No abstract

No abstract

This study is based on a simple, low-cost and a novel approach towards the removal of excess fluoride ions from aqueous solution by absorbing fluoride on porous vaterite calcium carbonate nanoparticles (PVCCNPs) synthesised using ethylene glycol-water soft template method. SEM images clearly show the porous nature of aggregated nanoparticles present in the dry powder. Physicochemical properties of synthesised PVCCNP and fluoride on PVCCNP was characterised further by FTIR, XRD, XRF, EDX, and TGA-DTG. Fluoride removal by PVCCNPs from 100.00 ml of 10.0 mg l −1 NaF solution with 0.500 g of PVCCNPs, determined using a fluoride ion-selective electrode, indicates that around 90% removal is achieved within 1 h thus reducing the level to desired 1 ppm. The pseudo-second order kinetic model has a better fit to describe the adsorption of fluoride on PVCCNP than pseudofirst order model. The Langmuir isotherm model is more appropriate to describe the equilibrium behaviour of the adsorption process, than the Freundlich model. Given that the value of n (Freundlich constant) is greater than 1 (3.07) and R L value is in the range of 0<R L <1 (0.014-0.024) implies that the adsorption process is spontaneous and fluoride ions are favourably adsorbed on PVCCNPs. Langmuir model shows that the maximum adsorption capacity of fluoride is 1.956 mg g −1 . Excess fluoride in drinking waters causes several severe ill-health effects and filter media based on these nanoparticles can be used to remove fluoride down to safe and required levels to tackle these health problems. As such, PVCCNPs-based filter can be designed to remove fluoride in drinking waters. This may be a way for controlling fluorosis and many other diseases associated with excess fluoride present in drinking waters.

No abstract

Dye-sensitized solid-state solar cells (DSSCs) replacing the liquid electrolyte with a p-type semiconductor have been extensively examined to solve the practical problems associated with wet-type solar cells. Here, we report the fabrication of a solid-state solar cell using copper iodide (CuI) as the hole conductor and alkyl-functionalized carbazole dye (MK-2) as the sensitizer. A DSSC sensitized with MK-2 showed a solar-to-electrical power conversion efficiency of 3.33% with a Voc of 496 mV and a Jsc of 16.14 mA cm-2 under AM 1.5 simulated sunlight. The long alkyl chains act as a barrier for charge recombination, and the strong accepting and donating abilities of the cyanoacrylic and carbazole groups, respectively, enhance the absorption of light at a longer wavelength, increasing the short-circuit current density. The efficiency recorded in this work is higher than similar DSSCs based on other hole collectors.

No abstract

Fluorine-doped tin oxide nanorod transparent thin films were fabricated with SnCl4·5H2O, NH4F, and ethylene glycol (EG) using an improved spray pyrolysis deposition technique. The fabricated nanorods showed a low resistance of 15.3 Ω/sq and a good transparency of 70.8%. The nanorods have a higher surface area than the conventionally used thin films.

No abstract