No abstract

No abstract

There are many studies related to using alkali activated binders for the improvement of clayey soil mechanical properties. In this study, alkali activated slag (AAS) for the improvement of clayey soil strength was used and it reinforced the clay. This paper presents results of an investigation on the utilization of ground-granulated blast-furnace slag in the reinforcement of clay soils. Therefore, significant cost savings could be achieved by using alkali activated slag as binding material. These samples were analyzed by X-Ray fluorescence analysis (XRF), X-Ray diffraction (XRD), scanning electron microscopy (SEM) and strength tests after the curing. The clay samples reinforced with AAS showed higher shear stress, cohesion and internal friction angle compared with the samples without reinforcement. The highest shear strength was achieved by using the highest amount of AAS (30%). This shear stress of the unreinforced clay samples could be increased from 63.2 to 137.4 kPa (117.4%) and from 123.2 to 257.4 kPa (108.9%) when the normal stress value of 100 and 500 kPa was used, respectively. The increase in shear strength is closely related to the compact contact zone between AAS and clay. Moreover, the new formed cementitious compounds of AAS had a positive influence on the shear strength of samples as well.

A study of immobilization of hexavalent chromium in the form of Na2CrO4 salt by self-compacting soils (SCS) is presented. Carbofill E additive was used as SCS binder. The efficiency of immobilization of Cr (VI) was evaluated by washing out chromium compounds from SCS samples. The influence of the nature of the soil and the content of Carbofill E and Na2CrO4 in the SCS samples on the efficiency of Cr (VI) immobilization was studied. It was found that the nature of the soil and the content of Carbofill E in the SCS samples affect the immobilization of Cr (VI). Moreover, increasing the Carbofill E content in SCS samples further increases Cr (VI) immobilization. X-ray diffraction studies of the samples with immobilized hexavalent chromium showed that part of the sample transforms from a readily soluble form of salt into oxide forms of chromium and calcium-chromium, which are practically insoluble in water.

Abstract. This paper presents new ideas about the possibilities to increase the reliability of clay slope stability computation method. Many known methods are proved to give controversial results. The reason for this discrepancy is explained to be the result of assumptions and simplifications introduced into the methods, insufficiently precise estimation of porous water pressure, and the dependency of clay cohesion on a sudden change of compression as well. The method of a modified Boussinesq equation and slices is suggested to compute slope stability in terms of clay cohesion and internal friction determined under unconsolidated-undrained conditions.