No abstract

Sucker rods are a key element in certain oil-extraction processes as they link the motor group on the surface with the pumps located downhole. During the transport from the production site toward the extraction well, these components are prone to corrosion. A hydrophobic carbon nanotube (CNT) coating, deposited via electrophoretic deposition (EPD), is proposed as a protective layer, shielding the rods from harsh environmental conditions. Three different coating systems are considered and thoroughly characterized (depending on the additive that is used to deposit the CNT), namely, magnesium nitrate hexahydrate (Mg-Nit), triethylamine (TEA), and a duplex coating (DD). The latter presents an approach which combines the advantages of each additive, mechanical stability from Mg-Nit and strong hydrophobicity from TEA (near superhydrophobic). The former coatings are further processed to overcome their individual shortcomings, resulting in an increase in the coating's stability for TEA coating, as well as transforming the hydrophilic Mg-Nit surface into a hydrophobic surface.

No abstract

Copper is extensively used in a wide range of industrial and daily-life applications, varying from heat exchangers to electrical wiring. Although it is protected from oxidation by its native oxide layer, when subjected to harsh environmental conditionssuch as in coastal regionsthis metal can rapidly degrade. Therefore, in this study, we analyze the potential use of carbon nanoparticle coatings as protective barriers due to their intrinsic hydrophobic wetting behavior. The nanocarbon coatings were produced via electrophoretic deposition on Cu platelets and characterized via scanning electron microscopy, confocal laser scanning microscopy, and sessile drop test; the latter being the primary focus since it provides insights into the wetting behavior of the produced coatings. Among the measured coatings, graphite flakes, graphene oxide, and carbon nanotube (CNT) coatings showed superhydrophobic behavior. Based on their wetting behavior, and specifically for electrical applications, CNT coatings showed the most promising results since these coatings do not significantly impact the substrate’s electrical conductivity. Although CNT agglomerates do not affect the wetting behavior of the attained coatings, the coating’s thickness plays an important role. Therefore, to completely coat the substrate, the CNT coating should be sufficiently thickabove approximately 1 μm.