be used to indicate the attainment of a steady state in every zone of the current-voltage curve.

No abstract