Sixteen feet with retrocalcaneal bursitis (RB) and twenty-two feet with calcific Achilles insertional tendinosis (IAT-CS) underwent retrocalcaneal decompression after failure of nonoperative treatment. Follow-up evaluation at least two years after surgery included AOFAS Ankle-Hindfoot subscale scores, satisfaction, time until maximum symptomatic improvement, and radiographs. Statistically significant differences between the groups include the following: IAT-CS patients were older, required nearly twice the time to reach maximum symptomatic improvement, had lower satisfaction rates, had a lower pain score, and more frequently had shoewear restrictions. Radiographic recurrence did not correlate with outcome or symptomatic recurrence.

We studied 33 third generation, alumina ceramic-on-ceramic bearings retrieved from cementless total hip replacements after more than six months in situ. Wear volume was measured with a Roundtest machine, and acetabular orientation from the anteroposterior pelvic radiograph. The overall median early wear rate was 0.1 mm(3)/yr for the femoral heads, and 0.04 mm(3)/yr for the acetabular liners. We then excluded hips where the components had migrated. In this stable subgroup of 22 bearings, those with an acetabular anteversion of < 15 degrees (seven femoral heads) had a median femoral head wear rate of 1.2 mm(3)/yr, compared with 0 mm(3)/yr for those with an anteversion of > or =15 degrees (15 femoral heads, p < 0.001). Even under edge loading, wear volumes with ceramic-on-ceramic bearings are small in comparison to other bearing materials. Low acetabular anteversion is associated with greater wear.

We used decision-analysis modeling to determine the most cost-effective fixation device among Herbert screws, AO screws, and the Luhr plate for first metatarsophalangeal joint arthrodesis. The model considered patient-reported outcomes at minimum 2-year follow-up, patient charges for the entire course of care, and event and outcome incidences within each fixation group. AO screws had the lowest average cost of utility and, therefore, are the most cost-effective fixation device for first metatarsophalangeal joint arthrodesis even though utility is highest with the Luhr plate. Operating room costs and union rate most strongly influenced cost-effectiveness.

No abstract