The deformation of metallic acetabular cups employed for metal-on-metal hip resurfacing procedures was considered theoretically using the finite element method in the present study, following on the experimental investigation reported in Part 1. Three representative cups, characterized by the cup wall thickness as thin, intermediate, and thick, were considered. For the intermediate cup, the effects of both the size and the diametral interference on the cup deformation were investigated. Both two-dimensional axisymmetric and three-dimensional finite element models were developed to examine the important parameters during and after the press-fit procedure, and in particular the deformation of the metallic cup. The theoretical prediction of the cup deformation was in reasonable agreement with the corresponding experimental measurement reported in Part 1. The most significant factor influencing the cup deformation was the cup wall thickness. Both the size and the diametral interference were also shown to influence the cup deformation. It is important to ensure that the cup deformation does not significantly affect the clearance designed and optimized for tribological performances of metal-on-metal hip resurfacing prostheses. Furthermore the contact parameters at the cup and bone interface associated with the press fit were also discussed.

A flexible trileaflet polyurethane valve has been made by dip-moulding leaflets directly onto an injection-moulded frame. The durability of this value is, in part, determined by the thickness of its leaflets. Leaflet thickness is also a major determinant of hydrodynamic function. This study examines valves (n = 31) with leaflets made of a polyetherurethane (PEU, n = 22) or a polyetherurethaneurea (PEUE, n = 9), of varying thickness distributions. The valves were subjected to accelerated fatigue test at 37 degrees C and failure monitored. Leaflet thicknesses ranged from 60 to 200 microns. PEU leaflet thickness bore no relationship to durability, which was less than 400 million cycles. PEUE valves, in contrast, exceeded 800 million cycles. Durability in PEUE valves was directly related to leaflet thickness (r = 0.93, p < 0.001), with good durability achieved with median leaflet thicknesses of approximately 150 microns. Thus polyurethane valves can be made with good hydrodynamic properties and with sufficient durability to consider potential clinical use.

When rabbit corneas are fixed in an osmic acid fixativeto which potassium pyroantimonate has been added, an electron-opaque precipitate of sodiium pyroantimonate is localized along the cellular side of the lateral plasmla membrane of the endothelial cells. This heavy precipitate represents areas of high Na(+) concentration and may represent the site of a saturated, high-affinity Na(+) carrier. Significantly heavier precipitate occurs at the same site when ouabain is injected into the aqueous humor prior to fixation of the cornea.

No abstract

The detection of foot-and-mouth disease virus (FMDV)-persistent carriers among convalescent ruminants is of paramount importance in the aftermath of a field outbreak. To this purpose, FMDV-specific antibody should be investigated first, since virus isolation procedures from such carriers are seriously constrained. The complexity of the overall picture may be compounded by possible emergency vaccinations in the affected areas at the beginning of the outbreak. In this case, it is suggested that mucosal rather than serum antibody be investigated. In fact, we showed that FMDV-infected cattle regularly mount an antibody response in oropharyngeal fluids, in contrast to vaccinated cattle. Antibody could be revealed by neutralization assays and/or an immunoglobulin A (IgA)-specific kinetic enzyme-linked immunosorbent assay (ELISA). Cattle vaccinated once seldom showed a mucosal antibody response, which could be only detected by a total immunoglobulin-specific kinetic ELISA. Very few, if any, cattle showed a mucosal IgA response after repeated vaccinations. Our kinetic, IgA-specific ELISA generally allowed an early detection of FMDV-infected cattle; in particular, it proved to be more sensitive than the usual indirect, antigen-trapping ELISA in experiments on saliva samples.