No abstract

Mimicking soft tissue mechanical properties and the high conductivity required for electrical transmission in the native spinal cord is critical in nerve tissue regeneration scaffold designs. However, fabricating scaffolds of high conductivity, tissue-like mechanical properties, and excellent biocompatibility simultaneously remains a great challenge. Here, a soft, highly conductive, biocompatible conducting polymer hydrogel (CPH) based on a plant-derived polyphenol, tannic acid (TA), cross-linking and doping conducting polypyrrole (PPy) chains is developed to explore its therapeutic efficacy after a spinal cord injury (SCI). The developed hydrogels exhibit an excellent electronic conductivity (0.05–0.18 S/cm) and appropriate mechanical properties (0.3–2.2 kPa), which can be achieved by controlling TA concentration. In vitro, a CPH with a higher conductivity accelerated the differentiation of neural stem cells (NSCs) into neurons while suppressing the development of astrocytes. In vivo, with relatively high conductivity, the CPH can activate endogenous NSC neurogenesis in the lesion area, resulting in significant recovery of locomotor function. Overall, our findings evidence that the CPHs without being combined with any other therapeutic agents have stimulated tissue repair following an SCI and thus have important implications for future biomaterial designs for SCI therapy.

Email address: sharell@126.com (R. Shi). AbstractInfection is the major reason for guided tissue regeneration/guided bone regeneration (GTR/GBR) membrane failure in clinical application. In this work, we developed GTR/GBR membranes with localized drug delivery function to prevent infection by electrospinning of poly(ε-caprolactone) (PCL) and gelatin blended with metronidazole (MNA). Acetic acid (HAc) was introduced to improve the miscibility of PCL and gelatin to fabricate homogeneous hybrid nanofiber membranes. The effects of the addition of HAc and the MNA content (0,1,5,10,20,30, and 40 wt.% of polymer) on the properties of the membranes were investigated. The membranes showed good mechanical properties, appropriate biodegradation rate and barrier function. The controlled and sustained release of MNA from the membranes significantly prevented the colonization of anaerobic bacteria. Cells could adhere to and proliferate on the membranes without cytotoxicity until the MNA content reached 30%.Subcutaneous implantation in rabbits for 8 months demonstrated that MNA-loaded membranes evoked a less severe inflammatory response depending on the dose of MNA than bare membranes. The biodegradation time of the membranes was appropriate for tissue regeneration. These results indicated the potential for using MNA-loaded PCL/gelatin electrospun membranes as anti-infective GTR/GBR membranes to optimize clinical application of GTR/GBR strategies.

No abstract

Guided tissue regeneration/guided bone regeneration membranes with sustained drug delivery were developed by electrospinning drug-loaded halloysite clay nanotubes doped into poly(caprolactone)/gelatin microfibers. Use of 20 wt % nanotube content in fiber membranes allowed for 25 wt % metronidazole drug loading in the membrane. Nanotubes with a diameter of 50 nm and a length of 600 nm were aligned within the 400 nm diameter electrospun fibers, resulting in membranes with doubling of tensile strength along the collector rotating direction. The halloysite-doped membranes acted as barriers against cell ingrows and have good biocompatibility. The metronidazole-loaded halloysite nanotubes incorporated in the microfibers allowed for extended release of the drugs over 20 days, compared to 4 days when directly admixed into the microfibers. The sustained release of metronidazole from the membranes prevented the colonization of anaerobic Fusobacteria, while eukaryotic cells could still adhere to and proliferate on the drug-loaded composite membranes. This indicates the potential of halloysite clay nanotubes as drug containers that can be incorporated into electrospun membranes for clinical applications.

Among the multiple components of propolis, flavonoids contribute greatly to the antioxidant activities of propolis. Flavonoids mainly exist in the form of sugar-conjugated derivatives. Quercetin glycosides represent the predominant flavonoid fraction in propolis. In this work, density functional theory (DFT) calculations were applied to analyze the antioxidative properties of quercetin and its glucosides in the gas and in the liquid phase (ethanol, water). Three main antioxidant mechanisms, hydrogen atom transfer (HAT), single electron transfer followed by proton transfer (SET-PT) and sequential proton loss electron transfer (SPLET) were used to analyze the antioxidative capacity of the investigated compounds. Solvent effects dominantly affect SET-PT and SPLET. Thus, the thermodynamically preferred mechanism can be altered. HAT and SPLET are the thermodynamically dominant mechanisms in gas and solvent phases, respectively. Therefore, in the gas phase, the sequence of the antioxidative capacity is similar with the bond dissociation enthalpy values: quercetin > quercetin-5-O-glucoside > quercetin-7-O-glucoside > quercetin-3-O-glucoside > quercetin-3′-O-glucoside > quercetin-4′-O-glucoside. While, in the solvent phases, the sequence is similar with the proton affinity values: quercetin-4′-O-glucoside > quercetin-5-O-glucoside > quercetin > quercetin-3-O-glucoside > quercetin-7-O-glucoside > quercetin-3′-O-glucoside. OH groups in B-ring and C-ring contribute mainly to the antioxidative activities of quercetin and glucosides compared with A-ring.

Until now there has been no fundamental theory applicable for biodegradable metals (BMs). First, this paper optimizes the definition of BMs given in 2014. Second, the dual criteria of biodegradability and biocompatibility are proposed for BMs, and all metallic elements in the periodic table with accessible data are screened on the basis of these criteria. Regarding biodegradability, electrode potential, reactivity series, galvanic series, Pilling–Bedworth ratio, and Pourbaix diagrams are all adopted as parameters to classify the degradable and nondegradable nature of a material, especially in a physiological environment. Considering the biocompatibility at different levels, cellular biocompatibility, tissue biocompatibility, and human/clinical related biocompatibility parameters are put forward to comprehensively evaluate the biosafety of BMs. Third, for the material design of BMs, mechanical properties, chemical properties, physical properties and biological properties should be considered and balanced to guarantee that the degradation behavior of BMs match well with a tissue regeneration/repair procedure as the function of time and spatial location. Besides the selected metallic elements, some nonmetallic elements are selected as suitable alloying elements for BMs. Finally, five classification/research directions for future BMs are proposed: biodegradable pure metals, crystalline alloys, bulk metallic glasses, high entropy alloys, and metal matrix composites.

Clinically, methicillin-resistant Staphylococcus aureus (MRSA) biofilm infection inevitably induces the failure of bone implants. Herein, a hydrophilic and viscous hydrogel of poly­(vinyl alcohol) modified with chitosan, polydopamine, and NO release donor was formed on a red phosphorus nanofilm deposited on a titanium implant (Ti-RP/PCP/RSNO). Under the irradiation of near-infrared light (NIR), peroxynitrite (•ONOO–) was formed by the reaction between the released NO and superoxide (•O2 –) produced by the RP nanofilm. Specifically, we revealed the antibacterial mechanism of the ONOO– against the MRSA biofilm. In addition, osteogenic differentiation was promoted and inflammatory polarization was regulated by the released NO without NIR irradiation through upregulating the expression of Opn and Ocn genes and TNF-α. The MRSA biofilm was synergistically eradicated by •ONOO–, hyperthermia, and •O2– under NIR irradiation as well as the immunoreaction of the M1 polarization. The in vivo results also confirmed the excellent osteogenesis and biofilm eradication by released NO from the RP/PCP/RSNO system under NIR irradiation, indicating the noninvasive tissue reconstruction of MRSA-infected tissues through phototherapy and immunotherapy.