We investigate electronic transport properties of as-grown and annealed n-type modulationdoped Al 0.15 Ga 0.85 As/GaAs 1−x Bi x (x=0 and 0.04) quantum well (QW) structures using magnetotransport measurements in the temperature range 4.2 K and 60 K and at magnetic fields up to 18 T. Thermal annealing process was applied at two different temperatures, 700 °C and 350 °C during 60 s and 180 s, respectively. We find that electron effective mass and 2D electron density in as-grown Bi-containing sample are slightly lower than that in Bi-free one. Furthermore, quantum electron mobility and quantum scattering time are observed to be decreased in Bi-containing samples. The annealing process at 700 °C causes a slight increase in electron effective mass and 2D electron density. A negligible decrease in electron effective mass and an increase in 2D electron density are determined following annealing at 350 °C. The observed change in electron effective mass following thermal annealing process is attributed to changing 2D electron density in the samples. No improvement on quantum electron mobility and quantum scattering time are observed following thermal annealing at both process temperatures. We determine that one electron subband (e1) for as-grown and annealed (at 700 °C for 60 s) Bicontaining QWs and two electron subbands (e1 and e2) for the annealed (at 350 °C for 180 s) GaAsBi QW sample and the Bi-free QW sample contribute to electronic transport. Our results reveal that there is no significant direct effect of Bi on effective electron mass, but an indirect effect, in which Bi can provoke changes in 2D electron density and hence causes not to observe actual band-edge electron mass but a deviation from its band-edge value. Therefore, it can be concluded that dispersion curve of conduction band does not change as an effect of Bi incorporation in GaAs.

No abstract

Imazapyr owes its importance in Morocco to its success in controlling the perennial weed Solanumelaeagnifolium Cav., which infests the Tadla area. Persistence and mobility of imazapyr has been studied in two Moroccan soils from the Rabat area, with differing organic matter content (red and organic soils), under laboratory conditions at 75% of their field capacities and 25–28 °C. Residue analysis was performed on the basis of a bioassay test using lentil (Lens culinaris Medic.) as indicator species. The residual activity of imazapyr accounted for 69%, 25%, 50% and 62%, 46%, 66% of the initial activity for the red and organic soils at 1, 5 and 10 mg L−1 respectively. The half‐lives varied between 25 and 58 days for the red soil and 55 and 58 days for the organic soil. In the organic soil, imazapyr was highly mobile under the irrigation regime applied. Most of the activity was found in the first 3 × 75 mL of the effluents. A following biotest with the leached soil showed low remaining residual activity.

Here, we compare the sunspot counts and the number of sunspot groups (SGs) with variations of total solar irradiance (TSI), magnetic activity, Ca II K-flux, faculae and plage areas. We applied a time series method for extracting the data over the descending phases of solar activity cycles (SACs) 21, 22 and 23, and the ascending phases 22 and 23. Our results suggest that there is a strong correlation between solar activity indices and the changes in small (A, B, C and H-modified Zurich Classification) and large (D, E and F) SGs. This somewhat unexpected finding suggests that plage regions substantially decreased in spite of the higher number of large SGs in SAC 23 while the Ca II K-flux did not decrease by a large amount nor was it comparable with SAC 22 and relates with C and DEF type SGs. In addition to this, the increase of facular areas which are influenced by large SGs, caused a small percentage decrease in TSI while the decrement of plage areas triggered a higher decrease in the magnetic field flux. Our results thus reveal the potential of such a detailed comparison of the SG analysis with solar activity indices for better understanding and predicting future trends in the SACs.

In this study, considering the temporarily unbiased force and different forms of oscillating forces, we investigate the current and efficiency of Brownian particles in an entropic tube structure and present the numerically obtained results. We show that different force forms give rise to different current and efficiency profiles in different optimized parameter intervals. We find that an unbiased oscillating force and an unbiased temporal force lead to the current and efficiency, which are dependent on these parameters. We also observe that the current and efficiency caused by temporal and different oscillating forces have maximum and minimum values in different parameter intervals. We conclude that the current or efficiency can be controlled dynamically by adjusting the parameters of entropic barriers and applied force.