This paper reports on the design and experimental verification of a new class of thin-film (250 nm) superhighfrequency laterally-vibrating piezoelectric microelectromechanical (MEMS) resonators suitable for the fabrication of narrow-band MEMS filters operating at frequencies above 3 GHz. The device dimensions have been opportunely scaled both in the lateral and vertical dimensions to excite a contourextensional mode of vibration in nanofeatures of an ultra-thin (250 nm) AlN film. In this first demonstration, 2-port resonators vibrating up to 4.5 GHz have been fabricated on the same die and attained electromechanical coupling, kt^2, in excess of 1.5%. These devices are employed to synthesize the highest frequency MEMS filter (3.7 GHz) based on AlN contour-mode resonator technology ever reported. This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of the University of Pennsylvania's products or services. Internal or personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution must be obtained from the IEEE by writing to pubs-permissions@ieee.org. By choosing to view this document, you agree to all provisions of the copyright laws protecting it.This journal article is available at ScholarlyCommons: http://repository.upenn.edu/ese_papers/522 0885-3010/$25.00 © 2010 IEEE 38 IEEE TransacTIons on UlTrasonIcs, FErroElEcTrIcs, and FrEqUEncy conTrol, vol. 57, no. 1, JanUary 2010Abstract-This paper reports on the design and experimental verification of a new class of thin-film (250 nm) superhigh-frequency laterally-vibrating piezoelectric microelectromechanical (MEMS) resonators suitable for the fabrication of narrow-band MEMS filters operating at frequencies above 3 GHz. The device dimensions have been opportunely scaled both in the lateral and vertical dimensions to excite a contourextensional mode of vibration in nanofeatures of an ultra-thin (250 nm) AlN film. In this first demonstration, 2-port resonators vibrating up to 4.5 GHz have been fabricated on the same die and attained electromechanical coupling, k t 2 , in excess of 1.5%. These devices are employed to synthesize the highest frequency MEMS filter (3.7 GHz) based on AlN contour-mode resonator technology ever reported.

This paper reports on the design and experimental verification of Super High Frequency (SHF) laterally vibrating NanoElctroMechanical (NEMS) resonators. For the first time, AlN piezoelectric nanoresonators with multiple frequencies of operation ranging between 5 and 10 GHz have been fabricated on the same chip and attained the highest f-Q product (4.6E12 Hz) ever reported in AlN contour-mode devices. These piezoelectric NEMS resonators are the first of their class to demonstrate on-chip sensing and actuation of nanostructures without the need of cumbersome or power consuming excitation and readout systems. This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of the University of Pennsylvania's products or services. Internal or personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution must be obtained from the IEEE by writing to pubs-permissions@ieee.org. By choosing to view this document, you agree to all provisions of the copyright laws protecting it.This conference paper is available at ScholarlyCommons: http://repository.upenn.edu/ese_papers/493

A nanoenabled gravimetric chemical sensor prototype based on the large scale integration of single-stranded DNA (ss-DNA) decorated single-walled carbon nanotubes (SWNTs) as nanofunctionalization layer for aluminum nitride contour-mode resonant microelectromechanical (MEM) gravimetric sensors has been demonstrated. The capability of two distinct single strands of DNA bound to SWNTs to enhance differently the adsorption of volatile organic compounds such as dinitroluene (simulant for explosive vapor) and dymethyl-methylphosphonate (simulant for nerve agent sarin) has been verified experimentally. Different levels of sensitivity (17.3 and 28 KHz μm2/fg) due to separate frequencies of operation (287 and 450 MHz) on the same die have also been shown to prove the large dynamic range of sensitivity attainable with the sensor. The adsorption process in the ss-DNA decorated SWNTs does not occur in the bulk of the material, but solely involves the surface, which permits to achieve 50% recovery in less than 29 s.

This paper reports on the first demonstration of a gravimetric chemical sensor based on direct integration of Single Wall Carbon Nanotubes (SWNTs) grown by Chemical Vapor Deposition (CVD) on AlN ContourMode MicroElectroMechanical (MEMS) resonators. In this first prototype the ability of SWNTs to readily adsorb volatile organic chemicals has been combined with the capability of AlN Contour-Mode MEMS resonator to provide for different levels of sensitivity due to separate frequencies of operation on the same die. Two devices with resonance frequencies of 287 MHz and 442 MHz have been exposed to different concentrations of DMMP in the range from 80 to 800 ppm. Values of mass sensitivity equal to 1.8 KHz/pg and 2.65 KHz/pg respectively have been measured. This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of the University of Pennsylvania's products or services. Internal or personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution must be obtained from the IEEE by writing to pubs-permissions@ieee.org. By choosing to view this document, you agree to all provisions of the copyright laws protecting it. Author(s)Matteo

This paper reports on the design and experimental verification of a new class of ultra-thin-film (250 nm) aluminum nitride (AlN) microelectromechanical system (MEMS) contour mode resonators (CMRs) suitable for the fabrication of ultra-sensitive gravimetric sensors. The device thickness was opportunely scaled in order to increase the mass sensitivity, while keeping a constant frequency of operation. In this first demonstration the resonance frequency of the device was set to 178 MHz and a mass sensitivity as high as 38.96 KHz⋅μm2/fg was attained. This device demonstrates the unique capability of the CMR-S technology to decouple resonance frequency from mass sensitivity.

This paper reports on the design and experimental verification of a new class of nanoscale gravimetric sensors based on ultra-thin-film AlN Contour-Mode Resonant Sensor (CMR-S) functionalized with ss-DNA and connected to a chip-based self-sustaining oscillator loop (fabricated in the ON Semiconductor 0.5 μm CMOS process) for direct frequency read-out. The 220 MHz oscillator based on the ultra-thin AlN CMR-S exhibits an Allan Variance of ∼20 Hz for 100 ms gate time. The sensor affinity for the adsorption of volatile organic chemicals such as 2,6 dinitroluene (DNT, a simulant for explosive vapors) is enhanced by functionalizing the top gold electrode of the device with a thiol-terminated single stranded DNA sequence (Thiol -5' CTT CTG TCT TGA TGT TTG TCA AAC 3') enabling the detection of concentrations as low as 1.5 part per billion (ppb). Disciplines Electrical and Electronics CommentsSuggested Citation: Matteo Rinaldi, Brandon Duick, Chiara Zuniga, Chengjie Zuo, and Gianluca Piazza.

This paper reports on the first demonstration of a 457 MHz AlN Piezolectric Resonant Nanochannel (PRN) for biosensing applications in liquid environment. A novel process consisting of 7 lithographic steps was developed to fabricate the PRN. The new resonant device shows an unchanged value of the electromechanical coupling, k t 2 (about 0.8 %), whether the channel is filled with air or water and a quality factor, Q, in liquid of approximately 170.

This paper reports on the demonstration of a new class of ultra-thin (250 nm thick) super high frequency (SHF) AlN piezoelectric two-port resonators and filters. A thickness field excitation scheme was employed to excite a higher order contour extensional mode of vibration in an AlN nano plate (250 nm thick) above 3 GHz and synthesize a 1.96 GHz narrow-bandwidth channel-select filter. The devices of this work are able to operate over a frequency range from 1.9 to 3.5 GHz and are employed to synthesize the highest frequency MEMS filter based on electrically self-coupled AlN contour-mode resonators. Very narrow bandwidth (0 .35%) and high off-band rejection (~ 35 dB) were achieved at an operating frequency of 1.96 GHz. This first prototype showed insertion loss of 11 dB, which can be improved to few dB if parasitic elements are eliminated or device capacitance is increased. This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of the University of Pennsylvania's products or services. Internal or personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution must be obtained from the IEEE by writing to pubs-permissions@ieee.org. By choosing to view this document, you agree to all provisions of the copyright laws protecting it.This conference paper is available at ScholarlyCommons: http://repository.upenn.edu/ese_papers/523 ULTRA-THIN SUPER HIGH FREQUENCY TWO-PORT ALN CONTOUR-MODE RESONATORS AND FILTERSM. Rinaldi * , C. Zuniga, C. Zuo and G. Piazza University of Pennsylvania, Philadelphia, Pennsylvania, USA ABSTRACT This paper reports on the demonstration of a new class of ultra-thin (250 nm thick) Super High Frequency (SHF) AlN piezoelectric two-port resonators and filters. A thickness field excitation scheme was employed to excite a higher order contour extensional mode of vibration in an AlN nano plate (250 nm thick) above 3 GHz and synthesize a 1.96 GHz narrow-bandwidth channel-select filter. The devices of this work are able to operate over a frequency range from 1.9 to 3.5 GHz and are employed to synthesize the highest frequency MEMS filter based on electrically self-coupled AlN contour-mode resonators. Very narrow bandwidth (∼ 0.35%) and high off-band rejection (∼ 35 dB) were achieved at an operating frequency of 1.96 GHz. This first prototype showed insertion loss of 11 dB, which can be improved to few dB if parasitic elements are eliminated or device capacitance is increased.