Porous titania networks containing gold nanoparticles have been synthesized and tested in photocatalytic applications. The porous structure was controlled using a templating technique, while a range of gold concentrations and a variety of routes were investigated to incorporate the gold nanoparticles. The influence of these parameters on the final structure (surface area and pore size), the gold crystal size, distribution, and content, and the photocatalytic activity of the porous materials were investigated. UV−vis diffuse reflectance spectra of the Au/TiO2 materials showed strong absorbance at approximately 580 nm, indicating the successful incorporation of the gold species. X-ray diffraction analysis ascertained that the titania materials were crystalline (anatase phase) with gold peaks observed only when the gold content was greater than 0.25 wt %. Gold distribution and content in the materials were measured using secondary ion mass spectrometry and inductively coupled plasma mass spectrometry. From transmission electron microscopy analysis, the gold particle size and distribution varied with both the material preparation method and the concentration of gold used in the synthesis. Photocatalytic activity was dependent on the gold particle size and gold quantity. The highest photocatalytic activity under UV light irradiation as monitored by the photodecomposition of methylene blue was obtained for the Au/TiO2 sample containing 2.0 wt % gold prepared by the deposition of gold onto prefabricated porous TiO2.
This work reports the effect of indium segregation on the surface versus bulk composition of indium (In)-doped TiO(2). The studies are performed using proton-induced X-ray emission (PIXE), secondary-ion mass spectrometry (SIMS), X-ray photoelectron spectroscopy (XPS), and Rutherford backscattering spectroscopy (RBS). The results of XPS analysis indicate that annealing of In-doped TiO(2) containing 0.3 atom % In at 1273 K in the gas phase of controlled oxygen activity [p(O(2)) = 75 kPa and 10 Pa] results in a surface enrichment of 2.95 and 2.61 atom % In, respectively. The obtained segregation data are considered in terms of the transport of indium ions from its titanium sites in the bulk phase to the surface where these ions are incorporated into interstitial sites. The effect of oxygen activity on the segregation-induced surface enrichment is considered in terms of the formation of a low-dimensional surface structure and a sublayer, which are charged negatively. The latter is formed as a result of strong interactions between titanium vacancies and interstitial indium ions, leading to the formation of defect complexes. The data obtained in this work may be used for engineering of TiO(2)-based semiconductors with enhanced performance in solar energy conversion.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.