No abstract

The development of ion extraction methods under electrochemical control via electrochemistry at the interface between two immiscible electrolyte solutions is discussed. A hydrodynamic flow injection system was used for the potentiostatic extraction of non-redox-active species from a flowing aqueous phase into a stationary organogel phase. The ions tetraethylammonium, 4-octylbenzenesulfonate (4-OBSA-), and p-toluenesulfonate (p-TSA-) were studied as model analytes. The extraction study comprised examination of the influence of extraction potentials, aqueous-phase flow rate, and target species concentration. The extraction process can be monitored in situ by means of the ion-transfer current, which has opposing signs for anions and cations. Hydrodynamic voltammograms were obtained from these experiments. The selective extraction of 4-OBSA-, from its mixture with p-TSA-, as well as coextraction of both anions is shown. The results demonstrate the utility of electrochemical modulation for the controlled extraction of ions from an aqueous phase into an organogel electrolyte phase. This offers potential benefits for various analytical processes including sample preparation and cleanup.

The electrochemistry of a series of dendrimers was examined at the interface between two immiscible electrolyte solutions (ITIES), enabling study of non-redox-active dendrimers. Different generations of poly(propylenimine) (DAB-AM-n) and poly(amidoamine) (PAMAM) dendrimers were studied. In their protonated states, the dendrimers were transferred across the ITIES, with the electrochemical behavior observed depending on the dendrimer family, the generation number, and the experimental pH. The electrochemistry of the lower generations studied was characterized by well-defined peaks for both dendrimer families and with small peak-peak separations in the case of the PAMAM family. The voltammetry of the higher generations was more complex, showing distorted voltammograms and instability of the interface. The charges of the transferring dendrimers were calculated by convolution of the voltammetric data and were similar to the theoretical charges for DAB-AM-n. For PAMAM, only the lowest generation exhibited reversible behavior, with higher generations having irreversible behavior. Using cyclic voltammetry, low micromolar concentrations of the dendrimers were detected. The results show that electrochemistry at the ITIES can be a useful method for characterization of ionizable dendrimers and that voltammetry can be a simple method for detection of low concentrations of these multicharged species.

No abstract

Electrochemically modulated liquid-liquid extraction (EMLLE) enables the selective extraction and separation of ions from mixtures by choice of an applied interfacial potential difference. The extraction of ionized drugs from artificial urine is reported in this paper. The artificial urine matrix was characterized by cyclic voltammetry at the interface between two immiscible electrolyte solutions (ITIES), showing that components of that aqueous phase truncate the available potential window at the ITIES. The transfer of three cationic drugs from aqueous artificial urine to the 1,2-dichloroethane organic electrolyte phase was examined. Both propranolol and timolol were found to transfer across the artificial urine-organic interface. However, sotalol transfer was not possible within the available potential window. Extraction of propranolol and timolol from artificial urine into an organogel phase, by electrochemically modulated liquid-liquid extraction, was examined. The application of potentials positive of the drugs' formal transfer potentials enabled the selective extraction of both propranolol and timolol, with a higher potential being required for timolol. This work demonstrates the practical utility of EMLLE for the selective extraction of target compounds from a complex sample matrix.

Electrochemistry at the interface between two immiscible electrolyte solutions has been presented as a method of electrochemically modulated liquid-liquid extraction, where ions in a mixture can be selectively partitioned as a function of the applied interfacial potential difference. In this study, a mixture comprising 4-octylbenzenesulfonate (4-OBSA-) and tetraethylammonium (TEA+) ions was evaluated. The application of negative potential differences enabled the selective extraction of 4-OBSA- into the organic phase, and more positive potential differences enabled the selective extraction of TEA+. However, intermediate potentials lead to the coextraction of both ions into the organic phase, with apparent selectivity for TEA+ over 4-OBSA-. An increased concentration of either ion in the mixture inhibited the extraction response of the other ion, but the order of the extraction at these intermediate potentials was always TEA+ followed by 4-OBSA-. The reasons for the selectivity for the cation over the anion are discussed.

Electrochemistry at the liquid-liquid interface enables the detection of nonredoxactive species with electroanalytical techniques. In this work, the electrochemical behavior of two food additives, aspartame and acesulfame K, was investigated. Both ions were found to undergo ion-transfer voltammetry at the liquid-liquid interface. Differential pulse voltammetry was used for the preparation of calibration curves over the concentration range of 30-350 microM with a detection limit of 30 microM. The standard addition method was applied to the determination of their concentrations in food and beverage samples such as sweeteners and sugar-free beverages. Selective electrochemically modulated liquid-liquid extraction of these species in both laboratory solutions and in beverage samples was also demonstrated. These results indicate the suitability of liquid-liquid electrochemistry as an analytical approach in food analysis.

A microfluidic device is presented with offchip electrodes residing in a reservoir and connected via micro-capillaries to the Y-shaped microfluidic channel. The device is tested by potentiometric measurements involving dual-stream laminar flow of two aqueous solutions carrying different electrolytes at various concentrations. Open circuit potentials are measured for a series of solutions of alkali metal chlorides and tetraalkylammonium chlorides as well as for dilute hydrochloric acid. The open circuit potential for the microfluidic chip was calculated by taking into account the diffusion potential at finite ionic strength as well as the potential difference introduced by the reference electrode system. The liquid junction potential developed at the boundary of the co-flowing aqueous solutions may be manipulated to have greater or lesser relative contributions to the measured open circuit potential based on use of electrolyte salts having cation and anion pairs of similar or dissimilar mobilities in solution. A reasonable agreement between theoretical and experimental values of the open circuit potential is observed for these situations. The results show that simple microfluidic structures possess a rich environment for exploration and application of the solution chemistry of ions.