Environmental context Total organofluorine and known fluorosurfactants were quantified in 11 aqueous film forming foams (AFFFs) used to extinguish fires in Ontario, Canada, and one commercial AFFF product. By comparing the concentrations of known fluorosurfactants with the total organofluorine, less than 10% of the fluorosurfactants were identified in half of the samples. Our biodegradation experiment with one of the fluorosurfactants using waste-water treatment plant sludge showed that it was a potential source of perfluoroalkyl carboxylates, which are persistent in the environment. Abstract Eleven aqueous film forming foam (AFFF) samples that were used to extinguish fires in Ontario, Canada, and one commercial product, were analysed using a variety of analytical techniques to obtain structural information and quantities of organofluorine and known perfluoroalkyl and polyfluoroalkyl substances (PFASs). The NMR spectra of the foams distinguished the fluorosurfactants that were synthesised by either electrochemical fluorination or telomerisation. Total organofluorine content was quantified using total organofluorine–combustion ion chromatography (TOF-CIC), which revealed that the samples contained from 475 to 18 000µgFmL–1. The common AFFF component 6 : 2 fluorotelomermercaptoalkylamido sulfonate (FTSAS) was quantified by liquid chromatography tandem mass spectrometry (LC-MS/MS) together with perfluoroalkane sulfonates (PFSAs), perfluoroalkyl carboxylates (PFCAs) and fluorotelomer sulfonates (FTSAs); in five samples, 6 : 2 FTSAS was present in concentrations greater than 1000µgmL–1. By comparing the concentrations of these quantifiable fluorochemicals with the total organofluorine content, it was evident that in half of the AFFF samples, less than 10% of the fluorochemicals were identified; in two of the samples, perfluorooctane sulfonate (PFOS) accounted for ~50% of the total organofluorine content. Our degradation experiment with 6 : 2 FTSAS using waste-water treatment plant sludge showed that 6 : 2 FTSAS was a potential source of FTSAs, fluorotelomer alcohols and PFCAs in the environment.

In this critical review, the progress in catalytic asymmetric synthesis of beta-amino acids is discussed, covering the literature since 2002. The review treats transition metal catalysis, organocatalysis and biocatalysis and covers the most important synthetic methods, such as hydrogenation, the Mannich reaction and conjugate additions (160 references).

A new method for the synthesis of beta(3)-amino acids is presented. Phthalimide protected allylic amines are oxidized under Wacker conditions selectively to aldehydes using PdCl(2) and CuCl or Pd(MeCN)(2)Cl(NO(2)) and CuCl(2) as complementary catalyst systems. The aldehydes are produced in excellent yields and exhibit a large substrate scope. Beta-amino acids and alcohols are synthesized by oxidation or reduction and subsequent deprotection.

Abstract3‐Methylaspartate ammonia‐lyase (MAL) catalyzes the reversible amination of mesaconate to give both (2S,3S)‐3‐methylaspartic acid and (2S,3R)‐3‐methylaspartic acid as products. The deamination mechanism of MAL is likely to involve general base catalysis, in which a catalytic base abstracts the C3 proton of the respective stereoisomer to generate an enolate anion intermediate that is stabilized by coordination to the essential active‐site MgII ion. The crystal structure of MAL in complex with (2S,3S)‐3‐methylaspartic acid suggests that Lys331 is the only candidate in the vicinity that can function as a general base catalyst. The structure of the complex further suggests that two other residues, His194 and Gln329, are responsible for binding the C4 carboxylate group of (2S,3S)‐3‐methylaspartic acid, and hence are likely candidates to assist the MgII ion in stabilizing the enolate anion intermediate. In this study, the importance of Lys331, His194, and Gln329 for the activity and stereoselectivity of MAL was investigated by site‐directed mutagenesis. His194 and Gln329 were replaced with either an alanine or arginine, whereas Lys331 was mutated to a glycine, alanine, glutamine, arginine, or histidine. The properties of the mutant proteins were investigated by circular dichroism (CD) spectroscopy, kinetic analysis, and 1H NMR spectroscopy. The CD spectra of all mutants were comparable to that of wild‐type MAL, and this indicates that these mutations did not result in any major conformational changes. Kinetic studies demonstrated that the mutations have a profound effect on the values of kcat and kcat/KM; this implicates Lys331, His194 and Gln329 as mechanistically important. The 1H NMR spectra of the amination and deamination reactions catalyzed by the mutant enzymes K331A, H194A, and Q329A showed that these mutants have strongly enhanced diastereoselectivities. In the amination direction, they catalyze the conversion of mesaconate to yield only (2S,3S)‐3‐methylaspartic acid, with no detectable formation of (2S,3R)‐3‐methylaspartic acid. The results are discussed in terms of a mechanism in which Lys331, His194, and Gln329 are involved in positioning the substrate and in formation and stabilization of the enolate anion intermediate.

No abstract

An approach is described for the synthesis of aromatic alpha- and beta-amino acids that uses phenylalanine aminomutase to catalyze a highly enantioselective addition of ammonia to substituted cinnamic acids. The reaction has a broad scope and yields substituted alpha- and beta-phenylalanines with excellent enantiomeric excess. The regioselectivity of the conversion is determined by substituents present at the aromatic ring. A box model for the enzyme active site is proposed, derived from the influence of the hydrophobicity of substituents on the enzyme affinity toward various substrates.

The gene encoding aspartate ammonia lyase (aspB) from Bacillus sp. YM55‐1 has been cloned and overexpressed, and the recombinant enzyme containing a C‐terminal His6 tag has been purified to homogeneity and subjected to kinetic characterization. Kinetic studies have shown that the His6 tag does not affect AspB activity. The enzyme processes L‐aspartic acid, but not D‐aspartic acid, with a Km of ≈15 mM and a kcat of ≈40 s−1. By using this recombinant enzyme in the reverse reaction, a set of four N‐substituted aspartic acids were prepared by the Michael addition of hydroxylamine, hydrazine, methoxylamine, and methylamine to fumarate. Both hydroxylamine and hydrazine were found to be excellent substrates for AspB. The kcat values are comparable to those observed for the AspB‐catalyzed addition of ammonia to fumarate (≈90 s−1), whereas the Km values are only slightly higher. The products of the enzyme‐catalyzed addition of hydrazine, methoxylamine, and methylamine to fumarate were isolated and characterized by NMR spectroscopy and HPLC analysis, which revealed that AspB catalyzes all the additions with excellent enantioselectivity (>97 % ee). Its broad nucleophile specificity and high catalytic activity make AspB an attractive enzyme for the enantioselective synthesis of N‐substituted aspartic acids, which are interesting building blocks for peptide and pharmaceutical synthesis as well as for peptidomimetics.

The monosaccharides glucose, fructose, and xylose were subjected to hydrothermal carbonization in aqueous solution at temperatures of 180, 220, and 250 °C for different operating times (30 min to 16 h). Here, 68% to 78% of the organic carbon was converted into hydrochar at 220 °C with glucose and fructose as feedstock, whereas hydrothermal treatment of xylose did not result in significant hydrochar formation under these conditions. The main topic of this contribution was the identification of stable organic products in the process water in the molecular mass range between 120 and 300 Da by means of GC-MS analysis using several derivatization agents. Special attention was paid to polar OH- and COOH-functionalized compounds. The overwhelming majority of identified organic compounds had cyclic structures of which a prominent group included hydroxylated benzofurans. However, the combined yield of products, which might be potential substrates for liquid biofuels, turned out very low.