We pushed direct green laser diodes towards longer wavelengths at 524–532 nm based on improvements of epitaxial design and material quality on c-plane GaN substrate. Mounted ridge laser diodes show significant performance improvement in cw operation. For 524 nm laser, wall plug efficiency up to 2.3% at 50 mW optical output power is achieved. In pulse mode operation we demonstrate broad-area test lasers with an emission wavelength of 531.7 nm. Nonpolar and polar substrates are compared with respect to indium content in InGaN quantum wells. The limiting factors for achieving longer wavelengths and better performance of green lasers are discussed from this viewpoint.

In this paper we investigate the waveguiding (WG) of direct green InGaN laser diodes grown on c-planeGaNsubstrates. The problem of parasitic modes emerges due to the reduced refractive index difference between the GaN waveguide and AlGaN cladding layers for green compared to blue emitting laser diodes. We discuss several approaches to avoid substrate modes. We investigate different materials and designs for optimized WG of green InGaN laser diodes using a 1D transfer matrix simulation tool

The challenges of green InGaN lasers are discussed concerning material quality as a function of InGaN composition, quantum well design and piezoelectrical fields. Investigations of polar quantum well designs and comparison with simulated nonpolar structures demonstrate that the quality of the indium rich layers is more important than the influence of interface charges. A high risk of dark spots at high In concentrations of 26-33% is observed. Small changes of about 2% of In significant reduce or increase the quantity and size of dark luminescence areas. Polar designs are a trade-off between low indium concentrations of 4 nm wide quantum wells and high overlap of electrons and holes in 2 nm narrow designs. Furthermore, our single quantum wells have less non-radiative defects than indium rich multiquantum well structures. Optimized active layer designs and the material qualities enable us to get green InGaN lasers on c-plane substrates for cw operation at 515-524 nm and wall plug efficiencies of 3.9-2.3%. Slope efficiency of 0.3-0.4 W/A allows up to now highest optical output power of 50 mW.

Mobile laser projection is of great commercial interest. Today, a key parameter in embedded mobile applications is the optical output power and the wall plug efficiency of blue and green lasers. We report on improvements of the performance of true blue riedge waveguide InGaN lasers at 452nm with cw-output power up to 800mW in overstress and mono mode operation up to 500mW in a temperatures range of 20°C to 80°C. We succeeded in high and almost temperature independent wall plug efficiencies >20% at stable output power levels from 200 to 500mW in cw-operation. Due to several improvements of our blue laser diodes we now estimate life times is in the order of 40khrs for 80mW output power in cw-operation at 40°C. Additional overstress degradation tests at power levels up to 200mW show a strong dependency of lifetime with output power. Furthermore, we present pioneering results on true green InGaN laser diodes on c-plane GaN-substrates. The technological challenge is to achieve In-rich InGaN-quantum wells with sufficiently high material quality for lasing. We investigated the competing recombination processes below laser threshold like nonradiative defect recombination by electro-optical measurements, such confirming that low defect densities are essential for stimulated emission. A model for alloy fluctuations in In-rich InGaN-MQWs based on spectral and time resolved photoluminescence measurements yields potential fluctuations in the order of E0=57meV for our blue laser diodes. To get a closer insight into the physics of direct green InGaN-Laser we investigated the inhomogeneous broadening of experimentally measured gain curves via Hakki-Paoli-measurements in comparison to calculated gain spectra based on microscopic theory showing the importance of strong LO-phonon coupling in this material system. Investigations of current dependent gain measurements and calculations yield a factor of 2 higher inhomogeneous broadening for our green lasers than for our blue laser diodes on c-plane GaN. Based on the improvements of the material quality and design we demonstrate true green InGaN-Laser in cw-operation at 522nm with more than 80mW output power on c-plane GaN. The combination of low laser threshold ~60-80mA, high slope efficiency ~0.65W/A and low operating voltage 6.9-6.4V of our green monomode RWG-Laser results in a high wall plug efficiency of 5-6% in a temperature range of 20-60°C

We present a blue InGaN research and development superluminescent light-emitting diode (SLED) that is suitable for picoprojection. The SLED reaches an output power of >100 mW with a peak wavelength of 443 nm and a spectral bandwidth of >2.6 nm as well as a single-mode far-field driven in cw mode at 25 °C. In order to figure out an optimized waveguide design, which enables such a high output power at lowest operation current, we compare the performance of diodes with curved and tilted shaped ridges in detail, using the lasing threshold current as a criterion for lasing or superluminescence, respectively.