The viability of the human probiotic strains Lactobacillus paracasei NFBC 338 and Bifidobacterium sp. strain UCC 35612 in reconstituted skim milk was assessed by confocal scanning laser microscopy using the LIVE/DEAD BacLight viability stain. The technique was rapid (<30 min) and clearly differentiated live from heat-killed bacteria. The microscopic enumeration of various proportions of viable to heat-killed bacteria was then compared with conventional plating on nutrient agar. Direct microscopic enumeration of bacteria indicated that plate counting led to an underestimation of bacterial numbers, which was most likely related to clumping. Similarly, LIVE/DEAD BacLight staining yielded bacterial counts that were higher than cell numbers obtained by plate counting (CFU) in milk and fermented milk. These results indicate the value of the microscopic approach for rapid viability testing of such probiotic products. In contrast, the numbers obtained by direct microscopic counting for Cheddar cheese and spray-dried probiotic milk powder were lower than those obtained by plate counting. These results highlight the limitations of LIVE/DEAD BacLight staining and the need to optimize the technique for different strain-product combinations. The minimum detection limit for in situ viability staining in conjunction with confocal scanning laser microscopy enumeration was approximately 10(8) bacteria/ml (equivalent to approximately 10(7) CFU/ml), based on Bifidobacterium sp. strain UCC 35612 counts in maximum-recovery diluent.

No abstract

S. Confocal scanning laser microscopy (CSLM) methods were developed to identify fat and protein in cheeses, milk chocolate and milk powders. Various fluorescent probes were assessed for their ability to label fat or protein in selected food products in situ. Dual labelling of fat and protein was made possible by using mixtures of probes. Selected probes and probe mixtures were then used to study (a) structure development of Mozzarella cheese during manufacture and ripening, and (b) the distribution of fat and protein in milk chocolate made with milk powders containing varying levels of free fat. Microstructural changes in the protein and fat phases of Mozzarella cheese were observed at each major step in processing. Aggregation of renneted micelles occurred during curd formation ; this was followed by amalgamation of the para-casein into linear fibres during plasticization. Following storage, the protein phase of the Mozzarella became more continuous ; entrapping and isolating fat globules. Chocolate made with a high free-fat spray-dried powder blend showed a homogeneous fat distribution, similar to that of chocolate made with roller-dried milk. Chocolate made with whole milk powder containing 10 g free fat\100 g fat showed a non-homogeneous fat distribution with some fat occluded within milk protein particles. These differences in fat distribution were related to Casson yield value and Casson viscosity of the chocolates.

No abstract

No abstract

No abstract

No abstract

No abstract