Summary Background: Focused electron beam induced deposition (FEBID) is a direct-writing technique with nanometer resolution, which has received strongly increasing attention within the last decade. In FEBID a precursor previously adsorbed on a substrate surface is dissociated in the focus of an electron beam. After 20 years of continuous development FEBID has reached a stage at which this technique is now particularly attractive for several areas in both, basic and applied research. The present topical review addresses selected examples that highlight this development in the areas of charge-transport regimes in nanogranular metals close to an insulator-to-metal transition, the use of these materials for strain- and magnetic-field sensing, and the prospect of extending FEBID to multicomponent systems, such as binary alloys and intermetallic compounds with cooperative ground states. Results: After a brief introduction to the technique, recent work concerning FEBID of Pt–Si alloys and (hard-magnetic) Co–Pt intermetallic compounds on the nanometer scale is reviewed. The growth process in the presence of two precursors, whose flux is independently controlled, is analyzed within a continuum model of FEBID that employs rate equations. Predictions are made for the tunability of the composition of the Co–Pt system by simply changing the dwell time of the electron beam during the writing process. The charge-transport regimes of nanogranular metals are reviewed next with a focus on recent theoretical advancements in the field. As a case study the transport properties of Pt–C nanogranular FEBID structures are discussed. It is shown that by means of a post-growth electron-irradiation treatment the electronic intergrain-coupling strength can be continuously tuned over a wide range. This provides unique access to the transport properties of this material close to the insulator-to-metal transition. In the last part of the review, recent developments in mechanical strain-sensing and the detection of small, inhomogeneous magnetic fields by employing nanogranular FEBID structures are highlighted. Conclusion: FEBID has now reached a state of maturity that allows a shift of the focus towards the development of new application fields, be it in basic research or applied. This is shown for selected examples in the present review. At the same time, when seen from a broader perspective, FEBID still has to live up to the original idea of providing a tool for electron-controlled chemistry on the nanometer scale. This has to be understood in the sense that, by providing a suitable environment during the FEBID process, the outcome of the electron-induced reactions can be steered in a controlled way towards yielding the desired composition of the products. The development of a FEBID-specialized surface chemistry is mostly still in its infancy. Next to application development, it is this aspect that will likely be a guiding light for the future development of the field of focused electron beam induced deposition.

We have fabricated Pt-containing granular metals by focused electron beam induced deposition from the (CH3)3CH3C5H4Pt precursor gas. The granular metals are made of platinum nanocrystallites embedded in a carbonaceous matrix. We have exposed the asgrown nanocomposites to low energy electron beam irradiation and we have measured the Finally, by means of AFM measurements we observe a reduction of the volume of the samples with increasing irradiation time which we attribute to the removal of carbon molecules.

The lifetimes of electrons at the interface between 3,4,9,10-perylene-tetracarboxylic acid dianhydride (PTCDA) and Ag(111) have been studied by means of time- and angle-resolved two-photon photoemission. We observe a dispersing unoccupied state 0.6 eV above the Fermi level with an effective electron mass of 0.39m{e} at the Gamma[over ] point. The short lifetime of 54 fs is indicative of a large penetration of the wave function into the metal. Supported by model calculations this interface state is interpreted as predominantly arising from an upshift of the occupied Shockley surface state of the clean metal due to the interaction with the PTCDA overlayer.

We present temperature-dependent conductivity data obtained on a sample set of nanogranular Pt-C with finely tuned intergrain tunnel coupling strength g. For samples in the strong-coupling regime g > g(C), characterized by a finite conductivity for T→0, we find a logarithmic behavior at elevated temperatures and a crossover to a √T behavior at low temperatures over a wide range of coupling strengths g(C) ≈ 0.25 < g ≤ 3. The experimental observation for g > 1 is in very good agreement with recent theoretical findings on ordered granular metals in three spatial dimensions. The results indicate a validity of the predicted universal conductivity behavior that goes beyond the immediate range of the approach used in the theoretical derivation.

This paper introduces a new methodology for the fabrication of strain-sensor elements for MEMS and NEMS applications based on the tunneling effect in nano-granular metals. The strain-sensor elements are prepared by the maskless lithography technique of focused electron-beam-induced deposition (FEBID) employing the precursor trimethylmethylcyclopentadienyl platinum [MeCpPt(Me)3]. We use a cantilever-based deflection technique to determine the sensitivity (gauge factor) of the sensor element. We find that its sensitivity depends on the electrical conductivity and can be continuously tuned, either by the thickness of the deposit or by electron-beam irradiation leading to a distinct maximum in the sensitivity. This maximum finds a theoretical rationale in recent advances in the understanding of electronic charge transport in nano-granular metals.