No abstract

No abstract

No abstract

The efficiency of 2,2-Dimethoxy-2-phenylacetophenone (DMPA) for the photopolymerization of methacrylate monomers in thick sections was assessed. DMPA is an efficient photoinitiator for thick sections (%2 mm) because a fast reaction and high conversions are obtained with concentrations as low as 0.25 wt % DMPA. The polymerization rate increased when the DMPA content increased from 0.125 wt % to 0.25 wt %. However, the conversion versus irradiation time profiles in resins containing 0.25 wt % or 0.5 wt % DMPA were similar. This is attributed to the screening effect caused by excessive levels of DMPA. In addition, the consumption of DMPA under UV irradiation was accompanied by the appearance of light absorbing photoproducts. Because the absorbing species nearest to the light source absorb part of it, the light fails to reach the deeper layers of the sample. The overall effect of light screening is a reduced photoinitiation rate and double bond conversion along the irradiation path. This effect was compensated by the use of irradiation sources of higher intensity; which increased the initiation rate by increasing the production of primary radicals. DMPA is colorless and it does not require the presence of amine as coinitiator. These properties make DMPA attractive as photoinitiator of dental composites.

No abstract

No abstract

No abstract

The present work is concerned with applications of a kinetic model for free-radical polymerization of a polymethylmethacrylate-based bone cement. Autocatalytic behavior at the first part of the reaction as well as a diffusion control phenomenon near vitrification are described by the model. Comparison of theoretical computations with experimental measurements for the temperature evolution during batch casting demonstrated the capacity of the proposed model to represent the kinetic behavior of the polymerization reaction. Temperature evolution and monomer conversion were simulated for the cure of the cement in molds made of different materials. The maximum monomer conversion fraction was markedly influenced by the physical properties of the mold material. The unreacted monomer acts as a plasticizer that influences the mechanical behavior of the cement. Hence, the same cement formulation cured in molds of different materials may result in different mechanical response because of the differences in the amounts of residual monomer. Standardization of the mold type to prepare specimens for the mechanical characterization of bone cements is recommended. Theoretical prediction of temperature evolution during hip replacement indicated that for cement thickness lower than 6 mm the peak temperature at the bone-cement interface was below the limit stated for thermal injury (50 degrees C for more than 1 min). The use of thin cement layers is recommended to diminish the risk of thermal injury; however, it is accompanied by an increase in the amount of unreacted monomer present in the cured material.