Wheat is an important dietary source of zinc (Zn) and other mineral elements in many countries. Dietary Zn deficiency is widespread, especially in developing countries, and breeding (genetic biofortification) through the HarvestPlus programme has recently started to deliver new wheat varieties to help alleviate this problem in South Asia. To better understand the potential of wheat to alleviate dietary Zn deficiency, this study aimed to characterise the baseline effects of genotype (G), site (E), and genotype by site interactions (GxE) on grain Zn concentration under a wide range of soil conditions in India. Field experiments were conducted on a diverse panel of 36 Indian-adapted wheat genotypes, grown on a range of soil types (pH range 4.5–9.5), in 2013–14 (five sites) and 2014–15 (six sites). Grain samples were analysed using inductively coupled plasma-mass spectrometry (ICP-MS). The mean grain Zn concentration of the genotypes ranged from 24.9–34.8 mg kg-1, averaged across site and year. Genotype and site effects were associated with 10% and 6% of the overall variation in grain Zn concentration, respectively. Whilst G x E interaction effects were evident across the panel, some genotypes had consistent rankings between sites and years. Grain Zn concentration correlated positively with grain concentrations of iron (Fe), sulphur (S), and eight other elements, but did not correlate negatively with grain yield, i.e. no yield dilution was observed. Despite a relatively small contribution of genotype to the overall variation in grain Zn concentration, due to experiments being conducted across many contrasting sites and two years, our data are consistent with reports that biofortifying wheat through breeding is likely to be effective at scale given that some genotypes performed consistently across diverse soil types. Notably, all soils in this study were probably Zn deficient and interactions between wheat genotypes and soil Zn availability/management (e.g. the use of Zn-containing fertilisers) need to be better-understood to improve Zn supply in food systems.
In bread wheat, QTL interval mapping was conducted for nine important drought responsive agronomic traits. For this purpose, a doubled haploid (DH) mapping population derived from Kukri/Excalibur was grown over three years at four separate locations in India, both under irrigated and rain-fed environments. Single locus analysis using composite interval mapping (CIM) allowed detection of 98 QTL, which included 66 QTL for nine individual agronomic traits and 32 QTL, which affected drought sensitivity index (DSI) for the same nine traits. Two-locus analysis allowed detection of 19 main effect QTL (M-QTL) for four traits (days to anthesis, days to maturity, grain filling duration and thousand grain weight) and 19 pairs of epistatic QTL (E-QTL) for two traits (days to anthesis and thousand grain weight). Eight QTL were common in single locus analysis and two locus analysis. These QTL (identified both in single- and two-locus analysis) were distributed on 20 different chromosomes (except 4D). Important genomic regions on chromosomes 5A and 7A were also identified (5A carried QTL for seven traits and 7A carried QTL for six traits). Marker-assisted recurrent selection (MARS) involving pyramiding of important QTL reported in the present study, together with important QTL reported earlier, may be used for improvement of drought tolerance in wheat. In future, more closely linked markers for the QTL reported here may be developed through fine mapping, and the candidate genes may be identified and used for developing a better understanding of the genetic basis of drought tolerance in wheat.
Spot blotch is a major foliar disease of wheat caused by Bipolaris sorokiniana in warm and humid environments of the world including South Asian countries. In India, it has a larger impact in Indo-Gangetic plains of the country. Therefore, the present study was undertaken to phenotype a mapping population at different hot spots of India and to detect quantitative trait loci (QTL) for resistance to spot blotch in wheat. For this study, 209 single seed descent (SSD) derived F, F, F recombinant inbred lines (RILs) of the cross 'Sonalika' (an Indian susceptible cultivar)/'BH 1146' (a Brazilian resistant cultivar) were assessed for spot blotch resistance at two hot spot locations (Coochbehar and Kalyani) for three years and for two years under controlled conditions in the polyhouse (Karnal). The population showed large variation in spot blotch reaction for disease severity in all the environments indicating polygenic nature of the disease. Microsatellite markers were used to create the linkage maps. Joint and/or individual year analysis by composite interval mapping (CIM) and likelihood of odds ratio (LOD) >2.1, detected two consistent QTLs mapped on chromosome 7BL and 7DL and these explained phenotypic variation of 11.4 percent and 9.5 percent over the years and locations, respectively. The resistance at these loci was contributed by the parent 'BH 1146' and shown to be independent of plant height and earliness. Besides, association of some agro-morphological traits has also been observed with percent disease severity. These identified genomic regions may be used in future wheat breeding programs through marker assisted selection for developing spot blotch resistant cultivars.
A set of thirty-six wheat cultivars were grown for two consecutive years under low and high nitrogen conditions. The interactions of cultivars with different environmental factors were shown to be highly significant for most of the studied traits, suggesting the presence of wider genetic variability which may be utilized for the genetic improvement of desired trait(s). Three cultivars, i.e., RAJ 4037, DBW 39 and GW 322, were selected based on three selection indices, i.e., tolerance index (TOL), stress susceptibility index (SSI), and yield stability index (YSI), while two cultivars, HD 2967 and MACS 6478, were selected based on all four selection indices which were common in both of the study years. According to Kendall’s concordance coefficient, the consistency of geometric mean productivity (GMP) was found to be highest (0.778), followed by YSI (0.556), SSI (0.472), and TOL (0.200). Due to the high consistency of GMP followed by YSI and SSI, the three selection indices could be utilized as a selection tool in the identification of high-yielding genotypes under low nitrogen conditions. The GMP and YSI selection indices had a positive and significant correlation with grain yield, whereas TOL and SSI exhibited a significant but negative correlation with grain yield under both high and low nitrogen conditions in both years. The common tolerant genotypes identified through different selection indices could be utilized as potential donors in active breeding programs to incorporate the low nitrogen tolerant genes to develop high-yielding wheat varieties for low nitrogen conditions. The study also helps in understanding the physiological basis of tolerance in high-yielding wheat genotypes under low nitrogen conditions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.