MoS2(1-x) Se2x single-layer films are prepared using a mixture of organic selenium and sulfur precursors as well as a solid molybdenum source. The direct bandgaps are found to scale nearly linearly with composition in the range of 1.87 eV (pure single-layer MoS2 ) to 1.55 eV (pure single-layer MoSe2 ) permitting straightforward bandgap engineering.
Despite its extremely weak intrinsic spin-orbit coupling (SOC), graphene has been shown to acquire considerable SOC by proximity coupling with exfoliated transition metal dichalcogenides (TMDs). Here we demonstrate strong induced Rashba SOC in graphene that is proximity coupled to a monolayer TMD film, MoS 2 or WSe 2 , grown by chemical vapor deposition with drastically different Fermi level positions. Graphene/TMD heterostructures are fabricated with a pickup-transfer technique utilizing hexagonal boron nitride, which serves as a flat template to promote intimate contact and therefore a strong interfacial interaction between TMD and graphene as evidenced by quenching of the TMD photoluminescence. We observe strong induced graphene SOC that manifests itself in a pronounced weak anti-localization (WAL) effect in the graphene magnetoconductance. The spin relaxation rate extracted from the WAL analysis varies linearly with the momentum scattering time and is independent of the carrier type. This indicates a dominantly Dyakonov-Perel spin relaxation mechanism caused by the induced Rashba SOC. Our analysis yields a Rashba SOC energy of ~1.5 meV in graphene/WSe 2 and ~0.9 meV in graphene/MoS 2 , respectively. The nearly electron-hole symmetric nature of the induced Rashba SOC provides a clue to possible underlying SOC mechanisms.
Transition metal dichalcogenides (TMDs) have emerged as a new class of two-dimensional materials that are promising for electronics and photonics. To date, optoelectronic measurements in these materials have shown the conventional behavior expected from photoconductors such as a linear or sublinear dependence of the photocurrent on light intensity. Here, we report the observation of a new regime of operation where the photocurrent depends superlinearly on light intensity. We use spatially resolved photocurrent measurements on devices consisting of CVD-grown monolayers of TMD alloys spanning MoS2 to MoSe2 to show the photoconductive nature of the photoresponse, with the photocurrent dominated by recombination and field-induced carrier separation in the channel. Time-dependent photoconductivity measurements show the presence of persistent photoconductivity for the S-rich alloys, while photocurrent measurements at fixed wavelength for devices of different alloy compositions show a systematic decrease of the responsivity with increasing Se content associated with increased linearity of the current-voltage characteristics. A model based on the presence of different types of recombination centers is presented to explain the origin of the superlinear dependence on light intensity, which emerges when the nonequilibrium occupancy of initially empty fast recombination centers becomes comparable to that of slow recombination centers.
Lithium niobate is the archetypical ferroelectric material and the substrate of choice for numerous applications including surface acoustic wave radio frequencies devices and integrated optics. It offers a unique combination of substantial piezoelectric and birefringent properties, yet its lack of optical activity and semiconducting transport hamper application in optoelectronics. Here we fabricate and characterize a hybrid MoS2/LiNbO3 acousto-electric device via a scalable route that uses millimetre-scale direct chemical vapour deposition of MoS2 followed by lithographic definition of a field-effect transistor structure on top. The prototypical device exhibits electrical characteristics competitive with MoS2 devices on silicon. Surface acoustic waves excited on the substrate can manipulate and probe the electrical transport in the monolayer device in a contact-free manner. We realize both a sound-driven battery and an acoustic photodetector. Our findings open directions to non-invasive investigation of electrical properties of monolayer films.
MoS 2 is a highly interesting material, which exhibits a crossover from an indirect band gap in the bulk crystal to a direct gap for single layers. Here, we perform a direct comparison between large-area MoS 2 films grown by chemical vapor deposition (CVD) and MoS 2 flakes prepared by mechanical exfoliation from mineral bulk crystal. Raman spectroscopy measurements show differences between the in-plane and out-of-plane phonon mode positions in CVD-grown and exfoliated MoS 2 . Photoluminescence (PL) mapping reveals large regions in the CVD-grown films that emit strong PL at room-temperature, and low-temperature PL scans demonstrate a large spectral shift of the A exciton emission as a function of position. Polarization-resolved PL measurements under near-resonant excitation conditions show a strong circular polarization of the PL, corresponding to a valley polarization.
We demonstrate bandgap tuning of a single-layer MoS2 film on SiO2/Si via substitution of its sulfur atoms by selenium through a process of gentle sputtering, exposure to a selenium precursor, and annealing. We characterize the substitution process both for S/S and S/Se replacement. Photoluminescence and, in the latter case, X-ray photoelectron spectroscopy provide direct evidence of optical band gap shift and selenium incorporation, respectively. We discuss our experimental observations, including the limit of the achievable bandgap shift, in terms of the role of stress in the film as elucidated by computational studies, based on density functional theory. The resultant films are stable in vacuum, but deteriorate under optical excitation in air.
The chemical vapor deposition (CVD) of molybdenum disulfide (MoS2) single-layer films onto periodically poled lithium niobate is possible while maintaining the substrate polarization pattern. The MoS2 growth exhibits a preference for the ferroelectric domains polarized "up" with respect to the surface so that the MoS2 film may be templated by the substrate ferroelectric polarization pattern without the need for further lithography. MoS2 monolayers preserve the surface polarization of the "up" domains, while slightly quenching the surface polarization on the "down" domains as revealed by piezoresponse force microscopy. Electrical transport measurements suggest changes in the dominant carrier for CVD MoS2 under application of an external voltage, depending on the domain orientation of the ferroelectric substrate. Such sensitivity to ferroelectric substrate polarization opens the possibility for ferroelectric nonvolatile gating of transition metal dichalcogenides in scalable devices fabricated free of exfoliation and transfer.
The growth of micron-scale single-layer MoS 2 islands is seeded and distributed at high fidelity by means of a regular array of micron-scale holes that extend through the oxide layer of a 300 nm SiO 2 /Si substrate. Low coverages exhibit individual sub-micron MoS 2 islands directly adjacent to the seed positions. At moderate coverage the seed holes are encircled by merged MoS 2 islands, whose overall shape and internal grain boundaries reveal coalescence out of several initial crystallites. Seeded islands are strictly monolayer in height, non-overlapping and they offer high photoluminescence as well as conventional Raman signatures.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.