With the continuing shift of industrial activities in developing and transition economies, which often have poor regulation (and weak self-regulation of industries), additional global challenges regarding POPs and other contaminated sites may be expected. In this respect, a comprehensive application of the "polluter pays principle" in these countries will also be a key to facilitate the clean-up of contaminated areas and the prevention of future contaminated sites. The threats and challenges of contaminated sites and the high costs of securing/remediating the problems highlight the need for a comprehensive approach based upon integrated pollution prevention and control. If applied to all polluting (and potentially polluting) industrial sectors around the globe, such an approach will prove to be both the cheapest and most sustainable way to underpin the development of industries in developing and transition economies.

No abstract

Quantification of bioaccumulative contaminants in biota is time and cost-intensive and the required extensive cleanup steps make it selective toward targeted chemical groups. Therefore tissue extracts prepared for chemical analysis are not amenable to assess the combined effects of unresolved complex mixtures. Passive equilibrium sampling with polydimethylsiloxane (PDMS) has the potential for unbiased sampling of mixtures, and the PDMS extracts can be directly dosed into cell-based bioassays. The passive sampling approach was tested by exposing PDMS to lipid-rich tissue (dugong blubber; 85% lipid) spiked with a known mixture of hydrophobic contaminants (five congeners of tetra- to octachloro-dibenzo-p-dioxins). The equilibrium was attained within 24 h. Lipid-PDMS partition coefficients (Klip-PDMS) ranged from 20 to 38, were independent of hydrophobicity, and within the range of those previously measured for organochlorine compounds. To test if passive sampling can be combined with bioanalysis without the need for chemical cleanup, spiked blubber-PDMS extracts were dosed into the CAFLUX bioassay, which specifically targets dioxin-like chemicals. Small quantities of lipids coextracted by the PDMS were found to affect the kinetics in the regularly applied 24-h bioassay; however, this effect was eliminated by a longer exposure period (72 h). The validated method was applied to 11 unspiked dugong blubber samples with known (native) dioxin concentrations. These results provide the first proof of concept for linking passive sampling of lipid-rich tissue with cell-based bioassays, and could be further extended to other lipid rich species and a wider range of bioanalytical end points.

No abstract

To simultaneously quantify and profile the complex mixture of short-, median-, and long-chain CPs (SCCPs, MCCPs, and LCCPs) in Australian sewage sludge, we applied and further validated a recently developed novel instrumental technique, using quadrupole time-of-flight high resolution mass spectrometry running in the negative atmospheric pressure chemical ionization mode (APCI-qTOF-HRMS). Without using an analytical column the cleaned extracts were directly injected into the qTOF-HRMS followed by quantification of the CPs by a mathematical algorithm. The recoveries of the four SCCP, MCCP and LCCP-spiked sewage sludge samples ranged from 86 to 123%. This APCI-qTOF-HRMS method is a fast and promising technique for routinely measuring SCCPs, MCCPs, and LCCPs in sewage sludge. Australian sewage sludge was dominated by MCCPs with concentrations ranging from 542 to 3645 ng/g dry weight (dw). Lower SCCPs concentrations (<57–1421 ng/g dw) were detected in the Australian sewage sludge, which were comparable with the LCCPs concentrations (116–960 ng/g dw). This is the first time that CPs were reported in Australian sewage sludge. The results of this study gives a first impression on the distribution of the SCCPs, MCCPs, and LCCPs in Australia wastewater treatment plants (WWTPs).