The energy response of films in the energy range <100 keV can be improved by adjusting the active layer chemical composition. Removing bromine eliminated the over response at about 40 keV. The under response at energies ≤ 30 keV is improved by adding 7% Al to the active layer in the latest commercial EBT3 film models.

The GPUMCD algorithm showed good agreement against GEANT4 both in the presence and absence of a 1.5 T external magnetic field. The application of 1.5 T magnetic field significantly alters the dose at the interfaces by either increasing or decreasing the dose depending upon the density of the material on either side of the interfaces.

A radiochromic film based dosimetry system using only the green color channel of a flatbed document scanner showed superior precision if used alone in a dose range that extends up to 50 Gy, which greatly decreases the complexity of work. In addition, Solid Water™ material was shown to be a viable alternative to water in performing radiochromic film based dosimetry with HDR (192)Ir brachytherapy sources.

Purpose: In this work, the design, operation, initial experimental evaluation, and characterization of a small-scale graphite calorimeter probe -herein referred to as the Aerrow -developed for routine use in the clinical environment, are described. Similar in size and shape to a Farmer type cylindrical ionization chamber, the Aerrow represents the first translation of calorimetry intended for direct use by clinical physicists in the radiotherapy clinic. Methods: Based on a numerically optimized design obtained in previous work, a functioning Aerrow prototype capable of two independent modes of operation (quasi-adiabatic and isothermal) was constructed in-house. Reference dose measurements were performed using both Aerrow operation modes in a 6 MV photon beam and were directly compared to results obtained with a calibrated reference-class ionization chamber. The Aerrow was then used to quantify the absolute output of five clinical linac-based photon beams (6 MV, 6 MV FFF, 10 MV, 10 MV FFF, and 15 MV; 63.2% < %dd(10)9 < 76.3%). Linearity, dose rate, and orientation dependences were also investigated. Results: Compared to an ion chamber-derived dose to water of 76.3 AE 0.7 cGy, the average doses measured using the Aerrow were 75.6 AE 0.7 and 74.7 AE 0.7 cGy/MU for the quasi-adiabatic and isothermal modes, respectively. All photon beam output measurements using the Aerrow in waterequivalent phantom agreed with chamber-based clinical reference dosimetry data within combined standard uncertainties. The linearity of the Aerrow's response was characterized by an adjusted R 2 value of 0.9998 in the dose range of 80 cGy to 470 cGy. For the dose-rate dependence, no statistically significant effects were observed in the range of 0.5 Gy/min to 5.4 Gy/min. A relative photon beam quality dependence of 1.7% was calculated in the range of 60 Co to 24 MV (58.4% < %dd(10)9 < 86.8%) using Monte Carlo. Finally, the angular dependence (gantry stationary and detector rotated) of the Aerrow's response was found to be insignificant to within AE0.5%. Conclusions: This work demonstrates the feasibility of using an ion chamber-sized calorimeter as a practical means of measuring absolute dose to water in the radiotherapy clinic. The potential introduction of calorimetry as a mainstream device into the clinical setting is powerful, as this fundamental technique has formed the basis of absorbed dose standards in many countries for decades and could one day form the basis of a new local absorbed dose standard for clinics.