No abstract

No abstract

A methodology for the study of the absorption and metabolism of butyltin compounds in laboratory animals using isotopically enriched species was developed. The method is based on the oral administration of 119Sn-labeled monobutyltin (MBT), 118Sn-labeled dibutyltin (DBT), and 117Sn-labeled tributyltin (TBT) to the animals and the measurement of both the concentration and isotopic composition of these compounds in the different tissues by GC-ICPMS. The degradation of butyltin compounds during their metabolism was computed using least-squares isotope pattern deconvolution, and their concentration was measured by reverse isotope dilution analysis using natural-abundance MBT, DBT, and TBT standards. Male Wistar rats were used as models to evaluate the proposed methodology. Preliminary toxicological results obtained with one rat indicate that TBT is highly absorbed (64.4%), and it is found in all organs with relatively high levels in stomach and intestines. The apparent absorption of DBT was 27.3% and was mainly found in liver, kidney, and intestines. However, a large proportion of the found DBT is formed from the degradation of TBT (approximately 40% of the found DBT in liver is degraded TBT). The apparent absorption of MBT was found to be 12.5%, and the originally administered MBT was mainly recovered in the feces. However, MBT was clearly detected in liver, kidney, stomach, intestines, and urine as degradation products of DBT and TBT. Although a significant variability from rat to rat is expected to be obtained, the analytical variability provided by this methodology is small enough to yield meaningful biological results. The results obtained demonstrate that the developed methodology is able to follow qualitatively, quantitatively, and simultaneously the specific metabolic pathways of different species of a given element.

No abstract

The European Water Framework Directive 2000/60/EC requires monitoring of organic priority pollutants in so-called whole water samples, i.e. in aqueous nonfiltered samples that contain natural colloidal and suspended particulate matter. Colloids and suspended particles in the liquid phase constitute a challenge for sample homogeneity and stability. Within the joint research project ENV08 ''Traceable measurements for monitoring critical pollutants under the European Water Framework Directive 2000/60/EC'', whole water test materials were developed by spiking defined amounts of aqueous slurries of ultrafinely milled contaminated soil or sediment and aqueous solutions of humic acid into a natural mineral water matrix. This paper presents the results of an European-wide interlaboratory comparison (ILC) using this type of test materials. Target analytes were tributyltin, polybrominated diphenyl ethers and polycyclic aromatic hydrocarbons in the ng/L concentration range. Results of the ILC indicate that the produced materials are sufficiently homogeneous and stable to serve as samples for, e.g. proficiency testing or method validation. To our knowledge, this is the first time that ready-to-use water materials with a defined amount of suspended particulate and colloidal matter have been applied as test samples in an interlaboratory exercise. These samples meet the requirements of the European Water Framework Directive. Previous proficiency testing schemes mainly employed filtered water samples fortified with a spike of the target analyte in a water-miscible organic solvent. KeywordsWater Framework Directive Á Interlaboratory comparison Á Whole water sample Á Suspended particulate matter Á Polycyclic aromatic hydrocarbons Á Polybrominated diphenyl ethers Á Tributlyltin Electronic supplementary material The online version of this article (