Atomic layer deposition (ALD) of high-quality gadolinium oxide thin films is achieved using Gd(iPrCp)3 and O2 plasma. Gd2O3 growth is observed from 150 to 350 °C, though the optical properties of the film improve at higher temperature. True layer-by-layer ALD growth of Gd2O3 occurred in a relatively narrow window of temperature and precursor dose. A saturated growth rate of 1.4 Å/cycle was observed at 250 °C. As the temperature increases, high-quality films are deposited, but the growth mechanism appears to become CVD-like, indicating the onset of precursor decomposition. At 250 °C, the refractive index of the film is stable at ∼1.80 regardless of other deposition conditions, and the measured dispersion characteristics are comparable to those of bulk Gd2O3. XPS data show that the O/Gd ratio is oxygen deficient at 1.3, and that it is also very hygroscopic. The plasma etching rate of the ALD Gd2O3 film in a high-density helicon reactor is very low. Little difference is observed in etching rate between Cl2 and pure Ar plasmas, suggesting that physical sputtering dominates the etching. A threshold bias power exists below which etching does not occur; thus it may be possible to etch a metal gate material and stop easily on the Gd2O3 gate dielectric. The Gd2O3 film has a dielectric constant of about 16, exhibits low C–V hysteresis, and allows a 50 × reduction in gate leakage compared to SiO2. However, the plasma enhanced atomic layer deposition (PE-ALD) process causes formation of an ∼1.8 nm SiO2 interfacial layer, and generates a fixed charge of −1.21 × 1012 cm−2, both of which may limit use of PE-ALD Gd2O3 as a gate dielectric.
Hafnium oxide films deposited on silicon wafers from TEMAH and O 2 plasma showed saturation at growth rate per cycle of 1.1Å, which was independent of the plasma conditions. The same film deposited thermally using H 2 O as the oxidant saturated at 0.8Å/cycle. By varying the plasma exposure time the compositional ratio of [O]/[Hf], as calculated from RBS measurements, changed from 2.0 to 2.13. The carbon content in plasma HfO 2 films was < 2% compared to 8% in thermal HfO 2 films.Titanium nitride films deposited on silicon wafers from TiCl 4 and N 2 / H 2 plasma showed saturation at 0.33Å/cycle, which was independent of plasma conditions and a resistivity of <170µΩ cm at 350°C deposition temperature. The stoichiometry of the films can be changed from being slightly nitrogen rich to titanium rich by varying the N:H ratios in the plasma and limiting the amount of nitrogen available for the reaction. The chlorine impurity in TiN varied according to plasma exposure time (2.6% to 1.2%) and N 2 :H 2 gas ratio in the plasma, with a corresponding change in resistivity (200µΩ -150µΩ).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.