Biosorption on lignocellulosic wastes and by-products has been identified as a proper alternative to the existing technologies applied for toxic metal ion and dye removal from wastewater streams. This paper deals with utilization of typical low cost wastes and by-products produced in different food agricultural and agro-industries as biosorbent and reviews the current state of studies on a wide variety of cheap biosorbents in natural and modified forms. The efficiency of each biosorbent has been also discussed with respect to the operating conditions (e.g. temperature, hydraulic residence time, initial metal concentration, biosorbent particle size and its dosage), chemical modification on sorption capacity and preparation methods, as well as thermodynamics and kinetics.
A continuous fixed-bed study was carried out utilising a breakthrough biosorbent, specifically multi-metal binding biosorbent (MMBB) for removing cadmium, copper, lead and zinc. The effect of operating conditions, i.e. influent flow rate, metal concentration and bed depth was investigated at pH 5.5±0.1 for a synthetic wastewater sample. Results confirmed that the total amount of metal adsorption declined with increasing influent flow rate and also rose when each metal concentration also increased. The maximum biosorption capacities of 38.25, 63.37, 108.12 and 35.23mg/g for Cd, Cu, Pb and Zn, respectively, were achieved at 31cm bed height, 10mL/min flow rate and 20mg/L initial concentration. The Thomas model better described the whole dynamic behaviour of the column rather than the Dose Response and Yoon-Nelson models. Finally, desorption studies indicated that metal-loaded biosorbent could be used after three consecutive sorption, desorption and regeneration cycles by applying a semi-simulated real wastewater.
A breakthrough biosorbent namely multi-metal binding biosorbent (MMBB) made from a combination of tea wastes, maple leaves and mandarin peels, was prepared to evaluate their biosorptive potential for removal of Cd(II), Cu(II), Pb(II) and Zn(II) from multi-metal aqueous solutions. FTIR and SEM were conducted, before and after biosorption, to explore the intensity and position of the available functional groups and changes in adsorbent surface morphology. Carboxylic, hydroxyl and amine groups were found to be the principal functional groups for the sorption of metals. MMBB exhibited best performance at pH 5.5 with maximum sorption capacities of 31.73, 41.06, 76.25 and 26.63 mg/g for Cd(II), Cu(II), Pb(II) and Zn(II), respectively. Pseudo-first and pseudo-second-order models represented the kinetic experimental data in different initial metal concentrations very well. Among two-parameter adsorption isotherm models, the Langmuir equation gave a better fit of the equilibrium data. For Cu(II) and Zn(II), the Khan isotherm describes better biosorption conditions while for Cd(II) and Pb(II), the Sips model was found to provide the best correlation of the biosorption equilibrium data. The calculated thermodynamic parameters indicated feasible, spontaneous and exothermic biosorption process. Overall, this novel MMBB can effectively be utilized as an adsorbent to remove heavy metal ions from aqueous solutions.
A novel multi-metal binding biosorbent (MMBB) was developed by combining a group of three from the selective natural lignocellulosic agro-industrial wastes for effectively eliminating lead, cadmium, copper and zinc from aqueous solutions. Four MMBBs with different combinations (MMBB1: tea waste, corncob, sugarcane bagasse; MMBB2: tea waste, corncob and sawdust; MMBB3: tea waste, corncob and apple peel; MMBB4: tea waste, corncob and grape stalk) were evaluated. FTIR analysis for characterizing the MMBB2 explored that the MMBB2 contains more functional groups available for multi-metals binding. Comparing among the MMBBs as well as the single group biosorbents, MMBB2 was the best biosorbent with the maximum biosorption capacities of 41.48, 39.48, 94.00 and 27.23 mg/g for Cd(II), Cu(II), Pb(II) and Zn(II), respectively. After 5 times of desorption with CaCl2, CH3COOH and NaCl as eluent, the MMBB2 still remained excellent biosorptive capacity, so as it could be well regenerated for reuse and possible recovery of metals.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.