Semi-transparent perovskite solar cells are highly attractive for a wide range of applications, such as bifacial and tandem solar cells; however, the power conversion efficiency of semi-transparent devices still lags behind due to missing suitable transparent rear electrode or deposition process. Here we report a low-temperature process for efficient semi-transparent planar perovskite solar cells. A hybrid thermal evaporation–spin coating technique is developed to allow the introduction of PCBM in regular device configuration, which facilitates the growth of high-quality absorber, resulting in hysteresis-free devices. We employ high-mobility hydrogenated indium oxide as transparent rear electrode by room-temperature radio-frequency magnetron sputtering, yielding a semi-transparent solar cell with steady-state efficiency of 14.2% along with 72% average transmittance in the near-infrared region. With such semi-transparent devices, we show a substantial power enhancement when operating as bifacial solar cell, and in combination with low-bandgap copper indium gallium diselenide we further demonstrate 20.5% efficiency in four-terminal tandem configuration.
The introduction of a KF post-deposition treatment (KF PDT) of Cu(In,Ga)Se 2 (CIGS) thin films has led to the achievement of several consecutive new world record efficiencies up to 21.7% for the CIGS solar cell technology. The beneficial effect of the KF PDT on the photovoltaic parameters was observed by several groups in spite of differing growth methods of the CIGS layer. For CIGS evaporated at lower temperature on alkali-free, flexible plastic substrates, a postdeposition treatment to add Na was already successfully applied. However with the introduction of additional KF under comparable conditions, distinctly different influences on the final absorber alkali content as well as surface properties are observed. In this work we discuss in more details the intrinsically different role of both alkali-treatments by combining several microstructural and compositional analysis methods. The ion exchange of Na by K in the bulk of the absorber is carefully analyzed, and further evidences for the formation of a K-containing layer on the CIGS surface with increased surface reactivity are given. These results shall serve as a basis for the further understanding of the effects of alkali PDT on CIGS and help identifying research needs to achieve even higher efficiencies.
Chalcopyrite solar cells achieve efficiencies above 23%. The latest improvements are due to post‐deposition treatments (PDT) with heavy alkalis. This study provides a comprehensive description of the effect of PDT on the chemical and electronic structure of surface and bulk of Cu(In,Ga)Se2. Chemical changes at the surface appear similar, independent of absorber or alkali. However, the effect on the surface electronic structure differs with absorber or type of treatment, although the improvement of the solar cell efficiency is the same. Thus, changes at the surface cannot be the only effect of the PDT treatment. The main effect of PDT with heavy alkalis concerns bulk recombination. The reduction in bulk recombination goes along with a reduced density of electronic tail states. Improvements in open‐circuit voltage appear together with reduced band bending at grain boundaries. Heavy alkalis accumulate at grain boundaries and are not detected in the grains. This behavior is understood by the energetics of the formation of single‐phase Cu‐alkali compounds. Thus, the efficiency improvement with heavy alkali PDT can be attributed to reduced band bending at grain boundaries, which reduces tail states and nonradiative recombination and is caused by accumulation of heavy alkalis at grain boundaries.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.