Phenothiazine derivatives substituted in the 2 and 10 positions belong to a big group of tricyclic aromatic compounds.

Three simple spectrophotometric methods have been described for the assay of olanzapine in its pure and pharmaceutical formulations. The direct method (A) is based on the drug oxidation with excess of N-bromosuccinimide in acidic medium and the two indirect methods (B and C) are based on the oxidation of the drug with excess of Nbromosuccinimide and cerium(IV)sulfate, followed by the reaction of the unconsumed oxidants with celestine blue. The calibration graphs were linear over the range 10 -120 μg mL -1 (method A), 0.5 -6.0 μg mL -1 (method B) and 0.6 -3.0 μg mL -1 (method C). After validation, the proposed methods were successfully applied to assay of olanzapine in its commercial tablets with mean percentage recoveries of 101.23 ± 0.10, 96 ± 0.10 and 94 ± 0.04%. The mechanism of olanzapine oxidation with N-bromosuccinimide was also proposed.

No abstract

In recent years, the remains of chemical substances in water environments, referred to as emerging organic contaminations, have been more and more often studied by analysts. This work shows the possibility of using a boron-doped diamond electrode to determine low concentration levels of remains of pharmaceuticals in environmental samples. The study focused on selected biocides from the group of azole fungicides (itraconazole and posaconazole) and was performed using quick and sensitive electrochemical methods. The cyclic voltammetry method was used in order to determine the properties of these compounds, whereas analytical characterization was performed using square wave voltammetry. The work involved the specification of the optimum electrooxidation conditions of the selected fungicides, their comparative characterization, and the development of a new, sensitive methods of itraconazole and posaconazole assay. The proposed procedures allowed us to determine itraconazole in the range from 7.9 × 10−8 to 1.2 × 10−6 moL·L−1 and posaconazole in the range from 5.7 × 10−8 to 8.44 × 10−7 moL·L−1. The relative standard deviation of the measurements did not exceed 5.85%. The developed procedures were successfully used to determine itraconazole and posaconazole concentration in water samples and the assay recovery was between 93.5% and 102.8%.

No abstract