In this study a blue‐light‐emitting conjugated polymer, poly(9,9‐dioctylfluorene), is confined to the interlayer space of inorganic, layered metal dichalcogenide materials, metallic MoS2, and semiconducting SnS2. The nanocomposites are prepared through Li intercalation into the inorganic compound, exfoliation, and restacking in the presence of the polymer. X‐ray diffraction and optical absorption measurements indicate that a single conjugated polymer monolayer, with an overall extended planar morphology conformation, is isolated between the inorganic sheets, so that polymer aggregation or π–π interchain interactions are significantly reduced. Photoluminescence (PL) measurements show that the appearance of the undesirable green emission observed in pristine polymer films is suppressed by incorporating the polymer into the inorganic matrix. The blue emission of the intercalated polymer is stable for extended periods of time, over two years, under ambient conditions. Furthermore, the green emission is absent in the PL spectra of nanocomposite films heated at 100 °C for 7 h in air with direct excitation of the keto defect. Finally, no green emission was observed in the electroluminescence spectrum of light‐emitting devices fabricated with a polymer‐intercalated SnS2 nanocomposite film. These results support the proposed hypothesis that fluorenone defects alone are insufficient to generate the green emission and that interchain interactions are also required.

The generation of white light requires the combination of two or more chromophores that emit simultaneously. The observed color of a mixture of light-emitting molecules, however, originates generally only from the lowest band-gap species because of efficient energy transfer between the chromophores which is difficult to avoid. Here we report on a nanocomposite material designed to yield pure and stable white photo- and electroluminescence. In this material, red, green, and blue emitting conjugated polymers are confined within the galleries of a layered semiconducting host matrix. The host hinders polymer pi-pi interactions which are responsible for the energy transfer between polymer chains, consequently, emission from the three chromophores is observed simultaneously resulting in white photoluminescence. The efficacy of the nanocomposites is demonstrated in simple single-layer white-emitting polymer diodes. The mechanism suggested here for white light generation, supported by extensive luminescence measurements, is in contrast to that previously reported in white-emitting polymer diodes where efficient energy transfer between polymer chains was essential for obtaining white light.

The dimensionality of conjugated polymer systems plays an important role in energy-transfer processes, and 1D and 2D energy transfer of excitations are typically much slower than that between pi-stacked chains within a 3D polymeric solid. However, whether 2D energy transfer in conjugated polymers occurs mainly along polymer chains (intrachain), or between in-plain-adjacent polymer chains (interchain), has yet to be determined due to the difficulty of experimentally decoupling inter- and intrachain interaction in a 2D polymer system. This can be achieved by incorporating conjugated polymer chains into the planar galleries of layered matrices which sterically hinder polymer aggregation and pi-pi interchain interactions. Here, pristine blue-emitting polyfluorene chains and polyfluorene chains with known concentrations of green-emitting on-chain fluorenone defects are either separately or collectively incorporated into layered SnS(2). X-ray powder diffraction of the composite films confirms incorporation of the polymer chains into the layered galleries. Monitoring the fluorene-to-fluorenone energy transfer as a function of fluorenone concentration and distribution in the layered galleries allows differentiation between inter- and intrachain fluorene-fluorenone energy transfer. It is found that, 2D energy transfer in conjugated polymers follows mainly an interchain process, despite the absence of pi-pi interchain interactions.

Lamellar nanocomposites based on semiconducting polymers incorporated into layered inorganic matrices are prepared by the co-assembly of organic and inorganic precursors. Semiconducting polymer-incorporated silica is prepared by introducing the semiconducting polymers into a tetrahydrofuran (THF)/water homogeneous sol solution containing silica precursor species and a surface-active agent. Semiconducting polymer-incorporated MoS 2 and SnS 2 are prepared by Li intercalation into the inorganic compound, exfoliation and restack in the presence of the semiconducting polymer. All lamellar nanocomposite films are organized in domains aligned parallel to the substrate surface plane. The incorporated polymers maintain their semiconducting properties, as evident from their optical absorption and photoluminescence spectra. The optoelectronic properties of the nanocomposites depend on the properties of both the inorganic host and the incorporated guest polymer as demonstrated by integrating the nanocomposite films into light-emitting diodes. Devices based on polymer-incorporated silica and polymer-incorporated MoS 2 show no diode behaviour and no light emission due to the insulating and metallic properties of the silica and MoS 2 hosts. In contrast, diode performance and electroluminescence are obtained from devices based on semiconducting polymer-incorporated semiconducting SnS 2 , demonstrating that judicious selection of the composite components in combination with the optimization of material synthesis conditions allows new hierarchical structures to be tailored for electronic and optoelectronic applications.

Photophysical processes in conjugated polymers are influenced by two competing effects: the extent of excited state delocalization along a chain, and the electronic interaction between chains. Experimentally, it is often difficult to separate the two because both are controlled by chain conformation. Here we demonstrate that it is possible to modify intra-chain delocalization without inducing inter-chain interactions by intercalating polymer monolayers between the sheets of an inorganic layered matrix. The red-emitting conjugated polymer, MEH-PPV, is confined to the interlayer space of layered SnS(2). The formation of isolated polymer monolayers between the SnS(2) sheets is confirmed by X-ray diffraction measurements. Photoluminescence excitation (PLE) and photoluminescence (PL) spectra of the incorporated MEH-PPV chains reveal that the morphology of the incorporated chains can be varied through the choice of solvent used for chain intercalation. Incorporation from chloroform results in more extended conformations compared to intercalation from xylene. Even highly twisted conformations can be achieved when the incorporation occurs from a methanol:chloroform mixture. The PL spectra of the MEH-PPV incorporated SnS(2) nanocomposites using the different solvents are in good agreement with the PL spectra of the same solutions, indicating that the conformation of the polymer chains in the solutions is retained upon intercalation into the inorganic host. Therefore, intercalation of conjugated polymer chains into layered hosts enables the study of intra-chain photophysical processes as a function of chain conformation.