This paper proposes a simple, effective, non-scanning method for the visualization of a cell-attached nanointerface. The method uses localized surface plasmon resonance (LSPR) excited homogeneously on a two-dimensional (2D) self-assembled gold-nanoparticle sheet. The LSPR of the gold-nanoparticle sheet provides high-contrast interfacial images due to the confined light within a region a few tens of nanometers from the particles and the enhancement of fluorescence. Test experiments on rat basophilic leukemia (RBL-2H3) cells with fluorescence-labeled actin filaments revealed high axial and lateral resolution even under a regular epifluorescence microscope, which produced higher quality images than those captured under a total internal reflection fluorescence (TIRF) microscope. This non-scanning-type, high-resolution imaging method will be an effective tool for monitoring interfacial phenomena that exhibit relatively rapid reaction kinetics in various cellular and molecular dynamics.

A method of obtaining highly confined, enhanced surface fluorescence imaging is proposed using two-dimensional (2D) silver nanoparticle (AgMy) sheets. This technique is based on the localized surface plasmon resonance excited homogeneously on a 2D silver nanoparticle sheet. The AgMy sheets are fabricated at the air–water interface by self-assembly and transferred onto hydrophobic glass substrates. These sheets can enhance the fluorescence only when the excitation wavelength overlaps with the plasmon resonance wavelength. To confirm the validity of this technique, two separate test experiments are performed. One is the epifluorescence microscope imaging of a quantum dot 2D sheet on the AgMy 2D sheet with a SiO2 spacer layer, where the fluorescence is maximized with the 20 nm SiO2 layer, determined by the Förster resonance energy transfer distances. The second experiment is the imaging of a single fluorescence bead with a total internal reflection fluorescent microscope. We confirmed that the AgMy sheet provides a 4-fold increase in fluorescence with a 160-nm spatial resolution at 30 ms/frame snapshot. The AgMy sheet will be a powerful tool for high sensitivity and high-resolution real time bioimaging at nanointerfaces.

An improved unroofing method enabled the cantilever of an atomic force microscope (AFM) to reach directly into a cell to visualize the intracellular cytoskeletal actin filaments, microtubules, clathrin coats, and caveolae in phosphate-buffered saline (PBS) at a higher resolution than conventional electron microscopy. All of the actin filaments clearly exhibited a short periodicity of approximately 5–6 nm, which was derived from globular actins linked to each other to form filaments, as well as a long helical periodicity. The polarity of the actin filaments appeared to be determined by the shape of the periodic striations. Microtubules were identified based on their thickness. Clathrin coats and caveolae were observed on the cytoplasmic surface of cell membranes. The area containing clathrin molecules and their terminal domains was directly visualized. Characteristic ridge structures located at the surface of the caveolae were observed at high resolution, similar to those observed with electron microscopy (EM). Overall, unroofing allowed intracellular AFM imaging in a liquid environment with a level of quality equivalent or superior to that of EM. Thus, AFMs are anticipated to provide cutting-edge findings in cell biology and histology.

Background: ATP synthase (F 0 F 1 ) is a rotary motor enzyme. Results: F 1 with a short-sized helix-1 in ␤ subunit rotates with half of the normal torque and supports reduced ATP synthesis activity. Conclusion: Helix-1 acts as a "pushrod" to generate torque, and torque-reduced F 0 F 1 retains the catalytic ability of ATP synthesis. Significance: Generation and utilization of the torque are crucial for motor enzymes.

We propose an idea for improving the angular sensitivity of Kretschmann-type surface plasmon resonance (SPR) sensors through the use of high-refractive-index silver nanoparticle (AgNP) sheets on metal substrates. According to Fresnel simulations, the angular sensitivity will be improved threefold by using the multilayered AgNP coating on gold or silver substrates. We confirmed the validity of this method by a model measurement with a SiO2 sputtered film, which has a refractive index similar to that of organic or biological molecules. This simple technique will contribute to realizing a high-sensitivity SPR sensor, especially for the detection of small molecules.

Unroofing, which is the mechanical shearing of a cell to expose the cytoplasmic surface of the cell membrane, is a unique preparation method that allows membrane cytoskeletons to be observed by cryo-electron microscopy, atomic force microscopy, freeze-etching electron microscopy and other methods. Ultrasound and adhesion have been known to mechanically unroof cells. In this study, unroofing using these two means was denoted sonication unroofing and adhesion unroofing, respectively. We clarified the mechanisms by which cell membranes are removed in these unroofing procedures and established efficient protocols for each based on the mechanisms. In sonication unroofing, fine bubbles generated by sonication adhered electrostatically to apical cell surfaces and then removed the apical (dorsal) cell membrane with the assistance of buoyancy and water flow. The cytoplasmic surface of the ventral cell membrane remaining on the grids became observable by this method. In adhesion unroofing, grids charged positively by coating with Alcian blue were pressed onto the cells, thereby tightly adsorbing the dorsal cell membrane. Subsequently, a part of the cell membrane strongly adhered to the grids was peeled from the cells and transferred onto the grids when the grids were lifted. This method thus allowed the visualization of the cytoplasmic surface of the dorsal cell membrane. This paper describes robust, improved protocols for the two unroofing methods in detail. In addition, micro-unroofing (perforation) likely due to nanobubbles is introduced as a new method to make cells transparent to electron beams.

An improved unroofing method consisting of tearing off the cell membrane using an adhesive electron microscopy (EM) grid instead of vitreous ice sectioning (cryo-sectioning) has enabled us to panoramically view the membrane cytoskeleton in its native state with extremely high contrast. Grids pre-treated with Alcian blue were placed on cells, and a portion of the dorsal plasma membrane was transferred onto the grid, which was then floated in buffer solution. These membrane fragments contained sufficient cytoskeleton and were of suitable thickness for observation by cryo-EM. Many actin filaments and microtubules were clearly observed on the cytoplasmic surface of the plasma membrane with extremely high contrast because the soluble components of the cytoplasm flowed out and broke away from the cells. Actin filaments extended in all directions in a smooth contour with little branching. Microtubules spread out as far as 3 µm or more while winding gently in their native state. Upon fixation with 1% glutaraldehyde, however, the microtubules became straight and fragmented. Cryo-EM revealed for the first time a smooth endoplasmic reticulum network beneath the cell membrane in native cells. Clathrin coats and caveolae were also observed on the cytoplasmic surface of the plasma membrane, similar to those seen using freeze-etching replica EM (freeze-etching EM). Unroofing was also useful for immuno-labelling in cryo-EM. Antibody-labelled IQGAP1, one of the effector proteins facilitating the formation of actin filament networks, was localized alongside actin filaments. Freeze-etching EM confirmed the morphological findings of cryo-EM.

Actin filaments, the actin–myosin complex and the actin–tropomyosin complex were observed by a tip-scan atomic force microscope (AFM), which was recently developed by Olympus as the AFM part of a correlative microscope. This newly developed AFM uses cantilevers of similar size as stage-scan AFMs to improve substantially the spatial and temporal resolution. Such an approach has previously never been possible by a tip-scan system, in which a cantilever moves in the x, y and z directions. We evaluated the performance of this developed tip-scan AFM by observing the molecular structure of actin filaments and the actin–tropomyosin complex. In the image of the actin filament, the molecular interval of the actin subunits (∼5.5 nm) was clearly observed as stripes. From the shape of the stripes, the polarity of the actin filament was directly determined and the results were consistent with the polarity determined by myosin binding. In the image of the actin–tropomyosin complex, each tropomyosin molecule (∼2 nm in diameter) on the actin filament was directly observed without averaging images of different molecules. Each tropomyosin molecule on the actin filament has never been directly observed by AFM or electron microscopy. Thus, our developed tip-scan AFM offers significant potential in observing purified proteins and cellular structures at nanometer resolution. Current results represent an important step in the development of a new correlative microscope to observe nm-order structures at an acceptable frame rate (∼10 s/frame) by AFM at the position indicated by the fluorescent dye observed under a light microscope.