No abstract

Background Implantable cardiovascular therapeutic devices, while hemodynamically effective, remain limited by thrombosis. A driver of device-associated thrombosis is shear-mediated platelet activation (SMPA). Underlying mechanisms of SMPA, as well as useful biomarkers able to detect and discriminate mechanical versus biochemical platelet activation, are poorly defined. We hypothesized that SMPA induces a differing pattern of biomarkers compared with biochemical agonists. Methods Gel-filtered human platelets were subjected to mechanical activation via either uniform constant or dynamic shear; or to biochemical activation by adenosine diphosphate (ADP), thrombin receptor-activating peptide 6 (TRAP-6), thrombin, collagen, epinephrine, or arachidonic acid. Markers of platelet activation (P-selectin, integrin αIIbβ3 activation) and apoptosis (mitochondrial membrane potential, caspase 3 activation, and phosphatidylserine externalization [PSE]) were examined using flow cytometry. Platelet procoagulant activity was detected by chromogenic assay measuring thrombin generation. Contribution of platelet calcium flux in SMPA was tested employing calcium chelators, ethylenediaminetetraacetic acid (EDTA), and BAPTA-AM. Results Platelet exposure to continuous shear stress, but not biochemical agonists, resulted in a dramatic increase of PSE and procoagulant activity, while no integrin αIIbβ3 activation occurred, and P-selectin levels remained barely elevated. SMPA was associated with dissipation of mitochondrial membrane potential, but no caspase 3 activation was observed. Shear-mediated PSE was significantly decreased by chelation of extracellular calcium with EDTA, while intracellular calcium depletion with BAPTA-AM had no significant effect. In contrast, biochemical agonists ADP, TRAP-6, arachidonic acid, and thrombin were potent inducers of αIIbβ3 activation and/or P-selectin exposure. This differing pattern of biomarkers seen for SMPA for continuous uniform shear was replicated in platelets exposed to dynamic shear stress via circulation through a ventricular assist device-propelled circulatory loop. Conclusion Elevated shear stress, but not biochemical agonists, induces a differing pattern of platelet biomarkers—with enhanced PSE and thrombin generation on the platelet surface. This differential biomarker phenotype of SMPA offers the potential for early detection and discrimination from that mediated by biochemical agonists.

Objective: Mechanical circulatory support has emerged as lifesaving therapy for patients with advanced heart failure. However, mechanical circulatory support remains limited by a paradoxical coagulopathy accompanied by both thrombosis and bleeding. While mechanisms of mechanical circulatory support thrombosis are increasingly defined, mechanical circulatory support-related bleeding, as related to shear-mediated alteration of platelet function, remains poorly understood. We tested the hypothesis that platelet exposure to elevated shear stress, while a defined prothrombotic activator of platelets, coordinately induces downregulation of key platelet adhesion receptors GPIb (glycocalicin)-IX-V, α IIb β 3 , and P-selectin, thus decreasing platelet functional responsiveness to physiological stimuli. Approach and Results: Human gel-filtered platelets were exposed to continuous or pulsatile shear stress in vitro. Surface expression of platelet receptors and platelet-derived microparticle generation were quantified by flow cytometry. Shedding of receptor soluble forms were assessed via ELISA, and platelet aggregation was measured by optical aggregometry. We demonstrate that platelet exposure to elevated shear stress led to a downregulation of GPIb and α IIb β 3 receptors on platelets with a progressive increase in the generation of platelet-derived microparticles expressing elevated levels of α IIb β 3 and GPIb on their surface. No shear-mediated shedding of GPIb and β 3 subunit soluble fragments was detected. Soluble P-selectin was extensively shed from platelets, while surface expression of P-selectin on platelets and microparticles was not significantly altered by shear. Shear-mediated downregulation of GPIb, α IIb β 3 , and P-selectin on platelets was associated with an evident decrease of platelet aggregatory response induced by ADP and TRAP 6 (thrombin receptor activating peptide 6). Conclusions: Our data clearly indicate that accumulation of shear stress, consistent with supraphysiologic conditions characterizing device-supported circulation (1) induces adequate platelet degranulation, yet (2) causes downregulation of primary platelet adhesion receptors via ejection of receptor-enriched platelet-derived microparticles, thus mechanistically limiting platelet activation and the aggregatory response.

Regenerative medicine, particularly decellularization-recellularization methods via whole-organ tissue engineering, has been increasingly studied due to the growing donor organ shortage. Though numerous decellularization protocols exist, the ideal decellularization protocol for optimal recellularization is unclear. This study was performed to optimize existing heart decellularization protocols and compare current methods using the detergents SDS (sodium dodecyl sulfate), Triton X-100, OGP (octyl β-D-glucopyranoside), and CHAPS (3-[(3-cholamidopropyl) dimethylammonio]-1-propanesulfonate) through retrograde aortic perfusion via aortic cannulation of a whole porcine heart. The goal of decellularization is to preserve extracellular matrix integrity and architecture, which was analyzed in this study through histology, microscopy, DNA analysis, hydroxyproline content analysis, materials analysis and angiography. Effective decellularization was determined by analyzing the tissue organization, geometry, and biological properties of the resultant extracellular matrix scaffold. Using these parameters, optimal decellularization was achieved between 90 and 120 mmHg pressure with 3% SDS as a detergent. Relevance for patients: This study provides important information about whole heart decellularization, which will ultimately contribute to heart bioengineering. Keywords:porcine heart decellularization acellularization organ bioscaffold vascular

No abstract

No abstract

A critical component of tissue engineering is the ability to functionally replace native tissue stroma. Electrospinning is a technique capable of forming fibrous constructs with a high surface area for increased cell−material interaction and enhanced biocompatibility. However, physical and biological properties of electrospun scaffolds are limited by design controllability on a macroscale. We developed a methodology for generating electrospun scaffolds with defined patterns and topographic features to influence physical properties and biological interactions. Five unique design electrospinning target collectors were fabricated to allow for generation of defined polymeric scaffold patterns including lines, sinusoids, squares, zigzags, and solid. Poly(lacticco-glycolic) acid was electrospun under identical conditions utilizing these varied targets, and constructs generated were examined as to their physical configuration, mechanical and chemical properties, and their ability to foster vascular smooth muscle cell adhesion and retention at 24 h. Modifying collector designs led to significant differences in fiber target coverage ranging from 300 mm 2 for solid (100% of the target area) to 217.8 mm 2 for lines (72.6% of the target area). Measured fiber excess, residual open area, and contact angle (hydrophobicity) followed the same trend as fiber target coverage with respect to the collector pattern: lines > sinusoids > squares > zigzags > solid. Similarly, the line design allowed for the greatest cell adhesion and retention (258 ± 31 cells), whereas solid exhibited the lowest (150 ± 15 cells); p < 0.05. There was a strong direct correlation of cell adhesion to construct residual open area (R 2 = 0.94), normalized fiber excess (R 2 = 0.99), and fiber grammage (R 2 = 0.72), with an inverse relationship to fiber target coverage (R 2 = 0.94). Our results demonstrate the ability to utilize patterned collectors for modifying macroscopic and microscopic electrospun scaffold features, which directly impact cell adhesion and retention, offering translational utility for designing specific tissue constructs.

No abstract