Realization of ideal molecular sieves, in which the larger gas molecules are completely blocked without sacrificing high adsorption capacities of the preferred smaller gas molecules, can significantly reduce energy costs for gas separation and purification and thus facilitate a possible technological transformation from the traditional energy-intensive cryogenic distillation to the energy-efficient, adsorbent-based separation and purification in the future. Although extensive research endeavors are pursued to target ideal molecular sieves among diverse porous materials, over the past several decades, ideal molecular sieves for the separation and purification of light hydrocarbons are rarely realized. Herein, an ideal porous material, SIFSIX-14-Cu-i (also termed as UTSA-200), is reported with ultrafine tuning of pore size (3.4 Å) to effectively block ethylene (C H ) molecules but to take up a record-high amount of acetylene (C H , 58 cm cm under 0.01 bar and 298 K). The material therefore sets up new benchmarks for both the adsorption capacity and selectivity, and thus provides a record purification capacity for the removal of trace C H from C H with 1.18 mmol g C H uptake capacity from a 1/99 C H /C H mixture to produce 99.9999% pure C H (much higher than the acceptable purity of 99.996% for polymer-grade C H ), as demonstrated by experimental breakthrough curves.

The first sorbent with high CO2 selectivity and poor water affinity addresses need for trace CO2 remediation in confined spaces.

Fine-tuning of HUMs through pillar substitution can significantly enhance trace CO sorption performance and stability. The resulting materials, exemplified by the new material TIFSIX-3-Ni, [Ni(pyrazine)(TiF)], are shown through temperature programmed desorption experiments to remove trace quantities of CO from moist gas mixtures.

A nonporous square lattice (sql) coordination network [Co(bipy)2(NCS)2]n (sql-1-Co-NCS) exhibits recyclable switching induced by CO2. The sorption isotherms are stepped with moderate hysteresis, temperature controlled and saturation uptake is fixed. Such switching, which has rarely been observed, offers the promise of exceptional working capacity for gas storage.

We report water vapor sorption studies on four primitive cubic, pcu, pillared square grid materials: SIFSIX-1-Cu, SIFSIX-2-Cu-i, SIFSIX-3-Ni, and SIFSIX-14-Cu-i. SIFSIX-1-Cu, SIFSIX-3-Ni, and SIFSIX-14-Cu-i were observed to exhibit negative water vapor adsorption at ca. 40-50% relative humidity (RH). The negative adsorption is attributed to a water-induced phase transformation from a porous pcu topology to nonporous sql and sql-c* topologies. Whereas the phase transformation of SIFSIX-1-Cu was found to be irreversible, SIFSIX-3-Ni could be regenerated by heating and can therefore be recycled. In contrast, SIFSIX-2-Cu-i, which is isostructural with SIFSIX-14-Cu-i, exhibited a type V isotherm and no phase change. SIFSIX-2-Cu-i was observed to retain both structure and gas sorption properties after prolonged exposure to heat and humidity. The hydrolytic stability of SIFSIX-2-Cu-i in comparison to its structural counterparts is attributed to structural features and therefore offers insight into the design of hydrolytically stable porous materials.

In the synthesis of complex oxides, solid-state metathesis provides low-temperature reactions where product selectivity can be achieved through simple changes in precursor composition. The influence of precursor structure, however, is less understood in solid-state synthesis. Here we present the ternary metathesis reaction (LiMnO 2 + YOCl → YMnO 3 + LiCl) to target two yttrium manganese oxide products, hexagonal and orthorhombic YMnO 3 , when starting from three different LiMnO 2 precursors. Using temperature-dependent synchrotron X-ray and neutron diffraction, we identify the relevant intermediates and temperature regimes of reactions along the pathway to YMnO 3. Manganesecontaining intermediates undergo a charge disproportionation into a reduced Mn(II,III) tetragonal spinel and oxidized Mn(III,IV) cubic spinel, which lead to hexagonal and orthorhombic YMnO 3 , respectively. Density functional theory calculations confirm that the presence of Mn(IV) caused by a small concentration of cation vacancies (∼2.2%) in YMnO 3 stabilizes the orthorhombic polymorph over the hexagonal. Reactions over the course of 2 weeks yield o-YMnO 3 as the majority product at temperatures below 600°C, which supports an equilibration of cation defects over time. Controlling the composition and structure of these defect-accommodating intermediates provides new strategies for selective synthesis of complex oxides at low temperatures.

We report a 2-fold interpenetrated primitive cubic (pcu) network X-pcu-5-Zn, [Zn 2 (DMTDC) 2 -(dpe)] (H 2 DMTDC = 3,thiophene-2,5-dicarboxylic acid, dpe = 1,2-di(4-pyridyl)ethylene), that exhibits reversible switching between an as-synthesized "open" phase, X-pcu-5-Zn-α, and two nonporous or "closed" polymorphs, X-pcu-5-Zn-β and X-pcu-5-Zn-γ. There are two unusual features of X-pcu-5-Zn. The first relates to its sorption properties, which reveal that the α form exhibits high CO 2 uptake (ca. 255 cm 3 /g at 195 K) via reversible closed-to-open switching (type F-IV isotherm) of the type desirable for gas and vapor storage; there are only three other reports of porous materials that combine these two features. Second, we could only isolate the β form by activation of the CO 2 loaded α form and it persists through multiple CO 2 adsorption/desorption cycles. We are unaware of a new polymorph having been isolated in such a manner. That the observed phase changes of X-pcu-5-Zn-α occur in single-crystal-to-single-crystal fashion enabled structural characterization of the three forms; γ is a coordination isomer of α and β, both of which are based upon "paddlewheel" clusters.

[Co(bipy)(bptz)(NCS)2]n, a new mixed-linker sql coordination network, exhibits high xylene adsorption capacity and high xylene selectivity over ethylbenzene (>5).