In this study, we show for the first time that the separation efficiency of a pillar array column under pressure-driven liquid chromatography (LC) conditions can be improved using a separation channel with low-dispersion turns. The pillar array column was fabricated by reactive ion etching of a silicon substrate. With the low-dispersion-turn geometry, a column with a length and width of 110 mm and 400 microm, respectively, could be fabricated on a 20 x 20 mm microchip. Under nonretained conditions, the solute bands obtained for fluorescent compounds remained almost unchanged even after passing through the low-dispersion turns; however, significant skewing of the solute bands was observed in the case of constant-radius turns. Two coumarin dyes were well resolved under reversed-phase conditions, and a maximum theoretical plate number of 8000 was obtained. Successful separation of the fluorescent derivatives of six amino acids was achieved in 140 s. These results indicated that the separation efficiency of microchip chromatography could be significantly improved using a long separation channel with low-dispersion turns.

A fully automated amino acid analyzer using NBD-F (4- fluoro-7-nitro-2,1,3-benzoxadiazole) as a fluorescent derivatization reagent was developed. The whole analytical process was fully automated from derivatization, injection to HPLC separation and quantitation. The derivatization reaction conditions were re-evaluated and optimized. Amino acids were derivatized by NBD-F for 40 min at room temperature in the borate buffer (pH 9.5). The derivatives were separated within 100 min and fluorometrically detected at 540 nm with excitation at 470 nm. The detection limits for amino acids were in the range of 2.8-20 fmol. The calibration curves were linear over the range of 20 fmol to 20 pmol on column with the correlation coefficients of 0.999. The coefficients of variation were less than 5% at 3 pmol injection for all amino acids. Amino acids in rat plasma were determined by the proposed HPLC method.

No abstract

No abstract

No abstract

The derivatization of the reduced-form thiols with SBD-F (7-fluoro-2,1,3-benzoxadiazole-4-sulfonate) and ABD-F (4-aminosulfonyl-7-fluoro-2,1,3-benzoxadiazole) was studied. The yields of the derivatives of the reduced-form thiols (cysteine, homocysteine, reduced-form glutathione) with SBD-F at 60 degrees C for 45 min in the borate buffer (pH 9.3) were significantly decreased in the presence of the oxidized-form thiols (cystine, homocystine, oxidized-form glutathione) because of the thiol exchange reaction between the reduced-form and the oxidized-form thiols. The use of ABD-F at low temperature enabled the suppression of these thiol exchange reactions, and the recommended conditions were below 5 degrees C for 90 min in borate buffer (pH 9.3). These results suggest that ABD-F is a preferred derivatization reagent for the accurate determination of the reduced-form thiols in samples containing the oxidized-form thiols. In addition, it was also suggested that the derivatization of the reduced-form thiols should also be performed at low temperature when derivatization reagents such as o-phthalaldehyde (OPA) and monobromobimane (BrB) are used.

No abstract

No abstract