A method for determination of the 15N/14N ratio of total ammoniacal nitrogen (TAN; ammonium and ammonia) in aqueous solutions was developed, primarily intended for use with soil extracts, which have a high TAN level, e.g. from recently fertilised agricultural soils. Ammonium was converted to ammonia by addition of NaOH, followed by nitrogen isotopic analysis of the headspace by gas chromatography-combustion-isotope ratio mass spectrometry (GC-C-IRMS) where complete separation of TAN from the matrix was not necessary. The ammonia concentration in the gas phase was maximised by increasing the temperature and salt concentration and by decreasing the gas liquid ratio in the headspace vials. Isotopic equilibrium was reached after less than 1 h at 80 degrees C. The measured isotopic ratio was constant for solutions containing 30-200 mM NH4-N, corresponding to 950-7000 ng NH3-N detected with the IRMS. The integrated area response at m/z 28 increased linearly with the ammonium ion concentration in the interval 10-200 mM NH4-N. The fractionation factor between the liquid and gas phases was 1.0054 +/- 0.0007 within the linear range, which is in agreement with values reported in the literature, but with a higher precision. Changes in temperature, gas:liquid ratio or salt concentration did not affect the measured ratio, demonstrating the robustness of the developed method.

No abstract

The use of custom-made solid-phase microextraction (SPME) fibers coated with a perfluorosulfonated ionomer, Nafion, was investigated for nitrogen isotopic analysis of ammonium in aqueous solutions. Aqueous ammonium was converted to ammonia by addition of a base, followed by absorption from the headspace, desorption in the injection port of a gas chromatograph, and analysis by gas chromatography/combustion/isotope ratio mass spectrometry (GC/C/IRMS). Fibers coated with a Nafion tubing were chosen due to a higher fiber-gas distribution constant and a higher Nafion thickness than fibers coated with Nafion solution, both leading to a higher amount of ammonia absorbed at equilibrium. The Nafion membrane-coated fiber absorbed approximately 20 times more than a commercial polydimethylsiloxane (PDMS) fiber. The isotopic fractionation between fiber and gas was 1.0117 +/- 0.0009 (standard deviation, SD, of all measurements) at an initial ammonia gas concentration of 21-210 microM. At 390 microM initial gas concentration it was slightly lower. When sampling from liquid samples, an ammonium concentration of 10 mM was needed to obtain a sufficient amount of ammonia absorbed. Modeling of the absorption at different temperatures showed that the absorption was approximately constant in the temperature range suitable for SPME experiments. Absorption at room temperature was therefore used for simplicity. A pilot study was conducted in which absorption was achieved from a single 9 microL droplet of sample. The preliminary results showed that delta(15)N analysis was possible for only 0.4-0.5 micromol of ammonium with a SD of 0.8 per thousand (n = 5).